Flypod®is an insect control unit with patented* hygienic
glueboard removal system, utilising a pheromone
impregnated glueboard and a high powered Actinic UV
tube.
ELECTRONIC INSECT KILLERS
Flypod®is the modern answer to glueboard flying insect
control where hygiene is an important consideration.
The instructions given here are intended to help you
operate the Flypod®equipment at maximum efficiency.
WARNING
FLYPOD®IS ONLY SUITABLE FOR INDOOR USE AND IS NOT
SUITABLE FOR USE IN BARNS, STABLES AND SIMILAR
LOCATIONS.
IF THE SUPPLY CORD IS DAMAGED IT CAN NOT BE REPLACED
AND THE UNIT SHOULD BE SAFELY DESPOSED OF AND
REPLACED.
INSTALLATION
Your Flypod®unit requires certain conditions to ensure the
effective control of flying insects in your premises:
1. It should be correctly sited.
2. It should be the correct model for the area to be
protected.
3. It should be in operation for 24 hours a day.
4. Tubes must be replaced every 12 months.
5. The glueboard should be replaced every 4 weeks.
POWER REQUIREMENTS
Flypod®units are designed to operate from the following
power supply:
220V - 240V ~ 50Hz
Therefore, please ensure that your unit is compatible with
the electricity supply in your premises. Make sure the unit is
connected to an earthed electrical supply via a socket
outlet of compatible rating.
WARNING - THIS APPLIANCE MUST BE EARTHED
SITING
Applications of Flypod®obviously vary depending on the
location. Should any queries arise on siting, etc. please
contact your supplier. As a general rule, the UV light from the
Flypod®unit should be visible from every part of the room.
ASSEMBLY
When you first receive your Flypod®, check that you have all
the correct parts. You should have:
- 1 x Product
- 1 x Glueboard
- 1 x 18Watt Tube
To assemble, first attach the tube to the base, by lining up
the four connector pins and pushing into place. Then peel
back the protective paper from the glueboard (1) and
discard. Then slide the glueboard into the runners (2).
SERVICING
BEFORE ANY FORM OF SERVICING, ENSURE THAT THE UNIT IS
DISCONNECTED FROM THE MAINS SUPPLY.
To maintain the units efficiency, replace the UV fluorescent
tubes every 9 to 12 months, making sure the replacement
tubes are of the correct type - obtainable from the supplier
or P+L Systems Ltd. The glueboard should be changed every
4 weeks.
GUARANTEE
Your Flypod®unit is guaranteed for one year (excluding
tubes.) If a fault occurs within twelve months P+L Systems Ltd
will replace your unit, provided the unit is returned.
This guarantee only applies if genuine P+L Systems Ltd spare
parts are used.
N. B. TUBES ARE NOT GUARANTEED
Glueboard Installation
1. 2.
HYGIENIC GLUEBOARD INSECT CONTROL
Brighter Hygiene Solutions...
*Patent Applied
