Remember this vacuum has powerful suction and can pull fine dust out
of a carpet that other vacs may not have been able to do. This can
mean that fine dust will coat the inside of the filter bag effecting the
vacuum performance. It could takeaweek or two to get all the fine dust
out of commercial carpets.
5. If fine dust, like talc, cement/plaster or clay is picked up
the filter bag will be clogged
and reduce the suction. Therefore gently brush clean the inside of the filter bag after use
with a soft brush. Alternatively, on commercial sites useaspare vacuum cleaner to vacuum
the bag. However for the best results in this type of environment fit a paper bag inside the
Never wash the filter bag.
7. After use detach hose from the lid and clean around the outside of the swivel cuff
can be done by tilting and rotating detached cuff at the
vacuum inlet with vac switchedon.
Check hose, tubes, floor tool and lid regularly for blockages.
especially cuts. If damaged replace cord. See below under servicing.
9. Store unit upright on its base or hang by the carry handle. Always store cable as in Fig. 15.
wrap cable around the machine or behind the vac between the body and the
MOTORISED POWER FLOOR BRUSH
This unit may be fitted with a receptacle for a motorised power floor brush. Most power
heads can be adapted to this receptacle. See your supplier to ensure that the proper plug
andhose fittings are used.
Make sure this vacuum cleaner is serviced regularly. Frequency of service depends on use,
however carbon brushes must be checked the first time within 300 hours of use. Clean out or
replace internal foam insulation and replace cloth filter bag every 300 hours unless you are
using paper bags inside the cloth bag. Replace damaged cable with a 7.5 Amp2core cable.
1. Always empty the filter bag when full.
2. Make sure the bag support stand is in position at the bottom of the
canister under the filter bag (see Fig. 16).
be in position to maintain vacuuming performance. The secondary
filter disc must be on top of the bag support.
3. Check filter bag for holes or tears. Replace if torn or damaged.
Failure to do so could result in motor damage.
2. Unfasten Flaps on hip belt .
3. Loosen shoulder straps slightly. Slide pad off
shoulderand then off the other
grabbing the handle or lower the unit onto a table.
4. Unplug electric cord and wind the cord
starting from the machine
will help prevent the cable from
twisting and causing premature failure. When the cable is wound, place over
wrap cable around the machine or place between
the body and the carry handle. (
This vacuum cleaner is double insulated and is flame retardant for your safety and protection
However, a shock can occur if the electric cable is damaged. If the supply cable is damaged, it
must be replaced by the manufacturer or its agent or retailer to ensure the correct type of
approved cable is supplied in order to avoid a hazard.
DO NOT expose to rain and DO NOT pick up water or other liquids.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure they do not play with the appliance.
