Planet ADW-4401 A/B Manuale utente

802.11g Wireless

ADSL 2/2+ Router

ADW-4401 A/B

User's Manual

this publication may be reproduced, transmitted, transcribed, stored in a retrieval

system, or translated into any language or computer language, in any form or by any

means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise,

without the prior written permission of PLANET.

PLANET makes no representations or warranties, either expressed or implied, with

respect to the contents hereof and specifically disclaims any warranties,

merchantability or fitness for any particular purpose. Any software described in this

manual is sold or licensed "as is". Should the programs prove defective following

their purchase, the buyer (and not this company, its distributor, or its dealer) assumes

the entire cost of all necessary servicing, repair, and any incidental or consequential

damages resulting from any defect in the software. Further, this company reserves

the right to revise this publication and to make changes from time to time in the

contents hereof without obligation to notify any person of such revision or changes.

All brand and product names mentioned in this manual are trademarks and/or

registered trademarks of their respective holders.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

4. Consult the dealer or an experienced radio technician for help.

FCC Caution:

To assure continued compliance (example-use only shielded interface cables when

connecting to computer or peripheral devices). Any changes or modifications not

expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

Following two conditions: (1) This device may not cause harmful interference, and (2)

this Device must accept any interference received, including interference that may

cause undesired operation.

Federal Communication Commission (FCC) Radiation Exposure Statement

This equipment complies with FCC radiation exposure set forth for an uncontrolled

environment. In order to avoid the possibility of exceeding the FCC radio frequency

exposure limits, human proximity to the antenna shall not be less than 20 cm (8

inches) during normal operation.

R&TTE Compliance Statement

This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF

THE EUROPEAN PARLIAMENT AND THE COUNCIL OF 9 March 1999 on

radio equipment and telecommunication terminal Equipment and the mutual

recognition of their conformity (R&TTE)

The R&TTE Directive repeals and replaces in the directive 98/13/EEC

(Telecommunications Terminal Equipment and Satellite Earth Station Equipment)

As of April 8, 2000.

WEEE Regulation

To avoid the potential effects on the environment and human health as a

result of the presence of hazardous substances in electrical and electronic

equipment, end users of electrical and electronic equipment should

d the meaning of the crossed-out wheeled bin symbol. Do not

unicipal waste and have to collect such

understan

dispose of WEEE as unsorted m

WEEE separately.

Safety

ost care for the safety of those who install

attention must be paid to the dangers of electric shock

and static electricity when working with electrical equipment. All guidelines of this

the computer manufacture must therefore be allowed at all times to ensure the

EM-ADW4401v1

This equipment is designed with the utm

and use it. However, special

and of

safe use of the equipment.

evision

User’s Manual for 802.11g Wireless ADSL 2/2+ Router

-4401 A/BModel: ADW

Rev: 1.0 (Dec. 2005)

Part No.

Table of Contents

. INTRODUCTION .....................................................................................................7

1.1 FEATURE...........................................................................................................7

1.2 PACKAGE CONTENT ..............................................9

S......................................

1.3 PHYSICAL DETAILS .......................................................................................9

2. INSTALLATION ....................................................................................................11

2.1 SYSTEM REQUIREMENT .............................................................................11

2.2 HARDWARE INSTALLATION .....................................................................11

3 CONFIGURATION..................................................................................................13

3.1 DETERMINE YOUR CONNECTION SETTINGS ........................................13

3.2 CONNECTING THE ADSL ROUTER TO YOUR NETWORK....................13

3.3 CONFIGURING WITH WEB BROWSER .....................................................13

3.3.1 QUICK SETUP GUIDE ........................................................................14

3.3.2 System Time..........................................................................................18

3.3.3 Admin Setting........................................................................................19

3.3.4 Firmware Update...................................................................................20

3.3.5 System Log............................................................................................20

3.3.6 System Reset..........................................................................................21

3.4.1 ADSL Status..........................................................................................22

3.4.2 ADSL Statistics .....................................................................................22

3.4.3 VC Configuration..................................................................................23

3.5.1 WAN Configuration..............................................................................23

3.5.2 WAN Status...........................................................................................24

3.5.3 DNS.......................................................................................................25

3.5.4 DDNS ....................................................................................................26

3.6.1 LAN Configuration................................................................................27

3.7.1 Wireless Settings...................................................................................27

3.7.2 Wireless Security...................................................................................28

3.8.1 IP Filtering.............................................................................................29

3.9.1 NAT Setting...........................................................................................30

3.9.2 Virtual Server ........................................................................................31

3.9.3 DMZ Setting..........................................................................................31

3.9.4 ADSL Type Setting...............................................................................32

3.10.1 Static Routing......................................................................................32

3.10.2 Dynamic Routing.................................................................................33

3.10.3 Routing Table......................................................................................34

3.11.1 System Status.......................................................................................35

Append

ix A: Glossary..................................................................................................36

1. Introduction

The PLANET 802.11g Wireless ADSL 2/2+ Router, ADW-4401, provides office and

or sharing a high-speed ADSL 2/2+ broadband

4Mbps wireless network and a 10/100Mbps Fast Ethernet

er, NAT, virtual server, DMZ, access control, IP filter, PPTP/IPSec

eing

dress

ng IPs are monitored and filtered.

Internet Access Features

Internet Access. All users on the LAN or WLAN can access the

Internet through the ADW-4401 using only a single external IP Address. The

ddresses are hidden from external sources. This process is



pport. Various WAN

d. In most situations, the

the

residential users the ideal solution f

Internet connection on a 5

backbone. It can support downstream transmission rates of up to 24Mbps and upstream

transmission rates of up to 3.5Mbps. The product supports PPPoA (RFC 2364 - PPP

over ATM Adaptation Layer 5), RFC 2684 encapsulation over ATM (bridged or

routed), PPP over Ethernet (RFC 2516), and IPoA (RFC1577) to establish a connection

with ISP.

Via the user-friendly management interface, ADW-4401 can be managed by

workstations running standard web browsers. Furthermore, ADW-4401 provides

DHCP serv

pass-through, DDNS, and UPnP capability.

The ADW-4401 also serves as an Internet firewall, protecting your network from b

accessed by outside users. It provides the natural firewall function (Network Ad

Translation, NAT). All incoming and outgoi

Moreover, it can be configured to block internal users from accessing to the Internet.

1.1 Feature

Shared

local (invalid) IP A

called NAT (Network Address Translation).

Built-in ADSL 2/2+ Modem. The ADW-4401 provides ADSL 2/2+ modem,

and supports all common ADSL connections.

IPoA, PPPoE, PPPoA, Direct Connection Su

connections are supported by ADW-4401.

Auto-detection of Internet Connection Metho

ADW-4401 can test your ADSL and Internet connection to determine

connection method used by your ISP.

Fixed or Dynamic IP Address. On the Internet (WAN port) connection,

ADW-4401 supports both Dynamic IP Address (IP Address is allocated on

connection) and Fixed IP Address.

the

Adv c

s

quick and easy.

le firewall with NAT technology and provides option

atic discovery and

ture,

namic IP address which changes every time you connect.

otely

Wir s

less LANs. Maximum of 54Mbps are

ard

802.11g Wireless stations can be used simultaneously.

on are

less Access Control feature can

Wireless Stations can access your LAN.

LAN Features

an ed Internet Functions

Virtual Servers. This feature allows Internet users to access Internet server

on your LAN. The required setup is

Firewall. Supports simp

for blocking access from Internet, like Web, FTP, Telnet, SNMP, ICMP.

Universal Plug and Play (UPnP) UPnP allows autom

configuration of the Broadband Router. UPnP is supported by Windows ME,

XP, or later.

Dynamic DNS Support. DDNS, when used with the Virtual Servers fea

allows users to connect to Servers on your LAN using a Domain Name, even if

you have a dy

VPN Pass through Support. PCs with VPN (Virtual Private Networking)

software using PPTP, L2TP and IPSec are transparently supported - no

configuration is required.

RIP1/2 Routing. It supports RIP1/2 routing protocol for routing capability.

Simple Network Management Protocol (SNMP). It is an easy way to rem

manage the router via SNM

ele s Features

Standards Compliant. The ADW-4401 complies with the IEEE802.11g

(DSSS) specifications for Wire

supported.

Supports both 802.11b and 802.11g Wireless Stations. The 802.11g stand

provides for backward compatibility with the 802.11b standard, so bo

802.11b and

WEP support. Support for WEP (Wired Equivalent Privacy) is included. Key

sizes of 64 Bit and 128 Bit are supported.

WPA-PSK support. WPA-PSK_TKIP and WAP-PSK_AES encrypti

supported.

Wireless MAC Access Control. The Wire

check the MAC address (hardware address) of Wireless stations to ensure th

only trusted

4-Port Switch. The ADW-4401 incorporates a 4-port 10/100Base-TX

switching hub, making it easy to create or extend your LAN.

DHCP Server Support. Dynamic Host Configuration Protocol provides a

r devices upon request. The ADW-4401

1.2 Pa

ADW-4401 Unit

‧ Power Adapter

‧ User’s Manual CD

ront Panel

dynamic IP address to PCs and othe

can act as a DHCP Server for devices on your local LAN and WLAN.

ckage Contents

‧

‧ Quick Installation Guide

‧ RJ-11 (ADSL) cab

‧ RJ-45 cable

1.3 Physical Details

Front Panel LED definition

LED State Description

ON When the router is powered on and in ready state

Power Flashing The router is in booting stage

Successful connection between ADSL modem and telecom's

ON network

ADSL

Flashing Modem is trying to establish a connection to telecom’s network

ACT Flashing Data is transferred between router and Internet

WLAN Flashing When wireless AP is ready

ON Link

Flashing TX or RX activity

LAN

1-4 OFF

No Link

These four LAN (Local Area Network) ports are where you

will connect networked devices, such as PCs, print servers

remote hard drives, and anything else you want to put on your

network

Rear Panel

Rear panel Port and Button Definition

Connector Description

POWER Power connector with 9V DC 1.5 A

Reset The reset button, the router restore the default settings when press this

Switch button until reboot

Router is successfully connec through the corresponding

AN (1-4)

ted to a device

port (1, 2, 3, or 4). If the LED is flashing, the Router is actively sending

or receiving data over that port.

ADSL

Connector

The RJ-11 connector allows data communication between the modem

and the ADSL network through a twisted-pair phone wire

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Planet Router di rete

Planet

Planet GS-4210 SERIES Manuale utente

Planet

Planet 802.11g Wireless Access Point / Bridge... Manuale utente

Planet

Planet ERT-805 Manuale utente

Planet

Planet XRT-401C Manuale utente

Planet

Planet IGS-6325 DIN rail Series Manuale utente

Planet

Planet SW-502 Manuale utente

Planet

Planet IAD-300 Manuale utente

Planet

Planet WGS-804HP Manuale utente

Planet

Planet MH-3400 Manuale utente

Planet

Planet XRT-401D Manuale utente

Planet

Planet IGS-10020 Manuale utente

Planet

Planet FGSD-1022VHP Manuale utente

Planet

Planet WGSW-2620PV Manuale utente

Planet

Planet G.SHDSL.bis Bridge Router GRT-504 Manuale utente

Planet

Planet ADE-3400v3 Manuale utente

Planet

Planet WNAP-7335 Manuale utente

Planet

Planet FGSW-2620 Manuale utente

Planet

Planet ADE-4100 Manuale utente

Planet

Planet VR-100 Series Manuale utente

Planet

Planet WGS3-2840 Manuale utente

Planet

Planet WDRT-1800AX Manuale utente

Planet

Planet MGSW-28240F Manuale utente

Planet

Planet EPN-104 Manuale utente

Planet

Planet GRT-402 Manuale utente

Manuali Router di rete popolari di altre marche

Allnet

Allnet ALL0333AU Manuale utente

HomeSeer

HomeSeer HT-SEL Manuale utente

Sercomm

Sercomm Genesis OC3505D Manuale utente

Billion

Billion BIPAC 5102 Series Manuale utente

TP-Link

TP-Link TD-8817 Manuale utente

Motorola

Motorola MR1900 Manuale utente

Digi

Digi IX14 Manuale utente

Cisco

Cisco NCS 540 Manuale

XAVi

XAVi X8821e Manuale utente

BEC

BEC 6200WZL Manuale utente

MikroTik

MikroTik hAP ac3 Series Manuale utente

Korenix

Korenix JetNet 5428G Series Manuale utente

NETGEAR

NETGEAR FS526T - Switch Manuale utente

Korenix

Korenix JetNet 5710G Series Manuale utente

Automated Logic

Automated Logic ZN551 Manuale del proprietario

Cisco

Cisco ASR 1000 Series Manuale dell'operatore

EnGenius

EnGenius ESR-9710 Manuale utente

Cisco

Cisco 805 Series Istruzioni operative e di sicurezza