Philips LASERFAX 920 Manuale utente

920

100

OFF

English page 4

Français page 16

Dansk side 28

Norsk side 40

Svenska sid 52

Suomi sivu 64

1Do not allow the shaver to become wet.

2Do not leave the appliance in a position

where it can become damaged by direct

sunlight or other heat source.

- Before first use or

- if the shaver has not been used for a

month or longer

it should be charged for a period of at

least 8 hours (irrespective of the reading

on the display).

If the batteries are completely empty, it may

take some time (3-5 minutes) before

information appears in the display.

• Please bear in mind that your skin may

need two to four weeks to become fully

accustomed to the Philishave shaving

system.

920

100

920

100

■■■ Important English

■■■ Switching on/off.

3 The slider switch has a locking

knob which prevents the shaver

from being switched on

accidentally.

Keeping the small knob on the

switch pressed-in slide the switch

upwards/downwards.

■■■ Charging

• Ensure that the shaver is switched off.

•It is advisable to charge the shaver at

temperatures between 5°and 35°C (41°and 95°F).

This guarantees maximum life from the

rechargeable batteries.

•If you keep the shaver in the case when

charging ensure that the lid is left open to

prevent overheating.

•Before first use (or if the shaver has not been

used for long time) it should be charged for a

period of at least 8 hours.

To protect the environment, this

rechargeable Philishave appliance is

equipped with nickel-hydride batteries.

These contain less than 0.01% cadmium.

Yet we advise you to ensure that the batteries

are separated from the normal household

refuse and that they are disposed of at an

officially assigned place when discarding your

appliance in due course. Please refer to section

“Protecting the environment”.

•Recharging: 60 minutes.

The shaver can also be charged from a 12 - 24 Volts

(DC) supply using cord connector type HP 1957.

(Available from Philips retailers or Authorised Service

Dealers.) Charging from a 12 - 24 Volts (DC) supply

requires approx. 24 hours.

• Regular cleaning of the shaver means that less

battery energy is consumed, so that more shaving

time becomes available.

• The shaver will not be damaged by leaving it

connected to the mains supply after it is fully

charged. However, it is not advisable to charge the

shaver permanently as this would shorten the life of

the rechargeable batteries.

4 Insert the small plug into the

shaver. Ensure that the plug is

pushed fully home. (Note the

indication mark.)

Mains voltages: 100 - 240 Volts.

(The shaver adjusts

automatically.)

5One of the blocks of the charge meter

will start flashing.

If the batteries are almost empty, the

first block will be red.

When it turns green, there is enough

energy in the rechargeable batteries for

one cordless shave (3 minutes).

6Each time when 20% of the full charge

has been accomplished the next block

of the energy meter will start to flash.

920

100

920

100

920

100

7After 60 minutes, block “100” comes on

flashing. This block stops flashing as

soon as the shaver is fully charged.

■■■ Cordless shaving

When switching on and off, the blocks of the energy

meter become visible for approx. 8 seconds.

You can then check how much charge is still

available in the rechargeable batteries, until the

reserve capacity will be reached.

8After shaving cordless with the fully

charged shaver for some time, the fifth

block will no longer be visible.

Thereafter, the other blocks will

disappear successively.

9When the last block turns red, the

reserve energy has been reached.

(You will be able to complete the

shave.)

As the shaver is switched off you will

hear a sound signal for 4 seconds

and the red block will start flashing.

This indicates that it is time to

recharge the shaver.

920

100

920

100

920

100

■■■ Have you missed out charging?

When the batteries are completely empty and the

shaver stops, you can give the shaver a quick

charge (sufficient for one cordless shave):

- Charge the shaver until the last block turns from red

into green.

■■■ Shaving directly from the mains supply

(wall socket)

- If you wish you can connect the shaver to a wall

socket using the mains cord and shave directly from

the mains supply.

■■■ Shaving

10 Switch on.

11 The comfort control can be adjusted to suit

skin sensitivity.

Start with the control set to position 1 (for sensitive

skin) and then try other positions to find the one

that suits you best.

12 Move the shaving unit quickly over the skin

and especially against the direction of the hair

growth, stretching the skin with your free hand to

bring the hairs into an upright position.

• Best results are obtained if the skin is dry.

Preferably shave before or some time after

washing.

• If required apply a pre-shave lotion. This can be

particularly helpful if the climate is warm and humid.

1 2 3 4 5 6 7 8 9

11 12

■■■ Trimmer

The trimmer can be engaged whilst the motor is

running.

13 To engage the trimmer push the slide

upwards.

To disengage move the slide downwards.

Brush the trimmer clean after each use.

14 The trimmer has been especially designed for

grooming sideburns, moustache and beard.

The trimmer is not required for long hairs in the

neck area; these hairs can easily be shaved off

with the shaving unit.

15 Maintenance (every six months)

Apply two drops of light machine oil to the teeth of

the trimmer.

13 15

OIL

Altri manuali per LASERFAX 920

Questo manuale è adatto per i seguenti modelli

Indice

Lingue:

Altri manuali Philips Rasoio elettrico

Philips

Philips HQ9090 Manuale utente

Philips

Philips HQ 7742 Manuale utente

Philips

Philips HQG267 Manuale utente

Philips

Philips HQ7130 Manuale utente

Philips

Philips S7000 series Manuale utente

Philips

Philips HQ-T 388 Manuale utente

Philips

Philips S99 series Manuale utente

Philips

Philips NORELCO AT895 Manuale utente

Philips

Philips Norelco QT4019 Istruzioni per il montaggio

Philips

Philips OneBlade QP2529/95 Manuale utente

Philips

Philips QS6140/32 Manuale utente

Philips

Philips AquaTouch AT926 Manuale utente

Philips

Philips Philishave HQ 686 Manuale utente

Philips

Philips HQ7816/16 Manuale utente

Philips

Philips Norelco 7380XL Manuale utente

Philips

Philips Corona HQ8100 Manuale utente

Philips

Philips S7000 series Manuale utente

Philips

Philips Bikini Perfect HP6362 Manuale utente

Philips

Philips MG7730 Manuale utente

Philips

Philips Norelco RQ12+ Manuale utente

Philips

Philips Ladyshave HP6342 Manuale utente

Philips

Philips HQ7140/17 Manuale utente

Philips

Philips RQ1285 Manuale utente

Philips

Philips PQ225 Manuale utente

Manuali Rasoio elettrico popolari di altre marche

Norelco

Norelco Quadra 7610X Manuale utente

Braun

Braun WaterFlex WF2s Manuale utente

Daga

Daga MT-400 Manuale

Remington

Remington BHT100 Manuale utente

Kompernass

Kompernass KH 5537 Manuale utente

Remington

Remington BHT6100 Manuale utente

MIA

MIA Aqua Body Manuale utente

Matheo

Matheo MLR 15 Manuale utente

CTC Union

CTC Union Clatronic HSM 3441 NE Manuale utente

Remington

Remington XR7000 Manuale utente

Eldom

Eldom G47 Manuale utente

Braun

Braun silk-epil 5 Manuale utente

SEVERIN

SEVERIN SÉRIE E700 0533 Guida utente

Remington

Remington PR1355 Manuale utente

Aurora

Aurora AU 3543 Manuale utente

Braun

Braun InterFace 3614 Manuale utente

Wahl

Wahl 8061 5-STAR Manuale utente

Norelco

Norelco 4404LC Manuale utente