Qeedji SMH300 Manuale utente
User Manual
SMH300
4.11.11 001C
1
Legal Notice
User Manual SMH300 4.11.11 (001C_en)
© 2019 INNESSA
Rights and Responsibilities
All rights reserved. No part of this manual may be reproduced in any form or by any means whatsoever without the written permission of the publisher. The products
and services mentioned in this document may be trademarks and/or trademarks of their respective owners. The publisher and the author do not pretend to these
brands.
Although every precaution has been taken in the preparation of this document, the publisher and the author assumes no responsibility for errors or omissions, or for
damages resulting from the use of the information contained in this document or the use of programs and source code who can accompany it. Under no circumstances
can the publisher and the author be held responsible for any loss of profits or any other commercial prejudice caused or that would have been caused directly or
indirectly by this document.
Product information
The conception and specifications of the product may change without prior notice, and this applies to hardware, embedded software and this guide. Consumable items
accessories may slightly differ than herein described as Qeedji is depending on the evolutions of its suppliers. This document contains confidential information; it can’t
be disclosed to any third parties without prior written authorization of INNES.
Safety instructions
Please read carefully the following instructions before switching the product on: - WARNING! Correct fitting and installation is of the utmost importance. Incorrect fitting
and/or installation may result in personal injury or loss. Qeedji disclaims all liability, of whatever kind, if the product is assembled, fitted and/or installed in an incorrect
manner. - Do not use the product near a water supply. - Do not pour anything on the product, like flammable liquids or material. - Do not expose the product to direct
sun, near a heating source or a dust nor vibrations. - Do not obstruct holes, to be sure that air flows freely around the product. - Switch off the product during a storm. -
Do not open the product in any circumstances.
Guarantee terms
Qeedji products are eligible for a warranty to cover genuine manufacturing defect for 3 years. Product failure occurring as the result of factors that do not constitute
genuine manufacturing defect are not covered under the terms of the warranty and any repairs of this nature would be chargeable. For example: Inappropriate
maintenance action, a non-authorized modification, a not specified environment utilization (see ‘Safety instructions’), or if the product has been damaged after an
impact, a fall, a bad manipulation or a storm consequence, an insufficient protection against heat, moisture or frost. This warranty is not transferrable. In addition, any
repairs carried out by non-authorized personnel will invalidate the warranty.
WEEE Directive
This symbol means that your end of life equipment must not be disposed of with household waste but must be deposited at a collection point for waste electrical and
electronic equipment or to your reseller. This will benefit the environment. In this context, a system for collecting and recycling has been implemented by the European
Union
2
1.1
1.2
1.3
1.4
1.4.1
1.4.2
1.4.3
1.5
1.6
1.7
1.8
1.9
1.10
1.11
Table of Contents
Introduction
Getting Started
Connectors
Configuration Web interface
SLATE configuration
SLATE pairing
SLATE system status
Configuration by script through USB
.ppk picture update on WebDAV directories
LEDs
Technical specifications
Troubleshooting
Conformities
Contacts
3
1.1 Introduction
This manual explains how to setup your device SMH300.
Recommendations and warnings
This device is designed to be used inside a building.
This device is intended to work with the supplied power supply unit. This power supply unit must be connected to a mains socket conforming to standard NF C 15-100. If
the AC power cable is damaged, it must be replaced. It is possible to order a replacement mains unit by sending a request to the email address [email protected].
This device is a Class A device. In a residential environment this device may cause radio interference. In this case, the user is asked to take appropriate measures.
When powering the unit from a PoE source, this PoE source must be "Limited Power Source" as defined in EN60950-1: 2006.
Content of the package
Items Functions
Device SMH300 with Gekkota embedded
1 power supply unit 12V Power Supply unit with cable of 1.2m
1 label PSN (Product Serial Number) on the packaging and on the device
1 WLAN antenna To be screwed on the dedicated WLAN locations (provided with the device when it is supporting the WLAN option)
1 WWAN antenna To be screwed on the dedicated WLAN locations (provided with the device when it is supporting the WWAN option)
4
Device fixture
The bottom of the smh300 if often fixed at 220 cm from the floor, oriented in the right sense, meaning cable output oriented towards the ceiling.
200
258
176
screws
6mm ≤ Ø ≤ 8mm
Ø ≤ 4mm
SMH300 DRILL PATTERN
Device dimensions
258 mm 35 mm
176 mm
Labelling
The model of the device, the power supply characteristics, the serial number (PSN) and the MAC address are written on a label which is stuck on the case. Some
additional tags may be present in case of built-in options.
☛ The serial number of the device can be requested in case of technical support.
00:1C:E6:02:2E:3D
Mac:
12VInput:
SMH300
5A rue Pierre Joseph Colin
35000 Rennes, FR
PSN00920-00036 CD4
www.qeedji.tech
600mA
3 7 0 0 5 6 8 1 0 6 2 4 0
SMH300
EAN
www.qeedji.tech
Device start-up step
6
Step 1 (T0=0s)
Device start-up initialisation
Step 2 (T~9s)
Device start-up finalisation
This phase duration is depending on some variable values
(like NTP), some network access duration or some data
checking (check-disk)
Step 3 (T~35s)
Nominal mode
During this step, the device has to play the content.
When firmware upgrade process occured, in
case DNS valid & NTP server inactive, it takes ~4
min 30 s.
>
7
1.3 Connectors pin-out
Power supply connector (12VDC-1.2A)
+
ST
PW
DC IN
LAN connector
Ethernet RJ-45 PoE. 10/100 BaseT. It is recommended to use shielded cables.
IR LAN
PoE
Jack 3.5mm connector (GPIO1)
321
IR LAN
PoE
N° Name Write/Read Control
1 Voltage reference 3.3V
2 GPIO1 IN or OUT CPU/GPIO1
3 Ground
Electrical features
Vin min Vin max VOH min VOL max VIH min VIL max
GPIO1 -0.5V 3.6V 2.9V 0.4V 2.0V 0.8V
The 3.3V pin must not be used as a power supply, but rather as a reference voltage.
During boot, the GPIO is configured in input during some seconds. And then after the system startup, the GPIOs is operational.
The GPIO has a weak pull-up.
It is not recommended to hotplug/unplug the GPIO1 connector, which could damage the device.
8
Three wires input configuration for GPIO1:
Two wires configuration for GPIO1:
Output configuration for GPIO1:
3.3V
CPU/GPIO1
SMA300
Switch
Input
2 (Jack)
3 (Jack)
1 (Jack)
PERIPHERAL
CPU/GPIO1
SMA300
Switch or dry loop
Input
2 (Jack)
3 (Jack)
PERIPHERAL
CPU/GPIO4
SMT210
Logic gate, transistor or opto-coupler
Output
Power supply
+-
2 (Jack)
3 (Jack)
PERIPHERAL
9
1.4 Device configuration Web interface
The device SMH300 supports a configuration Web interface. It is available with the URL:
http://<device_IP_addr>/.admin/
The supported Web browsers are : MS-Edge , Google Chrome and Mozilla Firefox .
The LAN factory configuration is the DHCP mode.
These are the main parameters:
Configuration > Administrator :
Login / password
Hostname ,
Identification method ,
Configuration > Network :
LAN : DHCP , static IP address , gateway address , subnet mask
WLAN : the menu is valid when the option WLAN is supported on your device
WWAN : the menu is valid when the option WWAN is supported on your device
Configuration > Servers :
PlugnCast G2 : allows the device to download an App from a remote WebDAV server. Once the App supporting the xpf compatibility is downloaded on the
device, its content is played immediately.
PlugnCast G3 : allows the device to download an App from a remote WebDAV server. Once the App is downloaded on the device, its content is played
immediately.
NTP ,
DNS ,
Proxy , ...
Configuration > License : allows to enter the device license.
Configuration > Date & time : allows to set the device Date & time and the time zone .
Configuration > Regionality : allows to set the language of the information messages or the error messages
English ,
Spanish ,
German ,
French .
SLATEs pairing : allows to associate some SMH300 devices to the SMH300 hub
Maintenance > TestCard : allows to activate/inactivate the configuration testcard. When the TestCard is activated, the content is not played.
Maintenance > Preferences : allows to edit and program the user preferences
Maintenance > Tools
Certificates : allows to load the certificates required to play some specific HTML page or to connect to WebDAV servers with the https scheme
⚠ It is highly recommended that your device SMH300 is on time. When it is possible, synchronize the time & date with a NTP server.
⚠ In case the device does not answer with its IP address, that means that either the device power supply is not plugged, or the Ethernet cable is not plugged, or
the network configuration is not properly set. To work around, if your computer and your local network are supporting the IPV6, you can even connect to the
device with the IPV6 address of your device, helped by your device MAC value written on the sticker at the back of the device, or showed when the TestCard is
activated.
For example, for the MAC address value: ``00-1c-e6-02-1e-45`,
in a Web browser, enter the URL: http://[fc00::21c:e6ff:fe02:1e45]/.admin/
For further information about IPV6, refer to the Network configuration recovery application note.
⚠ It is recommended to enter a unic Hostname for each device used on your locak network. When using several devices SMH300 spread on several buildings or on
several locations, it is recommended to enter Hostname values having a specific key word reminding the building and the location of the device (for exmaple: Hall-
RD-Paris-1 ). It is recommended to limit the hostname to 15 characters.
10
Altri manuali per SMH300
2
Indice
