Planet ERT-805 Manuale utente

Table of Contents

Chapter 1 Package Contents 1

Unpacking the router 1

Hardware install section 2

Connect a Serial Device 2

Chapter 2 Terminal Setup 3

Chapter 3 Logon to the Console 5

Chapter 4 Configure Password 7

Chapter 5 Configuration IP Address 9

This page is intentionally left blank

Chapter 1

Package Contents

Thank you for purchasing ERT-805 Serial WAN Router.

This installation guide provides the basic information of the router, ERT-805, including,

hardware installation, console interface login and LAN interface setup. For more

information of the router, please also refer to the user’s manual of the router in the CD-

ROM.

Unpacking the router

Open the box of the ERT-805 router and carefully unpack it. The box should contain the

following items:

• ERT-805 Serial WAN Router

• Power Cord

• DB9 to RJ-45 changer

• RJ-45 to RJ-45 modem cable

• User’s Manual CD

• Quick installation Guide

 Note:

if any item is found missing or damaged, please contact your local

reseller immediately.

Hardware install section

To install ERT-805 serial router, just following the step:

• Connect an Ethernet device

• Connect a Serial device

• Connect a terminal or PC

• Connect the power supply

Connect a Serial Device

WAN Option WAN Encapsulation

Frame relay

X.25

Link control (HDLC) or ppp

Frame-relay

X.25

Chapter 2

Terminal Setup

To congure the system, connect the provided RJ-45 cable and DB9 connector to a COM

port on a PC or notebook computer and to serial (console) port of the device.

When the connection between the PC and ERT-805 is ready, run the Hyper Terminal and

congure its communication parameters. It can be accessed from the Start menu. Click

START, then Programs, Accessories and then Hyper Terminal.

The operating mode of the console port is:

• Baud rate: 9600

• Data bits: 8

• Parity: none

• Stop bits: 1

• Flow control: None

After nished the setting, click OK.

Or run the Mrcom32.exe under DOS mode (The program can be found in the CD-ROM,

directory “/utility”). It can access from START menu click RUN then type “e:/utility/

mrcom32 com1 9600” where assume ‘e’ drive is the CD-ROM drive.

This page is intentionally left blank

Chapter 3

Logon to the Console

Once the terminal has connected to the device, power on the device, the terminal will

display that it is running POST (Power on self-test) procedures.

Then, screen as below will show up. The ERT-805 will prompt with “>”. This means ERT-

805 is in operating mode now.

Types “enable” to enter privilege mode. The ERT-805 will prompt with “#” for privilege

mode. By default there is no password.

 Note:

For security reason, please follow the following section to change

the new password after this rst setup. Memorize the password

or write it down and store in a secured place.

This page is intentionally left blank

Chapter 4

Configure Password

1. Once log on to the console, the following screen displayed.

Fig 1: The privilege Screen of ERT-805

2. Types “cong terminal” to enter conguration mode. ERT-805 will prompt

“<console>#”

Fig 2: Conguration mode Screen

3. Then type command enable password “abc” to setup the enable privilege password

where abc is the password. ( password can be any alphabetic or numerical with up

to 16 ASCII character is allowed)

Fig 3: conguration for password

4. Key in “end” to close the congure mode and key in “wr” to store the setting and

make the setting activated right away.

This page is intentionally left blank

Altri manuali per ERT-805

Indice

Altri manuali Planet Router di rete

Planet

Planet Powerline Ethernet Bridge PL-104E Manuale utente

Planet

Planet VC-200S Manuale utente

Planet

Planet ADSL 2/2+ VPN Firewall Router ADE-4300A/B Manuale utente

Planet

Planet ADE-4301A Manuale utente

Planet

Planet WGD-800 Manuale utente

Planet

Planet FGSW-4840S Manuale utente

Planet

Planet ADE-4400 Manuale utente

Planet

Planet ISW-800M Manuale utente

Planet

Planet WAP-200N Manuale utente

Planet

Planet G.SHDSL.bis Bridge Router GRT-504 Manuale utente

Planet

Planet FGSW-4840S Manuale utente

Planet

Planet Gaw9.2Z18-4 Manuale utente

Planet

Planet VDR-300NU Manuale utente

Planet

Planet ADE-3400 Manuale utente

Planet

Planet IGS-801M Manuale utente

Planet

Planet IGS-801T Manuale utente

Planet

Planet ISW-500T Manuale utente

Planet

Planet FGSW-2620 Manuale utente

Planet

Planet ADE-3400v3 Manuale utente

Planet

Planet FNSW-2400PS Manuale utente

Planet

Planet XRT-401C Manuale utente

Planet

Planet WSD-800 Manuale utente

Planet

Planet FNSW-4800 Manuale utente

Planet

Planet ADE-4100 Manuale utente

Manuali Router di rete popolari di altre marche

Allnet

Allnet ALL0333AU Manuale utente

HomeSeer

HomeSeer HT-SEL Manuale utente

Sercomm

Sercomm Genesis OC3505D Manuale utente

Billion

Billion BIPAC 5102 Series Manuale utente

TP-Link

TP-Link TD-8817 Manuale utente

Motorola

Motorola MR1900 Manuale utente

Digi

Digi IX14 Manuale utente

Cisco

Cisco NCS 540 Manuale

XAVi

XAVi X8821e Manuale utente

BEC

BEC 6200WZL Manuale utente

MikroTik

MikroTik hAP ac3 Series Manuale utente

Korenix

Korenix JetNet 5428G Series Manuale utente

NETGEAR

NETGEAR FS526T - Switch Manuale utente

Korenix

Korenix JetNet 5710G Series Manuale utente

Automated Logic

Automated Logic ZN551 Manuale del proprietario

Cisco

Cisco ASR 1000 Series Manuale dell'operatore

EnGenius

EnGenius ESR-9710 Manuale utente

Cisco

Cisco 805 Series Istruzioni operative e di sicurezza