PheeNet MJCAS-310PTD Manuale utente
MJPEG IP Camera
User Manual Version 2.1.7
MJCAS-310PTD
MJPEG IP Camera User’s Guide
2/94
© 2004~2005.
Owner's Record
The model and serial numbers are located at the bottom. Record these numbers in the spaces provided
below. Refer to these numbers whenever you call upon your dealer regarding this product.
Model No. ______________ Serial No. ____________________
To prevent fire or shock hazard, do not expose the unit to rain or
moisture.
For AC Adaptor to avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
For customers in the U.S.A.
This equipment has been tested and found to comply with the limits for a digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void
your authority to operate this equipment.
The shielded interface cable recommended in this manual must be used with this equipment in
order to comply with the limits for a digital device pursuant to Part 15 of FCC Rules.
Declaration of Conformity
MJPEG IP Camera User’s Guide
3/94
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTICE TO USERS
© 2004~2005. All rights reserved. This manual or the software described herein, in whole or in part,
may not be reproduced, translated or reduced to any machine readable form without prior written
approval.
WE PROVIDES NO WARRANTY WITH REGARD TO THIS MANUAL, THE SOFTWARE OR
OTHER INFORMATION CONTAINED HEREIN AND HEREBY EXPRESSLY DISCLAIMS
ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY
PARTICULAR PURPOSE WITH REGARD TO THIS MANUAL, THE SOFTWARE OR SUCH
OTHER INFORMATION. IN NO EVENT SHALL WE BE LIABLE FOR ANY INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES, WHETHER BASED ON TORT, CONTRACT, OR
OTHERWISE, ARISING OUT OF OR IN CONNECTION WITH THIS MANUAL, THE
SOFTWARE OR OTHER INFORMATION CONTAINED HEREIN OR THE USE THEREOF.
We reserves the right to make any modification to this manual or the information contained herein at
any time without notice. The software described herein may also be governed by the terms of a
separate user license agreement.
MJPEG IP Camera User’s Guide
4/94
Table of Contents
Overview ............................................................................................................................. 6
Package Contents................................................................................................................ 8
Connections....................................................................................................................... 11
Hardware Installation ....................................................................................................... 13
Logging in to Homepage................................................................................................... 15
Before Operation....................................................................................................... 15
Access the MJPEG IP Camera from the Internet Explorer for the first time............ 19
Logging in as an ordinary User................................................................................. 21
Logging in as an Administrator................................................................................. 21
Operating the MJPEG IP Camera.................................................................................... 22
Control Panel ............................................................................................................ 23
Advanced Function Area........................................................................................... 25
Basic Setting ..................................................................................................... 25
System .......................................................................................... 26
Camera.......................................................................................... 28
Network ........................................................................................ 31
User............................................................................................... 37
IP Filter ......................................................................................... 38
FTP Client..................................................................................... 41
SMTP............................................................................................ 43
Image Memory ............................................................................. 45
Alarm 1......................................................................................... 47
Alarm 2......................................................................................... 48
MJPEG IP Camera User’s Guide
5/94
Schedule ....................................................................................... 49
Motion Detection.......................................................................... 50
Time Setting ................................................................................. 51
Popup............................................................................................ 53
Firmware upgrade:........................................................................ 54
Factory Default............................................................................. 57
Reboot........................................................................................... 58
Trigger............................................................................................................... 59
Capture.............................................................................................................. 60
RightMouseButton of ActiveX Control.............................................................................. 61
View Menu................................................................................................................ 62
“Image Recording…-> Save as JPEG” .................................................................... 68
“Save Current Picture As …” ................................................................................... 74
Appendix A: Restore Factory Default Settings ................................................................. 76
Appendix B: Alarm I/O Connector ................................................................................... 77
Appendix C: Troubleshooting & Frequently Asked Questions ......................................... 79
Appendix C: Troubleshooting & Frequently Asked Questions ......................................... 79
Appendix D: PING IP Address ......................................................................................... 84
Appendix E: Bandwidth Estimation.................................................................................. 85
Appendix F: Specifications ............................................................................................... 86
Appendix G: Time Zone Table........................................................................................... 88
Appendix H: DDNS Application ....................................................................................... 90
MJPEG IP Camera User’s Guide
6/94
Overview
This user’s guide explains how to operate the MJPEG IP Camera from a computer.
Basically, the user’s guide is written to be read on the computer display. However, users
might consider printing it out to access easily and read it before you operate the MJPEG
IP Camera.
Introduction
This MJPEG IP Camera is an inexpensive fully scalable surveillance technology.
Because the MJPEG IP Cameras can be plugged in to your existing computer network
infrastructure, you will potentially save thousands of dollars on unnecessary cabling.
The MJPEG IP Camera is accessible via the LAN or Internet connection. Connect your
MJPEG IP Camera directly to a computer network or DSL modem, and with a standard
Web browser you get instant, on demand video streams. Within minutes you can set up
the MJPEG IP Camera to capture a video sequence to a PC. Live video image can be
uploaded to a website for the world to see or made available only to select users on the
network.
Features:
zHigh quality 1/3” CCD sensor
zComposite video output
zMotorized and wide-range pan and tilt operation
z16 Preset Points
zJPEG video compression
zBuilt-in internal microphone
zRemote-Control via Internet Explorer
zSupport statistic and dynamic IP address
zDDNS and PPPoE
zCF memory card interface (for CF card enabled version only)
zMulti-channel control software for surveillance application
zOn-line firmware upgrade
MJPEG IP Camera User’s Guide
7/94
Application:
zRemote monitoring
zSurveillance
Minimum System Requirement
zMicrosoft Internet Explorer 5.0 or later
zVGA Monitor resolution 1024 x 768
zPentium 4 1.3GHz or above
zMemory Size: 256MB or above
zWindows ME, 2000, XP, or 2003
MJPEG IP Camera User’s Guide
8/94
Package Contents
User can find the following items in the package:
1. PT MJPEG IP Camera x 1
2. Power adapter x 1
3. Power cord x 1
4. Decoration ring x 1
5. Screw x 4
6. Terminator for Alarm I/O x 1
7. Installation software and manual CD x 1
8. Quick Start Guide x 1
Item Descriptions
1. This unit is the main element of
the system.
2. Switching Power Adapter
dedicates 12V DC electric power
output to MJPEG IP Camera.
MJPEG IP Camera User’s Guide
9/94
3. Power Cord provides connection
between AC Power Adapter and
Power Outlet for electricity.
4. Decorate the mounting parts.
Provide four screw holes to fix
MJPEG IP Camera.
5. Screws are used to fix MJPEG
IP Camera.
6. Alarm I/O connector is used to
provide an easy fixing interface for
the wire connection from alarm
devices and sensor devices to
MJPEG IP Camera.
7. User’s Manual provides
important information and
instructions for operating the
MJPEG IP Camera.
MJPEG IP Camera User’s Guide
10/94
8. Quick Start Guide provides
important information and
instructions for installing this device.
If any of the above items are missing, please contact your dealer immediately.
Note: Using a power supply with a different voltage than the one included with the
MJPEG IP Camera will cause damage and void the warranty for this product.
Altri manuali per MJCAS-310PTD
1
Indice
Altri manuali PheeNet Telecamera IP
