Peak PE-452 Scheda tecnica
Product instruction manual
A2 Pouch Laminating System
Peak educator - PE-452
Peak laminators have been designed to be user
friendly, however we strongly recommend you take
a few minutes to read through this manual to ensure
correct operation.
Keep this manual safe for future reference.
How to use your laminator
Ready light
Power switch
Temperature
control
Forward/Reverse
switch
Heater/Cold
switch
Parts and Features
Diagram 1
! This laminator is designed to be used with a card carrier or Lifejacket® and must not be used without one as
this can cause potential jamming and damage.
1) Carefully remove the laminator from all of its packaging and place it on a at, level surface. Make sure you
keep the original packaging somewhere safe (in case this is needed in the future).
2) Unpack the power cable and insert it into the power outlet at the back of laminator. Plug it in to a power
socket. Press the Red POWER switch to turn the laminator on. The light will illuminate.
3) Check that the FWD/REV (Forward and Reverse) switch is set to FWD (See diagram 1).
4) Refer to the temperature chart and set the laminator to the required temperature (Use this chart as a guide only).
5) Set the HEATER switch to ON.
6) The laminator will now begin to heat. Once it has reached the set temperature, the green READY light will illuminate.
7) Place the document you are laminating inside the pouch, making sure that it is centrally positioned and that a small
border (approx 5mm) is left around the edge. If you are laminating cut-up pieces ensure you still leave a 5mm border.
8) Once the document (or small pieces) are positioned in the pouch (and are not overlapping or touching each other)
then place the document and pouch inside the card carrier or Lifejacket®. ALWAYS USE A CARD CARRIER OR
LIFEJACKET® WITH THIS LAMINATOR. Insert the prepared document into the laminator. Make sure you insert the
SEALED EDGE FIRST and do not insert at an angle. The item will automatically feed through and appear the other end.
! Pay attention as you laminate and watch for your document appearing out of the exit at the back of the laminator. If
you do not see the document appearing after several seconds, press the REVERSE switch to avoid a potential jam and
the document wrapping around the rollers (Although this very rarely happens when using a card carrier/Lifejacket®).
!When you see your document appear at the exit, do not tug or pull at it to remove it quicker.
9) To turn o the laminator after use, set the HEATER switch to OFF and allow the laminator to still run for 5 minutes
(you will hear the rollers turning). This allows the laminator to cool down and it is then safe to turn OFF.
Thank you for purchasing the Peak educator PE-452. Peak laminators are designed to give you professional,
high quality results, quickly and easily. Please take a few minutes to read through this important document
as any damage caused to your laminator by user error is not covered under warranty.
xx
Don’t overlap Leave a 5mm border Don’t laminate open
end rst
Temperature control
Laminating pouch thickness Paper Type Approx temperature (oC)
150 to 200 micron total
(75 + 75 per side up to 100 + 100
per side)
Copy paper (80gsm) 110-120
Photo paper (120gsm) 115-120
Card (200gsm) 115-125
250 to 360 micron total
(125 + 125 per side up to 180 + 180
per side)
Copy paper (80gsm) 120-125
Photo paper (120gsm) 125-130
Card (200gsm) 125-130
500 micron (maximum)
(250 + 250 per side)
Copy paper (80gsm) 130-140
Photo paper (120gsm) 135-140
Card (200gsm) 135-145
Laminating speed: 690mm/minute
Laminating width: 450mm
Maximum pouch thickness: 500 micron
Laminating temperature: 100-160oC
Warm up time: 5 minutes
Power supply: AC 100, 110, 220
240V/50Hz, 60Hz
Power consumption: 1050W
Dimensions: 650 x 215 x 113mm
Weight: 11kgs
Warranty: 2 years
Technical Specications
Temperature control is designed for laminating pouches and documents of varying thickness. Thicker objects
need more heat. The table below gives an indication of the correct temperature setting required. Please note
this is a guide only. Other factors can aect the laminator such as room temperature and the thickness of the
document being laminated.
Never laminate without
using a Lifejacket® or card
carrier or you risk jamming
and damaging your laminator
(this will not be covered under
warranty)
What is a ‘Lifejacket®’?
The Lifejacket® is a highly durable patented product made from Teon® that should be used when laminating
cut-up, odd shaped pieces (such as shapes, letters, signs as shown above) to prevent damage to your laminator
and potential jamming.
Why use a Lifejacket®?
. Protect your laminator from jamming
. Extend the life of your laminator by using the Lifejacket® - stops adhesive seeping onto rollers
. Eliminate repair bills as this product keeps your laminator working at an optimum level
. Available in A4, A3 and A2 sizes to protect documents of all sizes
Ask your supplier for more details.
Safety!
.
Always remember to switch your pouch laminator o after use. Leaving it on for long periods can cause damage
to the laminator and is a health and safety hazard
.
Always put the sealed end of the card carrier or Lifejacket® into the laminator rst
.
NEVER laminate metal objects such as keys or coins
.
NEVER use the laminator near water and do not leave the laminator next to a hot area such as a radiator
.
Always wrap the power cord around safely after use and do not leave it dangling where it could cause an accident
.
Do not allow children to use the laminator, unless supervised
.
If your laminator stops working, do not try to x it yourself by disassembling the machine. Contact your supplier for advice
.
Do not operate the laminator if the power cable is damaged in any way
.
Do not use this appliance for anything other than it’s intended purpose
.
Always use a card carrier or Lifejacket® with this laminator
Warranty & Incorrect Use
IMPORTANT INFORMATION
Your laminator should reach you in perfect condition, however please retain all original packaging once you have
unpacked your laminator in case you need to return it. If your laminator arrives damaged or faulty in anyway, this must
be reported to your supplier immediately. If you send your laminator back for repair under warranty at any time, then
the warranty may be void if the laminator is not packaged correctly and as a result is damaged in transit.
Unauthorised repair or attempts to service the unit will invalidate the warranty.
Your Peak Pouch Laminator includes a 2 years warranty on defective parts under normal operating conditions. THIS
DOES NOT COVER any jams, misfeeds or wrap arounds caused by operator error and you will be liable for the repair costs
(including delivery charges). The warranty does not cover the heated rollers. The warranty is for a period of two years
from the date of purchase by the original consumer.
Please note that attempting to laminate any type of unsuitable documents (for example multiple cutouts, textiles, food
matter, documents exceeding the maximum thickness or documents too large or small for the pouch) may result in
jamming. Damage caused by incorrect use or failing to follow the instructions are not covered within the warranty.
FAQ’S
My document has come out cloudy - what does this mean?
This means that the temperature setting is not quite hot enough. Try increasing the temperature by 5oC and try again as applying
more heat should x the problem.
My document has come out wavy - what does this mean?
If the document comes out with a wavy nish the temperature is set too high. Decrease the temperature by 5oC and try again. If you
have an important document to laminate such as a photograph, it is always good to try a test document rst to ensure you have the
laminator at the perfect temperature.
Indice
Altri manuali Peak Plastificatrice
Peak
Peak PE332 Scheda tecnica
Peak
Peak Peak lite - PL320 Manuale utente
Peak
Peak Peak Performance PS320 Scheda tecnica
Peak
Peak Instant PI-320 Scheda tecnica
Peak
Peak PE332 Manuale utente
Peak
Peak PP-330 Manuale utente
Peak
Peak PL-220 Scheda tecnica
Peak
Peak Pro PP260 Scheda tecnica
Peak
Peak PN230 Scheda tecnica
Peak
Peak PE332 Manuale utente
