oticon miniRITE Series Manuale utente
miniRITE
Alta2
Nera2
Ria2
Instructions for use
Model overview
This booklet is valid for Oticon miniRITE in the following hearing aid
families and models:
Inium Sense
Alta2 Pro Nera2 Pro Ria2 Pro
Alta2 Nera2 Ria2
The following speakers are available for the above models:
Speaker 60
Speaker 85
Speaker 100
Power mold speaker 100
Power mold speaker 105
151801CA-US / 2019.06.13/ Ver 1.0
151801CA-US / 2019.06.13/ Ver 1.0
Introduction to this booklet
This booklet guides you in how to use and maintain your new
hearing instrument. Please read the booklet carefully including
the Warnings section. This will help you to achieve the full benet
of your new hearing instrument.
Your Hearing Care Professional has adjusted the hearing
instrument to meet your needs. If you have additional questions,
please contact your Hearing Care Professional.
About Start up Handling Options Warnings More info
For your convenience this booklet contains a navigation bar to help
you navigate easily through the dierent sections.
Indication for use
The hearing aid is intended to amplify and transmit sound to the ear
and thereby compensate for impaired hearing within mild to severe-
to-profound hearing loss. The hearing aid is intended for use by adults
and children older than 36 months.
IMPORTANT NOTICE
The hearing instrument amplication is uniquely adjusted and optimized
to your personal hearing capabilities during the instrument tting
performed by your Hearing Care Professional.
About
Identify your hearing instrument speaker and earpiece 8
miniRITE 10
Identify left and right instrument 12
Battery 13
Start up
Turn the hearing instrument ON and OFF 14
When to replace a battery 15
Replace the battery 16
Handling
Caring for your hearing instrument 18
MultiTool for handling batteries and cleaning 19
Put on the instrument 20
Standard earpieces: dome or Grip Tip 22
Replace dome or Grip Tip 23
ProWax miniFit filter 24
Replace ProWax miniFit filter 25
Customized earpieces: Micromold, LiteTip, or Power flex mold 26
Clean the MicroMold, LiteTip, or Power Mold 27
Replace ProWax filter 28
Options
Optional features and accessories 30
Mute the hearing instrument 31
Change programs 32
Change volume 34
Tamper-resistant battery drawer 36
Wireless accessories 38
Other options 39
Warnings
Warnings 40
More info
Troubleshooting guide 44
Water resistant 46
Conditions of use 47
Warranty certificate 48
International warranty 49
Technical information 50
Table of content
8 9
About Start up Handling Options Warnings More info
Identify your hearing instrument speaker
and earpiece
This will make it easier for you to
navigate through this booklet.
Speakers
The hearing aids uses one of
the following speakers:
Speaker
(60 shown)
Ear grip
(optional)
60 85 100
Earpieces
A RITE will have one of the
following earpieces.
Power mold speakers
Micromold or LiteTip
Dome (open dome shown)*
GripTip
100
105
* Please see details for replacing the dome or Grip Tip in section: Replace dome or Grip Tip
About
10 11
About Start up Handling Options Warnings More info
miniRITE
What it is
Push button Change
programs,
volume and
mute the
instrument
Microphone
openings
Sound in
What it does
Contains the battery.
Battery drawer is also
the on/o switch
Battery drawer
Sound out
Speaker
(60 shown)
12 13
About Start up Handling Options Warnings More info
Identify left and right instrument
It is important to distinguish between the left and the right hearing
aid, as they may be programmed dierently.
You can nd left/right color indicators in the battery drawer and on
60 and 85 speakers as shown. Indicators can also be found on 100
speakers and some earpieces.
Battery
Your hearing instrument is a miniature electronic device that runs on
special batteries. To activate the hearing instrument, you must insert
a new battery in the battery drawer. See how in the “Replace the
battery” section.
A RED indicator marks the
RIGHT instrument.
A BLUE indicator marks the
LEFT instrument.
Battery drawer
Your instrument
battery size is 312
Pull out to open
14 15
About Start up Handling Options Warnings More info
Turn the hearing instrument ON and OFF
The battery drawer is also used to switch the hearing instrument
on and o. To preserve the battery, make sure your instrument is
switched o when you are not wearing it.
When to replace a battery
When it is time to replace the battery you will hear two beeps
repeated in moderate intervals until the battery runs out.
Two beeps
= The battery is running low
Four beeps
= The battery has run out
Battery maintenance tip
To make sure the hearing instrument is always working, bring spare
batteries with you, or replace the battery before you leave home.
Turn ON
Close the
battery
drawer with
the battery
in place.
Turn OFF
Open the
battery drawer
Note: The batteries need to be replaced more often if you are streaming audio or music to your hearing aids.
Start up
16 17
About Start up Handling Options Warnings More info
Replace the battery
2. Uncover 3. Insert
Fully open the
battery drawer.
Remove the battery.
Remove the sticky
label from the + side
of the new battery.
Tip:
Wait 2 minutes so that
the battery can draw air,
to ensure optimal function.
Insert the new battery
into the battery
drawer. Make sure the
+ side faces up.
1. Remove
MultiTool
Close the battery drawer. The
instrument will play a jingle
through the earpiece.
Hold the earpiece close to your
ear to hear the jingle.
The MultiTool can be used for
battery change. Use the magnetic
end to remove and insert batteries.
The MultiTool is provided by
your Hearing Care Professional.
4. Close Tip
18 19
About Start up Handling Options Warnings More info
Caring for your hearing instrument
When handling your hearing instrument, hold it over a soft surface
to avoid damage if you drop it.
Clean the microphone openings
Carefully brush away debris from
the openings. Gently brush the
surface. Make sure the brush is
clean and that it is not pressed
into the openings.
IMPORTANT NOTICE
Use a soft, dry cloth to clean the hearing instrument. It must never be
washed or immersed in water or other liquids.
Microphone
openings
MultiTool for handling batteries and cleaning
The MultiTool contains a magnet which makes it easier to replace the
battery in the hearing aid. It also contains a brush and a wire loop for
cleaning and removing ear wax. If you need a new MultiTool please
contact your hearing care professional.
Brush
Wire loopMagnet
IMPORTANT NOTICE
The MultiTool has a built-in magnet. Keep the MultiTool 30 cm away from
credit cards and other magnetically sensitive devices.
Handling
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali oticon Apparecchio acustico
oticon
oticon Alta Manuale utente
oticon
oticon miniBTE Manuale utente
oticon
oticon Streamer 1.4 Manuale utente
oticon
oticon Alta2 Pro Ti Manuale utente
oticon
oticon More Manuale utente
oticon
oticon Alta2 Pro Ti Manuale utente
oticon
oticon minirite Manuale utente
oticon
oticon BTE SP Manuale utente
oticon
oticon miniBTE R Manuale utente
oticon
oticon CROS PX miniRITE R Manuale utente
oticon
oticon Geno 1 Manuale utente
oticon
oticon miniRITE Alta2 Manuale utente
oticon
oticon OPN Manuale utente
oticon
oticon Real miniBTE R Manuale utente
oticon
oticon CIC P Manuale utente
oticon
oticon More miniRITE R Series Manuale utente
oticon
oticon Intiga i Manuale utente
oticon
oticon Epoq BTE Manuale utente
oticon
oticon BTE 13 with Corda Manuale utente
oticon
oticon Alta2 Pro Ti Manuale utente
