Planet VC-23 Series Manuale utente
Ethernet over VDSL2 Bridge
VC-231/VC-234
User’s Manual
Trademarks
Copyright © PLANET Technology Corp. 2021
Contents subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp.
The information in this manual is subject to change without
notice. All other trademarks belong to their respective owners.
Disclaimer
PLANET Technology does not warrant that the hardware will
work properly in all environments and applications, and makes
no warranty and representation, either implied or expressed,
with respect to the quality, performance, merchantability, or
tness for a particular purpose.
PLANET has made every eort to ensure that this User’s Manual
is accurate; PLANET disclaims liability for any inaccuracies or
omissions that may have occurred.
Information in this User’s Manual is subject to change without
notice and does not represent a commitment on the part of
PLANET. PLANET assumes no responsibility for any inaccuracies
that may be contained in this User’s Manual. PLANET makes no
commitment to update or keep current the information in this
User’s Manual, and reserves the right to make improvements
to this User’s Manual and/or to the products described in this
User’s Manual, at any time without notice.
If you nd information in this manual that is incorrect,
misleading, or incomplete, we would appreciate your comments
and suggestions.
FCC Warning
This equipment has been tested and found to comply with the
regulations for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with this user’s guide, may
cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct
the interference at his own expense.
CE Mark Warning
This device is compliant with Class A of CISPR 32. In a
residential environment this equipment may cause radio
interference.
Energy Saving Note of the Device
This power required device does not support Standby mode
operation.
For energy saving, please remove the power cable to disconnect
the device from the power circuit.
Without removing power cable, the device will still consuming
power from the power source. In the view of Saving the Energy
and reduce the unnecessary power consuming, it is strongly
suggested to remove the power connection for the device if this
device is not intended to be active.
WEEE Warning
To avoid the potential eects on the environment and
human health as a result of the presence of hazardous
substances in electrical and electronic equipment, end
users of electrical and electronic equipment should
understand the meaning of the crossed-out wheeled bin symbol.
Do not dispose of WEEE as unsorted municipal waste and have
to collect such WEEE separately.
Revision
Ethernet over VDSL2 Bridge User's Manual
For Models: VC-231/VC-234
Rev 1.2 (Nov. 2019)
Part No.: 2350-AC0140-002
Table of Contents
1. Package Contents ............................................................. 5
2. Product Features............................................................... 6
3. Hardware Introduction ...................................................... 7
3.1 Front Panel................................................................ 7
3.2 LED Indicators ........................................................... 7
3.3 Rear Panel................................................................. 9
3.4 Mode DIP Switch...................................................... 10
3.5 Power Information.................................................... 13
4. Connecting and using the VDSL2 Bridge ........................... 14
4.1 Point-to-Point Application --
LAN to LAN Connection............................................. 15
4.2 Point-to-Multipoint Application --
Connect to IP DSLAM ............................................... 17
4.3 Chassis Installation and Rack Mounting (VC-231) ........... 19
5. Specications ................................................................. 20
6. Troubleshooting .............................................................. 23
7. FAQs ............................................................................. 24
8. Customer Support .......................................................... 26
55
1. Package Contents
Thank you for purchasing PLANET Fast Ethernet over VDSL2
Bridge Series, VC-231 and VC-234. In the following sections, the
term “VDSL2 Bridge” means the VC-23x series.
Open the box of the VDSL2 Bridge and carefully unpack it. The
box should contain the following items:
VDSL2 Bridge x 1 User’s Manual x 1
5V, 2A Power
Adapter x 1
Splitter x 1
(VC-231 only)
RJ11 Telephone
Wire x 1
If any of these are missing or damaged, please contact your
dealer immediately; if possible, retain the carton including the
original packing material, and use them again to repack the
product in case there is a need to return it to us for repair.
6
2. Product Features
Cost-eective VDSL2 CO/CPE bridge solution
One box design, CO/CPE selectable via DIP Switch
Denes prole 17a band plan for the long distance transmis-
sion of upstream and downstream signals
Denes prole 30a band plan for the short distance transmis-
sion of upstream and downstream signals
Complies with IEEE 802.3, IEEE 802.3u and IEEE 802.3x
standards
DMT (Discrete Multi-Tone) line coding
Half-duplex back pressure and IEEE 802.3x full-duplex pause
frame ow control
Built-in POTS splitter to share voice and data (VC-234 only)
Voice and data communication can be shared on the existing
telephone wire simultaneously
Hardware IGMP Snooping for multimedia service (VC-234)
Supports up to 1536 bytes packet size, 802.1Q VLAN tag
transparency
VDSL2 stand-alone transceiver for simple bridge modem
application
Selectable target prole and target SNR margin
Supports extensive LED indicators for network diagnostics
7
3. Hardware Introduction
3.1 Front Panel
VC-231 Front Panel
Figure 3-1: VC-231 front panel
VC-234 Front Panel
Power
VC-234 1234VDSL CPE
CO
LNK/ACT
Ethernet over VDSL Bridge
2
Figure 3-2: VC-234 front panel
3.2 LED Indicators
System
LED Color Function
PWR Green
Lit Lights to indicate that the VDSL2 Bridge
has power.
O Indicate that the VDSL2 Bridge has no
power.
8
VDSL
LED Color Function
VDSL Green
Lit Indicates that the VDSL link is
established.
Fast
Blink
Indicates that the VDSL link is in training
status (about 10 seconds).
Slow
Blink
Indicates that the VDSL link is in idle
status.
CO Green Lit Indicates the VDSL2 Bridge is running in
CO mode.
CPE Green Lit Indicates the VDSL2 Bridge is running in
CPE mode.
10/100BASE-TX Port for VC-231
LED Color Function
LNK/
ACT Green
Lit Indicates that the port is linked up.
Blink
Indicates that the VDSL2 Bridge is
actively sending or receiving data over
that port.
O Indicates that the port is linked down.
100 Green
Lit Indicates that the port is operating at
100Mbps.
O Indicate that the port is linked down or
10Mbps.
9
10/100BASE-TX Port for VC-234
LED Color Function
LNK/
ACT Green
Lit Indicates that the port is linked up at
10/100Mbps.
Blink Indicates that the VDSL Bridge is actively
sending or receiving data over that port.
O Indicates that the port is linked down.
3.3 Rear Panel
The rear panel of the VDSL2 Bridge is shown below.
VC-231 Rear Panel
Figure 3-3: VC-231 rear panel
¾DIP switch
¾DC jack (DC input) for power adapter
10
VC-234 Rear Panel
LAN
4 3 2 1VDSLPhone
CO
lnter
17a
9dB
CPE
Fast
30a
6dB
ON
OFF
5V
, 2A max.
1
2
3
4
ON
Figure 3-4: VC-234 rear panel
¾Four 10/100BASE-TX RJ45 connectors for Ethernet
¾One RJ11 connector for VDSL2; connect to IP DSLAM or
another VDSL2 Bridge
¾One RJ11 connector for telephone or PBX POTS
¾DIP switch
¾DC jack (DC input) for power adapter
3.4 Mode DIP Switch
The Ethernet over VDSL2 Bridge provides 4 selective
transmission modes. By switching the transmission modes,
you can obtain a best transmission mode to suit with phone
line quality or distance of connectivity. The following is the
summary table of transmission setting, bandwidth and distance
extensibility tested for AWG 24 (0.5mm) twisted-pair without
noise and cross talk.
DIP-1 DIP-2 DIP-3 DIP-4
Mode Channel Prole SNR
OFF CO Interleave 17A 9dB
ON (default) CPE Fast 30A 6dB
Questo manuale è adatto per i seguenti modelli
2
Indice
Altri manuali Planet Router di rete
Planet
Planet PL-510W Manuale utente
Planet
Planet PL-501-EU Manuale utente
Planet
Planet XRT-401C Manuale utente
Planet
Planet VC-230 Manuale utente
Planet
Planet FNSW-1601 Manuale utente
Planet
Planet WGS-804HP Manuale utente
Planet
Planet WNAP-7200 Manuale utente
Planet
Planet ADE-3400 Manuale utente
Planet
Planet IGS-5227-6T Manuale utente
Planet
Planet WNRT-625G Manuale utente
Planet
Planet FRT-420SN Manuale utente
Planet
Planet ADE-3400 Manuale utente
Planet
Planet 802.11g Wireless Access Point / Bridge... Manuale utente
Planet
Planet FGSW-2402VS Manuale utente
Planet
Planet GSD-908HP Manuale utente
Planet
Planet ADE-3400v4 Manuale utente
Planet
Planet FNSW-1600S Manuale utente
Planet
Planet VR-300 Series Manuale utente
Planet
Planet ERT-805 Manuale utente
Planet
Planet WDRT-1800AX Manuale utente
Manuali Router di rete popolari di altre marche
NETGEAR
NETGEAR FS526T - Switch Manuale utente
Korenix
Korenix JetNet 5710G Series Manuale utente
Automated Logic
Automated Logic ZN551 Manuale del proprietario
Cisco
Cisco ASR 1000 Series Manuale dell'operatore
EnGenius
EnGenius ESR-9710 Manuale utente
Cisco
Cisco 805 Series Istruzioni operative e di sicurezza