Philips ColourChaser Touch Manuale utente

ColourChaser Touch

Installation Guide

Philips ColourChaser Touch Manual2

Dimensions

100

110 29

C S

I 2 3 4

ColourChaser Touch - Dimensions in mm

Ø 4.5

Bracket - Dimensions in mm

Philips ColourChaser Touch Manual 3

Content Dimensions

Safety Information

Introduction

Installation

Connections

Controller to power supply

Power supply to xtures

AC power supply cable plug

Setup

Introduction

Software installation

Fixture setup

Troubleshooting

Specications

Technical data

Ordering information

Quick Guide

Philips ColourChaser Touch Manual4

Warning! This product is not for household use.

Read this manual before installing and operating the controller, follow the safety

precautions listed below, and observe all warnings in this manual.

Preventing electric shocks

• Alwaysground(earth)thepowersupply.

• UseonlyasourceofACpowerthatcomplieswithlocalbuildingand

electrical codes, and that has both overload and ground-fault protection.

• Ifthecontrollerorpowersupplyareinanywaydamaged,defective,wet,

or show signs of overheating, disconnect the power supply from AC power

and contact your supplier

• Donotinstallorusethedeviceoutdoors.Donotspraywithorimmerse

in water or any other liquid.

• Donotremoveanycoversorattempttorepairthecontrollerorpower

supply. Refer any service to Philips.

Disposingofthisproduct

PhilipsproductsaresuppliedincompliancewithDirective2002/96/ECof

theEuropeanParliamentandoftheCounciloftheEuropeanUnionon

WEEE(WasteElectricalandElectronicEquipment),asamendedbyDirective

2003/108/EC,whereapplicable.

Safety Information

Philips ColourChaser Touch Manual 5

Introduction

About the ColourChaser Touch

TheColourChaserTouchisalightingcontrollerforDMXcontrollablecolorchangingxtures

(luminaires).Programmedwitheachxturesuniquecolorcurve,itprovidesthesimplest,yet

most powerful interface ever developed to control and match colors from multiple sources

(RGB,RGBW,CMYandCMYK).

Package contents

The ColourChaser Touch package contains the following items.

• ColourChaserTouchController

• 48VPoweroverEthernet(POE)powersupply

• CD-ROMwithdocumentationandColourChaserDesignersoftware

• 5mUTPpatchcable

• 1.5mUSBcable

About this document

This guide describes how to install and set up the ColourChaser Touch controller.

For a description of how to operate the controller, please refer to the ColourChaser Touch

QuickGuide(Instructionforuse).

ForhelpwithColourChaserDesigner,refertotheprogram’sonlinehelp.

For installation and setup of xtures, please refer to their user manuals.

Philips ColourChaser Touch Manual6

Controller and bracket

The ColourChaser Touch is designed for wall mounting using the included bracket.To mount:

Loosen the set screw on the bottom of the

ColourChaser Touch with a 2 mm hex wrench

and remove the wall bracket.

Center the bracket on the desired mounting

position with the hooks pointing up.

Fasten the bracket to the wall with four

suitablescrews(notincluded).

Installation

2mm hex

∅5 mm

No. 6 (

∅ 3,5 mm)

Philips ColourChaser Touch Manual 7

Installation

Plugtheincluded5mUTPpatchcableintothe

RJ-45socketonthebackofthecontroller(or

useanotherUTPpatchcablewithamaximum

lengthof40meter).

Place the controller on the bracket and slide it

down over the hooks.

Tighten the set screw a few turns to hold the

controllerinplace.Donotovertighten:stopas

soon as you feel light resistance!

Power supply

Install the power supply in a dry location within a 40 meter cable run of the controller.

RJ-45

Philips ColourChaser Touch Manual8

Controller to power supply

ConnectaUTPpatchcable(max.40meter)betweentheRJ-45socketonthebackofthe

controllerandtheOUTsocketonthepowersupplybeforeconnectingthepowersupplytoAC.

Whenpowerisappliedtothepowersupplyunit,all3LEDswilllightfor2secondsandthenthe

“ON”LEDwillilluminategreen.The“CONNECT”LEDilluminatesgreenwhenthecontrolleris

connected and receiving power.

Connections

INOUT

USB

DMX

Luminaire

Power

Supply

Unit

DMX

Luminaire

DMX

Luminaire

After 30

Luminaires

a DMX

booster

is required

DMX DMX

DMX100 - 240 V DMX

C S

I 2 3 4

Philips ColourChaser Touch Manual 9

Power supply to xtures

ConnectanotherUTPpatchcable(notincluded)betweenthepowersupply’sINsocketandthe

DMXinputononeofthextures.IfthexturedoesnothaveaRJ-45socket,youwillneeda

3-pinor5-pinXLR-to-RJ-45adaptorthatconnectsthepinsasshownbelow.

RJ-45 pin Function

7, 8 signal common

2 data -

1 data +

Connect the xtures together in a serial chain, output to input. Connect no more than 30

xturesandkeepthetotalcablerunto300m(1000ft.)orless.Iftheapplicationexceedsthese

limits,DMXsplitter/ampliersmaybeusedafterthepowersupplytoincreasethecablerunand/

or number of xtures.

Line terminator

Terminate the end of the data line to prevent reections that can distort the signal.This is usually

accomplishedbyinsertingasuitable120ohmterminationplugintotheDMXoutputofthelast

xture in the line.

Philips ColourChaser Touch Manual10

AC power supply cable plug

Warning: Risk of electric shock!

Plug installation shall be performed by a qualied electrician.

Agrounding-type(earthed)powerplugthattsthelocalpoweroutletmustbeinstalledonthe

ACcableforthepowersupply.Alternatively,youcanacquireanIECpowercablewithasuitable

grounding-type plug from most consumer electronics stores.

When installing the plug connect pins as follows:

• yellowandgreenwiretoground(earth)

• bluewiretoneutral

• brownwiretolive

Indice

Altri manuali Philips Controllori

Philips

Philips Video System Manager Pro Series Manuale utente

Philips

Philips Dynalite DMC2 Manuale utente

Philips

Philips dynalite DBC1210 Manuale utente

Philips

Philips Dynalite Revolution Series Manuale utente

Philips

Philips Dynalite DBC1205 Manuale utente

Philips

Philips DYNALITE DDRC420FR Manuale utente

Philips

Philips Dynalite DMRC210DA-RJ12 Manuale utente

Philips

Philips TDA8002C Manuale utente

Philips

Philips Dynalite DLE1210GL Manuale utente

Philips

Philips CoralCare Istruzioni per il montaggio

Philips

Philips DYNALITE DDRC1220FR-GL Manuale utente

Philips

Philips Dynalite DRC810DT Manuale utente

Philips

Philips DYNALITE DMC4 Manuale di servizio

Philips

Philips Dynalite DDLE802 Manuale utente

Philips

Philips PDIUSBD12 Istruzioni operative

Philips

Philips 9890 000 0268 Series Manuale utente

Philips

Philips Dynalite DDRC810DT-GL Manuale utente

Philips

Philips Strand Lighting Sixer Manuale di istruzioni

Philips

Philips Dynalite DLE1220GL Manuale utente

Philips

Philips dynalite DDC116 Manuale utente

Philips

Philips Dynalite Revolution DR2PE Manuale utente

Philips

Philips NOA0025 Manuale utente

Philips

Philips iPlayer 3 Manuale utente

Philips

Philips Vaya Touch Controller Manuale utente

Manuali Controllori popolari di altre marche

Digiplex

Digiplex DGP-848 Istruzioni operative

YASKAWA

YASKAWA SGM series Manuale utente

Sinope

Sinope Calypso RM3500ZB Manuale utente

Isimet

Isimet DLA Series Style 2 Manuale di installazione

LSIS

LSIS sv-ip5a Manuale utente

Rockwell Automation

Rockwell Automation 1769-L31 Manuale utente

Airflow

Airflow Uno hab Manuale utente

ABB

ABB ACS580-01 drives Manuale utente

Panasonic

Panasonic GM1 Series Manuale utente

Emerson

Emerson SW93 Manuale utente

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuale utente

Panasonic

Panasonic FP? Positioning Unit RTEX Manuale utente

Samson

Samson Type 5824 Manuale di servizio

Alpha IP

Alpha IP MIOB 21001 Manuale utente

Siemens

Siemens OpenAir GMA 1 Series Manuale utente

Surecom

Surecom SR-629 Manuale utente

Fishman

Fishman TriplePlay Manuale utente

Regulus

Regulus SRS1 T Manuale utente