Philips ADD4963 Manuale utente
Dispenser
ADD4963
User Manual
Main technical specication
1 1
Product overview
2 2
Indicator panel and switch
3 3
Instruction
·UV-LED light
4 4
5
Precautions
5 5
Cleaning and maintenance
6 7
Trouble shooting 8
9
9
Guarantee and Service
7
Packing list
8
9
Content
1 Main technical specication
Model
Rated voltage
Rated frequency
Heating power
Cooling power
Hot water
Cold water
Environmental temp.
Coolant
Relative humidity
Protection of anti-electric shock
ADD4963
220-240V~
50Hz/60Hz
500W
85W
≥90℃, 5L/h
≤10℃，2L/h
S T/ T
R134a, 38g
≤90%
I
1
2 Product overview
Child safety lock
1
Indicator panel
2
Cold water faucet
3
Ambient water faucet
4
Hot water faucet
5
Drip tray
6
Lower cabinet door
7
Water bottle cap with hose
8
9
10
11
12
13
Water bottle
Power switch
Condenser
Power cord
Dispenser ushing drain
1
2
3
4
5
6
7
8
9
10
11
12
13
2
3 Indicator panel and switch
When the dispenser is connected with power and the power button switches to ON, the
power on indicator will light up.
When the dispenser is heating up the water in the hot water tank, the heating indicator light
will be on.
When the dispenser is cooling the water in the cold water tank, the cooling indicator light will
be on.
When there's no water left in the bottle, the water shortage indicator will be on. Replace with
a new bottled water and the indicator will switch o automatically.
At the back of the dispenser there is a red switch which controls the heating power, and a green
switch controlling the cooling power.
You can turn it on when you need hot or cold water.
Water shortage indicator
Cooling indicatorHeating indicator
Power on indicator
Indicator panel
3
Heating switchCooling switch
Power Switch
If you rst turn on the switch, for optimal temperature, the dispenser will need around 20
minutes for hot water and around an hour for cold water.
4 Instruction
(1) Unpacking the water dispenser
· Cut and remove the straps from the box. DO NOT turn the box upside down, or lay it on its
side. The bottom of the box is separate from the top section. Lift straight up on the top box
section to remove the top box section. Remove the Styrofoam packaging and plastic bag.
Lift the water dispenser o the bottom of the bottom of the box. Wipe it clean if necessary.
· Place the machine on a hard, at surface. Make certain the unit is leveled. The unit should
not be placed near direct sunlight or other source of heat.
· It is best to place the water dispenser in an area with good air circulation. Make sure there is
at least 4 inches (10cm) of space between the back of your water dispenser and the wall.
Keep a minimum distance of 2 inches (5cm) on each side of your water dispenser.
Warning: the drain plug on the back of the unit may become loose during shipping. Fasten
the drain plug tightly before you start to operate the unit. If the drain plug is loose, the unit
may leak and cause oor damage.
(2) Settling water bottle
· Make sure the water dispenser is not plugged into an electrical outlet.
· Open the door of the lower cabinet.
· Place full water bottle on oor. Remove the plastic cover over the mouth of the water bottle.
· Place the stainless tube inside the bottle and place the water bottle cap rmly over the
mouth of the water bottle.
· Attach the hose to the top of the cap using the quick connect system shown below*.
· Slide the bottle inside the cabinet and close the lower cabinet door.
* Your new water dispenser features an adjustable quick connect system. For proper
operation, make sure the connector is sealed tight (Fig. 1);
The connector can be removed easily for cleaning with warm soapy water (Fig. 2);
The stainless steel tube can be adjusted up and down to accommodate both 3 gallon and 5
gallon water bottle (Fig. 3).
4
Note: If there is not a secure connection between the hose cap and the connector on the
water dispenser, the water pump will operate but the water dispenser will not dispense water.
Make sure the hose is connected to the water dispenser correctly.
(3) Dispense water
· Plug the water dispenser into a grounded power outlet. The unit will pump the water from
the water bottle into the cooling and heating tanks.
· Press the hot water button until water ows out.
· Turn on the power switch on the back of the unit to heat or cool the water. The indicator light
will be on when heating or cooling is working. To get optimal temperature, do not turn o the
power switch until heating or cooling is done.
· Enjoy the hot or cold water you need.
· If you do not need hot or cold water, turn o the power switch to conserve energy.
Note: please wait until the water pump stops running before using the unit. If the water tank is
not full, no water will dispense from the water faucet.
5
UV-LED light
The UV-LED light is installed in the cold water tank to kill the bacteria which may grow inside.
It's controlled automatically by the software program once the dispenser is connected
with power.
Warning
When using electrical appliances, basic safety precautions should be followed to reduce the
risk of re, electric shock, and injury to persons or property. Read all instructions before using
any appliance.
5 Precautions
· Do not let hot water touch bare skin. Keep combustible material such as furniture, bedding,
pillows, clothes, and/or papers away from the back of the unit.
· Do not operate this, or any other appliance with a damaged power cord. No other appliance
should be plugged into the same outlet. Be sure that the plug is fully inserted into the outlet.
· Do not run the power cord over carpeting or other heat insulators. Do not cover the cord.
Keep cord away from high trac areas, and do not submerge in water.
· We do not recommend the use of extension cord as it may overheat and cause a risk of re.
· Exercise caution and use reasonable supervision when the appliance is used by or near children.
· Do not use your water dispenser outdoors. Place the water dispenser away from direct
sunlight and make sure that there is at least 4 inches (10cm) of space between the back of
your unit and wall. Keep a minimum of 2 inches (5cm) on each side of your unit free.
· Do not use this product to dispense anything other than water.
· To avoid a hazard due to instability of the appliance, it must be placed on even and at surface.
· If the supply cord is damaged, please contact aftersales personnel to replace it in order to
avoid a hazard.
· This water dispenser must be positioned so that the plug is accessible.
· Disconnect the plug from the outlet when not in use.
· Remove power plug or disconnect from the main power source before servicing the appliance.
· The appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction.
· Children being supervised should not play with the appliance.
· Do not store explosive substances such as aerosol cans with a ammable propellant in this
appliance.
· This appliance is intended to be used in household and similar applications
such as: IEC 60335-2-15.
- sta kitchen areas in shops, oces and other working environments;
- farm houses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments.
· WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged.
· WARNING: Do not locate multiple portable socket outlets or portable power supplies at the rear
of the appliance.
6
· To avoid accidents, turn o and unplug the water dispenser from the outlet before cleaning.
· A soft damp cloth may be used to clean the surface of the water dispenser. When necessary,
a mild detergent may be used. DO NOT use corrosive chemical solvents to clean the unit, as
this may damage the surface of the water dispenser.
· DO NOT pour water on the exterior of the unit to avoid getting the internal electrical system
wet . DO NOT immerse the unit in water when cleaning.
· The water bottle cap, hose, and drip tray may be washed in a dishwasher (top rack only).
· Keep the water dispenser 6 inches (15cm) away from the wall so it can work properly. Make
certain all ventilation openings are clear of obstruction.
· Do not damage the heating or cooling system, paying particular attention to the black
condenser or heating radiator on the back of the water dispenser.
· If you will not use the water dispenser for a long period of time, please unplug the power
cord and drain the water dispenser. Drain the water from all faucets, then remove the drain
cap on back and allow it to drain. Make certain the drain cap is fastened tightly when nished.
6 Cleaning and maintenance
7
Indice
Altri manuali Philips Distributore d'acqua
Philips
Philips ADD5910M Manuale utente
Philips
Philips Pure Taste WP3961 Manuale utente
Philips
Philips WP3890 Manuale utente
Philips
Philips WP3892 Manuale utente
Philips
Philips Micro X-Pure WP3922 Manuale utente
Philips
Philips Micro Pure WP3911 Manuale utente
Philips
Philips WP3893 Manuale utente
Philips
Philips WP3812 Micro X-Pure Manuale utente
Philips
Philips ADD4962 Manuale utente
Philips
Philips ADD4954 Manuale utente
