Permobil 1825342 Manuale utente
Page: 1/3
Technical manual, 8 Channel IR Receiver
Document Number: 205317-UK-0 Edition 1 2009-12
8 Channel RF Receiver
Spare part no: 1825342
General
This radio frequency (RF) receiver can be wired into powered devices (such as a door
opener) so it can be operated by sending an RF signal from an environmental control
device.
•This RF receiver is an eight-channel receiver with eight voltage-free relay switches.
•Each Ouput has a unique channel number (256 possible channels) and can be
easily programmed.
•The receiver relays can independently be set for bistable (latching - continuous) as
well as monostable (non-latching - temporary) function.
oMonostable - Temporary: the output remains closed as long as the receiver
receives a command (can be compared with a push button).
oBistable - Continuous: the situation of the output (open/closed) changes each
time a command is received (can be compared with a switch).
•The receiver module is equipped with 8 direct control buttons. This allows switching
a channel without the need of a RF transmitter. This is very helpful during
installation, testing or access by a third.
Page: 2/3
Technical manual, 8 Channel IR Receiver
Document Number: 205317-UK-0 Edition 1 2009-12
Installation of the Receiver
This RF receiver needs to be installed in a dry place by a skilled technician who is familiar
with installing home automation devices.
All electrical connections are done using connectors. This minimizes the installation time
and provides a fast switch of the module in case a replacement is necessary.
•Mount the receiver with the connectors down using the Mounting Holes.
•The receiver has eight voltage-free relay switches which are connected with a
removable terminal block. Max resistive load 1A at 24 V DC/AC or inductive load
0.5 A at 24V DC. When connecting inductive load for instance motors and relays,
an interference suppression device should be used.
•Connect the supplied power supply (9VDC). The receiver accepts 9..24V (voltages
above 15V are not recommended because of excessive power consumption).
•Internal 433.92MHz FM Receiver.
REMARK: For switching higher tensions or higher power, do always use an
auxiliary relay (e.g. for switching mains voltage).
Page: 3/3
Technical manual, 8 Channel IR Receiver
Document Number: 205317-UK-0 Edition 1 2009-12
Configuration of the Receiver
The receiver can be configured in a way that each channel responds to a unique RF code.
At the same time each channel can be set as monostable (non-latched) or bistable
(latched) output.
How do we enter configuration mode?
•Remove power from the module.
•Press the S button while powering up the module.
•The red LED will light up.
How to define a channel?
1. Press the button (I1 .. I8) of the channel that needs to be set. If you want to define
the latching mode, you also have to push S.
2. Now send the desired code with an RF transmitter. The green LED of the receiver
will light up.
3. Stop sending the RF code and release the button(s) of the receiver. The channel is
now programmed.
4. Repeat step 1 to 3 for the remaining channels.
5. Remove power from the module.
Does it work?
•Power up the module (do not press button S!). You now entered normal operation
mode.
•Press button I1 to I8 to close the switch of the associated channel. This is useful for
testing. The green LED will always light up when a switch is closed.
•Send a RF code. If configured correctly, the corresponding switch will close.
Troubleshooting?
•If the red LED flashes, the module is defective and needs to be returned for repair.
Indice
Altri manuali Permobil Ricevitore
