0
Getting Started
Important: The PowerView Remote will not operate a window covering until the
window covering has been added to a GROUP.
First, activate the remote by pulling both plastic tabs from the back battery
compartment.
Inserting the remote module into the PowerView Pebble (hand-held):
1. Centre the Hunter Douglas logo on the
remote module above the indentation
on the bottom rim of the Pebble
2. Align the ribs on the remote module with
the grooves on the Pebble
3. Gently push the remote module into the
Pebble until it is snug
Mounting the PowerView Surface:
1. Choose a location to mount the Surface
2. Orient the Surface mounting plate so that the Hunter Douglas logo is
horizontal and level. Mark screw holes
3. If you are mounting the Surface onto drywall, use a 6mm drill bit to drill pilot
holes. Tap drywall anchors into the pilot holes until the flange of the anchor
is flush with the drywall
4. If you are mounting the Surface onto wood, use a 3mm drill bit to drill the
screw holes
5. Attach the Surface mounting plate using the screws provided
6. Align the Surface ring with its mounting plate and twist the Surface ring
clockwise to lock it in place
Inserting the remote module in the Surface:
1. Align the ribs on the remote module with the grooves on the Surface
2. Gently push the remote module into the Surface until it is snug
