Outback Senator 6 Manuale utente
Photographs are not to scale.
Specifications subject to change
without prior notice.
Assembly and Operating Instructions for Outback®
Senator 6 Burner Gas BBQ
WARNING
For outdoor use only. Not for commercial use.
Read instructions before using the appliance. Failure to follow instructions could
result in death, serious bodily injury, and/or property loss.
Warning: accessible parts may be very hot. Keep young children and pets away.
Do not move the appliance during use.
Turn off the gas supply at the gas bottle after use.
Any modification of the appliance, misuse, or failure to follow the instructions may be
dangerous and will invalidate your warranty. This does not affect your statutory rights.
Retain these instructions for future reference.
Leak test annually, and whenever the gas bottle is removed or replaced. Check that the
hose connections are tight and leak test each time you reconnect the gas bottle.
For Flare-up control please refer to the ‘OPERATION’ section of this manual.
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open barbecue lid or hood.
4. If odour continues, discontinue use and
contact your local dealer.
FOR YOUR SAFETY
1. Do not store or use petrol or other flammable
vapours or liquids in the vicinity of this or any
other appliance.
2. A gas bottle not connected for use shall not be
stored in the vicinity of this or any other
appliance.
0359
MS5661AW
2
Parts List
Quantities vary according to model purchased. Specifications subject to change without prior notice. For
more details on hardware, please see ‘Hardware Reference Diagram’.
CODE PART QTY Senator 6 Burner Gas BBQ
HOOD
A1 Hood (Pre-Assembled to Body) 1
A2 Hood Handle 1
A3 Heat Indicator 1
A4 Warming Rack 1
BODY
B1 Barbecue Body 1
B2 Burner 6
B3 Cross Channel 5
B4 Control Panel 1
B5 Knob 6
B6 Flame Tamer 6
B7 Cooking Grill 2
B8 Round Cooking Grill 1
B9 Drip Tray Handle 1
B10 Drip Tray 1
B11 Drip Tray Left Bracket 1
B12 Drip Tray Right Bracket 1
B13 Side burner valve, Hose and Regulator Assembly 1
B14 Main Burner Electrode Wire 1
TROLLEY
C1 Side Burner Shelf 1
C2 Side Burner Shelf Front Panel 1
C3 Side Burner Grid 1
C4 Side Burner Knob 1
C5 Knob Bezel 1
C6 Side Burner 1
C7 Side Burner Electrode Wire 1
C8 Ignition Button 1
C9 Side Shelf 1
C10 Side Shelf Front Panel 1
C11 Tool Hook 1
C12 Left Cabinet Panel 1
C13 Right Cabinet Panel 1
C14 Upper Support 1
C15 Left Door 1
C16 Right Door 1
C17 Door Handle 2
C18 Rear Panel 1
C19 Bottom Panel 1
C20 Magnet 2
C21 Axle 1
C22 Wheel 2
C23 Hubcap 2
C24 Locknut 2
HARDWARE
D1 ST4.0x10 Screw 21
D2 M4x10 Bolt 3
D3 M4x15 Bolt 4
D4 Washer 4
D5 M4 Nut 4
D6 M6x15 Bolt 22
D7 M6x65 Bolt 4
D8 M6 Nut 10
Pre-Assembled Component
3
Parts Diagrams
Quantities vary according to model purchased. Specifications subject to change without prior notice. For
more details on hardware, please see hardware pack page.
A4 A2
A1
A3
B14
B1
B4
B5
B2
B3
B9
B7
B6
B11 B12
C3
C1
C9
C2
C7 C6
C4
C5
C8 C10
C12 C13
C14
C15 C16
C17
C18
C19
C21
C22 C23
C20
C11
B8
B10
C24
B13
4
Hardware Reference Diagram
Specifications subject to change without prior notice.
D7
D1
D2
D3,D4,D5
D6
D8
5
Attach the Left Cabinet Panel (C12) and Right Cabinet Panel (C13) to the Bottom Panel (C19)
using the M6x65 Bolts (D7x4pcs) and M6 Nuts (D8x4pcs).
2
Assembly
IMPORTANT!
TOOLS NEEDED FOR ASSEMBLY: Medium size flat blade or Phillips/Crosspoint screwdriver,
adjustable spanner or metric spanner set.
Remove any internal components or packaging from the barbecue body.
Whilst every care is taken in the manufacture of this product, care must be taken during assembly in
case sharp edges are present.
Please read the Important Information section carefully before assembly and use of your
barbecue.
Complete fixing the left cabinet panel and right cabinet panel onto bottom panel using the
ST4.0x10 Screw (D1x6pcs) as shown.
1
C19C12
C13
D7 D8
D1
Note: Ensure that the
holes to install magnet
should be at the front
of the bottom panel as
showed in figure D.
D
D
6
4
3
Unscrew the Locknuts (C24) from both ends of the Axle (C21).
Insert the axle through the corresponding holes in the left legs, then slide a Wheel (C22) over
each end of the axle. Secure the wheels into place with the locknuts.
Place the Hubcaps (C23) onto the outside of the wheels.
Carefully turn the assembled cabinet right side up.
Install the Rear Panel (C18) in position using the ST4.0x10 Screw (D1x7pcs) as shown.
C23
Step① Step②
D1
C18
LEFT RIGHT
BOTTOM
C24
C22
C21
7
6
5
Attach the Upper Support (C14) between the front legs using M6x15 Bolts (D6x4pcs).
Attach the Drip Tray Left Bracket (B11) to the left legs using ST4.0x10 Screws (D1x2pcs) as
shown. Repeat above process for Drip Tray Right Bracket (B12).
A
A
D1
B
B
FRONT REAR
FRONT REAR
B11 B12
C14 D6
LEFT RIGHT
8
8
7
Fit the Left Door (C15) and Right Door (C16) to the cabinet by depressing the spring pins and
placing into the cabinet, as shown.
Attach the Magnets (C20) onto the bottom panel and upper support using M4x15 Bolts (D3x4pcs),
Washer (D4x4pcs) and M4 Nuts (D5x4pcs) as shown.
D4D3 D5
C15 C16
Step① Step②
C20
9
10
9
Carefully place the Barbecue Body (B1) onto the body supports and fix it by using M6x15 Bolts
(D6x4pcs) as shown.
WARNING: DO NOT RELEASE THE BARBECUE BODY WHILE THE BARBECUE HAS
NOT BEEN PROPERLY SEATED. THIS MAY RESULT IN INJURY OR DAMAGE TO YOUR
BARBECUE.
CAUTION! Care must be taken to ensure the hood or lid does not fall open unexpectedly or
become damaged when it is set on the ground.
Attach Side Shelf Front Panel (C10) onto the Side Shelf (C9) using M6x15 Bolts (D6x2pcs) and M6
Nuts (D8x2pcs).
Attach Side Burner Shelf Front Panel (C2) onto the Side Burner Shelf (C1) using M6x15 Bolts
(D6x2pcs) and M6 Nuts (D8x2pcs).
Body supports
D6
C10 C2
D6 D8
C9 C1
10
12
11
Attach the side shelf assembly to the barbecue body using ST4.0x10 Screws (D1x2pcs) and
M6x15 Bolts (D6x4pcs) as shown.
Attach the Tool Hook (C11) onto the side shelf using M6x15 Bolts (D6x2pcs) and M6 Nut
(D8x2pcs) as shown.
D6 D8
C11
D1 D6
step1
step2
step4
step3
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Outback Griglia
Outback
Outback RS4491A Manuale utente
Outback
Outback GD4222S-S Manuale utente
Outback
Outback Spectrum 2 Burner Manuale utente
Outback
Outback MH3230 Manuale utente
Outback
Outback Mayfair Manuale utente
Outback
Outback OUTBACK TROOPER 359 Assembly and Manuale utente
Outback
Outback Meteor Select MS4431 Manuale utente
Outback
Outback Diamond Hooded Manuale utente
Outback
Outback CS3200 Manuale utente
Outback
Outback NEW Apollo 4 Manuale utente
Outback
Outback THG3302S Manuale utente
Outback
Outback Excel Onyx 2 Manuale utente
Outback
Outback Omega 100 Manuale utente
Outback
Outback MS4464 Manuale utente
Outback
Outback Orion Manuale utente
Outback
Outback Society/Granite Manuale utente
Outback
Outback Meteor 3 Manuale utente
Outback
Outback MS4464 Manuale utente
Outback
Outback Omega 100 Manuale utente
Outback
Outback Meteor MT-H4430-3 Manuale utente
