Prorack K053 Manuale utente

K053

Fitting Kit

EN Fitting Instructions for Basic Carrier

x 1 x 4

Revision No: 4C 1

Fitting Kit K053

MAX kgs (lbs)

W/P WHD

Subaru

Legacy Low Roof, 5dr Estate 89-93 EU 50 kgs (110 lbs) 50 kgs (110 lbs)

Legacy Low Roof, 5dr Wagon Oct 89-May 94 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)

Liberty Low Roof, 5dr Wagon Oct 89-May 94 AU 50 kgs (110 lbs) 50 kgs (110 lbs)

Fitting Kit EN

K053

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●This kit fits type A, B, C and D.

●These instructions show type A crossbar

fitted. They also apply to type B, C and D.

NOTE: Clamp images in these instructions may

not be representative of the clamps in this kit

Fitting Kit EN

K053

●Use keys to remove covers.

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment.

●Ensure each end of the crossbar is

adjusted equally.

Fitting Kit EN

K053

●Remove locking screw.

●Cut protective strip in four equal lengths.

●Apply protective strip as shown.

Trim if required.

●Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on

the vehicle (For example; "Front Right").

Fitting Kit EN

K053

●Refit locking screw so that it goes through

the hole in the clamp. Do not begin to

tighten the locking screw.

●Fit rubber pad (supplied with crossbar) to

foot.

●Make sure the pad fits into the holes

underneath the foot.

Fitting Kit EN

K053

Fitment

●Place crossbar on vehicle. Minimum

recommended spacing between the bars is

700mm (27 1/2") (unless otherwise stated).

●Adjust the legs on the crossbar so that they

are positioned equally from the ends of the

crossbar, and the clamps engage firmly on

the body work of the vehicle.

●Tighten adjusting screw to 5 Nm (3.7 ft lb).

Fitting Kit EN

K053

●Tighten locking screw on both legs evenly.

●Check crossbar is securely attached to the

vehicle.

●Use keys to fit and lock covers

Fitting Kit EN

K053

CAUTION: Recheck all fasteners immediately after

a load is applied to the crossbars.

Regularly check screws are tight.

Fitting Kit EN

K053

Maintenance

●Clean the car roof and surfaces of the

product that will be in contact with the car

roof.

●Follow the fitting instructions for fitting the

product to your vehicle. Make sure all steps

are carried out in order.

●Set crossbars a minimum distance of

700mm (27 1/2") apart where no other

distance is specified in the fitting

instructions. This is especially important

when carrying long loads.

●Check unit is securely attached whenever

you refit it to the vehicle. If the unit feels

loose, refer to the fitting instructions and

readjust.

●Some glass/panoramic roofs and radio

antennae may not be able to be used when

the product is fitted.

●Do not modify this product.

●Refer to the maximum permitted load

capacity specified in the fitting instructions.

Do not exceed the vehicle manufacturers

roof load rating if it is lower than the

maximum load capacity specified in the

fitting instructions.

●Loads should not overhang the sides of the

product and be evenly distributed with the

lowest possible centre of gravity.

●Long loads should be secured with non-

elastic straps to the front and rear of the

vehicle.

●Objects with pointed ends (e.g. ski poles)

should be carried with the pointed ends to

the rear of the vehicle.

●Remove all loose or removable objects

from the load prior to loading.

●Make sure all loads are securely fastened

with non-elastic straps. Check regularly

during longer journeys.

●A loaded roof rack system can alter the

performance of your vehicle. Be especially

aware of the effects of side winds,

changing of direction, and braking

performance. Avoid rapid acceleration and

deceleration. Drive carefully.

●Note that the total height of the vehicle

increases when upright loads are carried.

●Products should be locked during transport

if they have locks fitted.

Indice

Altri manuali Prorack Accessori per automobili

Prorack

Prorack K188 Manuale utente

Prorack

Prorack K069 Manuale utente

Prorack

Prorack K594 Manuale utente

Prorack

Prorack K504 Manuale utente

Prorack

Prorack K367 Manuale operativo e di installazione

Prorack

Prorack 8062003 Manuale utente

Prorack

Prorack K456 Manuale utente

Prorack

Prorack K991 Manuale utente

Prorack

Prorack K046 Manuale utente

Prorack

Prorack K563 Manuale operativo e di installazione

Prorack

Prorack K877 Manuale operativo e di installazione

Prorack

Prorack K832 Manuale operativo e di installazione

Prorack

Prorack K446W Manuale operativo e di installazione

Prorack

Prorack K528 Manuale utente

Prorack

Prorack PR3077 Manuale utente

Prorack

Prorack K765 Manuale operativo e di installazione

Prorack

Prorack K388 Manuale utente

Prorack

Prorack K143 Manuale utente

Prorack

Prorack K578 Manuale utente

Prorack

Prorack K1214 Manuale utente

Prorack

Prorack K381 Manuale utente

Prorack

Prorack K525 Manuale operativo e di installazione

Prorack

Prorack K774 Manuale utente

Prorack

Prorack K577W Manuale utente

Manuali Accessori per automobili popolari di altre marche

James Baroud

James Baroud Odyssey Manuale utente

Motorola

Motorola i50sx Manuale utente

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuale utente

Feniex

Feniex T3 Manuale utente

Renault

Renault 77 11 423 180 Manuale utente

Kia

Kia E8300-4D000 Manuale utente

Brink

Brink 756843 Manuale utente

Whispbar

Whispbar K085W Manuale utente

v.link

v.link CI-VL2-PC-HSD Manuale utente

Viking

Viking Stack-Rack Guida rapida alla configurazione

Aries

Aries 203015 Manuale utente

Choetech

Choetech AT0005 Manuale utente

ZZ2

ZZ2 ZZAIR-PRO Manuale utente

Holman

Holman 4A80L Manuale utente

Thule

Thule 2075 Manuale utente

Motorola

Motorola T325 Manuale utente

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guida all'installazione

DV8

DV8 FBJL-02 Manuale utente