Now the upper line of your DC shows the current
temperature of your heating chamber. In the lower
line, it shows you the firing temperature that is set
for your kiln. Now your kiln is ready. Take the
switch to HEATER position and your kiln starts to
heat.
What is the function of the DISPLAY mode?
DISPLAY mode stops the heating of your kiln.In this
mode, you can see the current temperature inside
your firing chamber and your target temperature
and you can change your target temperature.To
start heating, you need to turn you switch to the
HEATER position.
To stop the heating process, take your switch to
the «OFF»position.The numbers on your DC will
disappear.
2
IMPORTANT INFORMATION
•If no action is taken for along time you’ll need to start
programing again by pressing to the MODE key.
•If you make amistake during any point of the programing, turn
your kiln off and on again to start over.
•Place your kiln on afire proof surface (ceramic, marble etc.)
with min.30 cm space in all sides.
•Use aheat resistant glove when loading and unloading your
kiln.
•When transporting, place your kiln back side down on the
vehicle.
