ProFusion PH-9100WN Manuale utente

10,000W 240V Ceiling/Wall

Garage Heater

OWNER’S MANUAL

Model No.: PH-9100WN

10000W 240V 60Hz

7500W 208V 60Hz

IMPORTANT INSTRUCTIONS

READ & SAVE

Technical support: 1-866-206-0888

Service email: info@mecanair.net

TABLE OF CONTENTS

Important Instructions……………………………………… 3

Specifications and Wiring Diagram………………………. 5

Parts of the heater ……………………….………………… 6

Installing Instructions……………………….……………… 7-10

Operating Instructions……………………….………….... 11

Maintenance and Cleaning………………………………. 12

Troubleshooting……………………………………………. 13

IMPORTANT INSTRUCTIONS

PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS

HEATER

NOTE: There may be a trace of smoke or odor when unit is first

operated. Don’t be alarmed. This indicates that a drop of oil fell on

the heating coil during the manufacturing process. It will quickly

evaporate and should not re-occur.

Make sure that the room in which the appliance is located is well

ventilated during this operation. It is normal for the appliance to emit

small cracking sounds when you turn it on for the first time. Do not

be alarmed.

WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS

SHOULD ALWAYS BE FOLLOWED TO REDUCE RISK OF FIRE,

ELECTRICAL SHOCK AND INJURY TO PERSONS OR PROPERTY,

INCLUDING THE FOLLOWING:

1) Read all instructions before using this heater.

2) This heater is hot when in use. To avoid burns, do not let bare skin touch

hot surfaces. Keep combustible materials, such as furniture, pillows, bedding,

papers, clothes, and curtains at least 3’ (0.9 m) from the front of the heater

and keep them away from the sides and rear.

3) Extreme caution is necessary when any heater is used by or near children

or invalids and whenever the heater is left operating and unattended.

4) Always switch off the heater when not in use.

5) Do not operate any heater after the heater malfunctions, has been

dropped or damaged in any manner. Disconnect power at service panel and

have heater inspected by a reputable electrician before reusing.

6) Do not use outdoors.

7) To disconnect heater, turn off power to heater circuit at main disconnect

panel.

8) Do not install less than 8 feet (2.4m) high from the floor and closer than 1

foot (0.3m) to any adjacent vertical surfaces or walls. Keep at least 4.5 inches

(11.5cm) from the back wall (with or without using the wall hanging mounting

bracket).

9) Do not insert or allow foreign objects to enter any ventilation or exhaust

opening as this may cause an electric shock or fire, or damage the heater.

10) To prevent a possible fire, do not block air intakes or exhaust in any

manner.

11) A heater has hot and arcing or sparking parts inside. To reduce the risk of

fire, do not use it in areas where gasoline, paint, or flammable vapors and

liquids are used or stored.

12) Use this heater only as described in this manual. Any other use not

recommended by the manufacturer may cause fire, electric shock, or injury to

persons.

13) This product must be installed by a certified electrician, in accordance

with local codes.

14) For supply cables, use 6 AWG (13.3 mm2) copper wires .

15) WARNING –RISK OF FIRE, DO NOT USE AS A RESIDENTIAL OR

HOUSEHOLD HEATER.

CAUTION –High temperature, risk of fire, keep electrical cords, drapery,

furnishings, and other combustibles at least 3 feet (0.9 m) from the front of the

heater and away from the side and rear.

PET OWNERS WARNING:

The health of some small pets including birds are extremely

sensitive to the fumes produced during the first-time use of many

appliances. These fumes are not harmful to humans but we

recommended that you do not use your heater around birds and

small pets during its initial use until the manufacturing corrosion

coatings burn off.

SAVE THESE INSTRUCTIONS

WARNING –RISK OF FIRE, DO NOT USE AS A RESIDENTIAL OR

HOUSEHOLD HEATER.

10,000W 240V Ceiling/Wall Garage Heater

Model : PH-9100WN

Voltage : 1-Phase 208 / 240 V

Watts: 7500 / 10000 W

Frequency: 60 Hz

Recommended Heating Capacity: 1.25 watts / ft3 (0.03m3)

Wiring diagram:

SPECIFICATIONS

A. Wall Mount Bracket

B. Ceiling Bracket

C. Upper Housing

D. Louver for air direction

E. Tilt adjustable knob

F. Down Housing

G. Front Exhaust Grill

H. ON/OFF Switch

PARTS OF THE HEATER

WARNING:All wiring must be installed by a certified electrician

according to the electrical safety.

The ceiling heater must be grounded in accordance with all national

and local building codes.

All Wiring procedures and connections shall be in accordance

with the national and local codes having jurisdiction.

Before installation:

Disconnect the main supply connection.

Supply cables shall be 6 AWG (13.3 mm2) copper wires.

The heater must be connected to individual branch circuit protected

by 60 Amp circuit breaker only.

Supply cables must be equipped with a dual pole circuit breaker

rating at least 240V 40A/pole as main cutoff switch of power

connection to the heater.

Wiring compartment for accommodating supply cables and pigtail

leads are adequate and measured free space of 2524.67 cm3.

CAUTION : High temperature, risk of fire, keep electrical cords,

drapery, furnishings, and other combustibles at least 3 feet (0.9 m)

from the front of the heater and away from the side and rear.

WARNING: To reduce the risk of fire, do not store or use gasoline

or other flammable vapors and liquids in the vicinity of the heater.

INSTALLATION INSTRUCTION:

1. Keep the unit at least 8 feet (2.4m) away from the floor. This

minimum distance must be maintained.

2. Do not install closer than1 foot (or 0.3 m) to any adjacent vertical

surfaces or walls.

3. Keep at least 4.5 inches (11.5cm) from the back wall (with or

without using the wall hanging mounting bracket).

4. Mark the drill-hole positions on the wall or ceiling for the

mounting bracket.

INSTALLING INSTRUCTIONS

5. Drill the required holes with diameter fit for the anchor provided

for positioning the mounting bracket.

6. Insert the anchors.

7. Attach the mounting bracket to the wall and secure with

mounting screws.

8. Loose the tilt adjustment knobs, remove the cart.

9. Align the Hang Bracket to the knob screw holes.

10. Re-insert the knob and tighten.

11. Hook the unit to the mounting bracket and let the unit hang from

the mounting bracket.

12. Insert the bolt provided through the mounting bracket and the

heater handle; tighten with the nut and washer.

Wall Mount

Ceiling Mount

13. Loosen the screw to remove the small cover in the rear of the

heater.

14. Run the electrical power supply cable in conduit.

15. Secure the conduit to the back plate via the knock-out hole.

16. Make the connections properly with connectors which are

suitable for the conductor size, in cluding grounding wirings.

Pull all the conductors from the conduit. Strip 3/4 inch of

insulation from each of the insulated conductors. Make a right

angle bend in the white insulated pigtail and place its stripped

end next to the stripped ends of the other white supply cable.

Make sure that the bare ends are tight together and square.

Using lineman's pliers, twist the bare ends tightly together in a

clockwise direction, then screw one of the wire nuts tightly on the

spliced conductors. Check to be sure that no bare copper shows

from beneath the wire nut. Repeat these steps for the black

conductor. Once the wire nuts are firmly in place, cover them with

Wall Mount

Ceiling Mount

plastic electrical tape. The grounding conductor is spliced in the

same manner.

17. And after making the connections, arrange the pigtail leads of

unit and power supply wires in the wiring compartment.

18. Replace the wiring cover and lock in place with the screw.

19. Consult NEC code for other types of approved electrical wire

splices & wire connectors.

Indice

Altri manuali ProFusion Stufa

ProFusion

ProFusion EH-4601 Manuale utente

ProFusion

ProFusion GD9315BC1-N Manuale utente

ProFusion

ProFusion HA24-50MB Manuale utente

ProFusion

ProFusion WH-50B Manuale utente

ProFusion

ProFusion HA24-75MB Manuale utente

ProFusion

ProFusion PH-935E Manuale utente

ProFusion

ProFusion HA22-48M Manuale utente

ProFusion

ProFusion TV15LR Manuale utente

ProFusion

ProFusion PH-9100WRN Manuale utente

ProFusion

ProFusion PH-931 Manuale utente

ProFusion

ProFusion H-4439 Manuale utente

ProFusion

ProFusion HA24-50E Manuale utente

ProFusion

ProFusion GD8110BP-M Manuale utente

ProFusion

ProFusion Salamander PS-10241P Manuale utente

ProFusion

ProFusion DQ1016A Manuale utente

ProFusion

ProFusion Ceiling mounted utility heater Manuale utente

ProFusion

ProFusion H-5511 Manuale utente

ProFusion

ProFusion PH-9100WS Manuale utente

ProFusion

ProFusion PH-960N Manuale utente

ProFusion

ProFusion HA11-20M Manuale utente

ProFusion

ProFusion HFU15-E Manuale utente

ProFusion

ProFusion PH-960 Manuale utente

ProFusion

ProFusion PS-10241 Manuale utente

ProFusion

ProFusion EH-4604 Manuale utente

Manuali Stufa popolari di altre marche

oventrop

oventrop Regucor Series Manuale utente

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuale utente

ELMEKO

ELMEKO ML 150 Manuale utente

BN Thermic

BN Thermic 830T Manuale utente

KING

KING K Series Guida

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guida rapida

Well Straler

Well Straler RC-16B Manuale utente

EUROM

EUROM 333299 Manuale utente

Heylo

Heylo K 170 Manuale utente

Eterna

Eterna TR70W Manuale utente

Clarke

Clarke GRH15 Manuale di istruzioni

IRSAP

IRSAP The Radiator Company Ovali Manuale utente

Empire Heating Systems

Empire Heating Systems WCC65 Manuale utente

Wetekom

Wetekom 92 86 43 Manuale utente

Desa

Desa SPC170-F Manuale utente

Watlow

Watlow Watrod Electric Tubular Heaters Manuale utente

Haverland

Haverland ECO-DRY GPS Series Manuale elenco delle parti

Stelpro

Stelpro ASILVC2060 Series Manuale utente