Inallation
In mo gate controllers, the voltage required to power the switches, photocells and lighting
at the limits is available at the conneor. If the voltage is in the range of 9-25V DC or AC, it
should be used to power the Proxi Gate module. Any power polarity can be used.
When conneing output channel cables, the
conneor polarity given in the description
should be maintained. Depending on the
desired configuration, one or two Proxi Gate
module channels can be conneed.
Power supply conneion:
Conneion of the Proxi Gate
output channels:
Single channel control
Two channel control
The typical operation of a gate controller is
a sequence of “open-op-close” or “open-
-close”. To control the gate with one switch in
the mobile app, apart from the power supply,
two circuits should be conneed:
1. OUT1+ should be conneed to the appro-
priate input of the gate controller, usually
that for manual control or an additional
radio receiver.
2. OUT1- should be conneed to the Ground
of the gate controller, usually marked as
COM, GND or “-“.
The Proxi Gate module operation in two-
-channel mode is analogous to that of a
remote control with two buons.
To control two funions of the gate with
the help of two buons in the mobile app,
conne the power and the control circuits
as follows:
1. OUT1+ should be conneed to the appro-
priate input of the gate controller, usually
that for manual control or an additional
radio receiver.
2. OUT1- should be conneed to the Ground
of the gate controller, usually marked as
COM, GND or “-“.
3. OUT2+ should be conneed to the appro-
priate second input that controls the second
gate funion, usually the door funion
(partial opening), the funion of opening
with maintenance of the ate (the gate does
not close automatically), or other.
4. OUT2- should be conneed to the Ground
of the gate controller, usually marked as
COM, GND or “-“.
