Quantum QP-650 Manuale utente

QP-650

user manual

Quantun Electronics,LLC

Government law prohibits the operation of unlicensed radio

transmitters. Illegal operation is punishable by fine or imprisonment

Of both.

To avoid problem caused by electromagnetic interference and

electromagnetic compatibility, please turn off the transceiver at

the sites where you are required, such as hospital, airplane etc.

In the vehicle equipped with air bag safety, don't put the transceiver

within the scope of the air bag inflation.

Please turn off the transceiver before step into the inflammable

and explosive places.

Don't transmit for a long time, it may damage the transceiver or

it may cause scald.

Don't use the transceiver which antenna is damaged or else when

the exposed metal touch the skin, it may cause scald also.

Don't expose the transceiver to long periods of direct sunlight,

nor place it close to heating appliances.

If belt the transceiver on with belt clip, please notice that the distance

Between body and antenna should be more than 5cm when

transmitting.

If an abnormal odor or smoke is detected coming from the

transceiver, switch OFF the power immediately and remove the

optional battery pack from the transceiver. Contact our dealer

nearby.

NOTICES TO THE USER

We are grateful for you choice of Quantun transceiver.

This Professional two-way radio incorporates the

advanced technology and craft. You will be pleased

with the quality and features of our product. Please

read this manual carefully to ensure you know how

to property operate the radio before use.

THANK YOU

User Safety, Training, and General Information

READ THIS IMPORTANT INFORMATION ON SAFE AND

EFFICIENT OPERATION BEFORE USING YOUR

QUANTUN PORTABLE TWO-WAY RADIO.

Compliance with RF Energy Exposure Standards

Your Quantun two-way radio is designed and tested to comply with a number of national

and international standards and guidelines (listed below) regarding human exposure to

radio frequency electromagnetic energy. This radio complies with the IEEE (FCC) and

ICNIRP exposure limits for occupational/controlled RF exposure environment at duty

cycles of up to 50% talk-50% listen and should be used for occupational use only. In terms

of measuring RF energy for compliance with the FCC exposure guidelines, your radio

radiates measurable RF energy only while it is transmitting (during talking), not when it is

receiving (listening) or in standby mode.

Note: The approved batteries supplied with this radio are rated for a 5-5-90 duty cycle

(5% talk-5% listen-90% standby), even though this radio complies with the FCC

occupational RF exposure limits at duty cycles of up to 50% talk.

Your Quantun two-way radio complies with the following of RF energy exposure

standards and guidelines:

zUnited States Federal Communications Commission, Code of Federal Regulations;

47CFR part 2 sub-part J

zAmerican National Standards Institute (ANSI)/Institute of Electrical and Electronic

Engineers (IEEE) C95. 1-1992

zInstitute of Electrical and Electronic Engineers (IEEE) C95. 1-1999 Edition

zInternational Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998

zMinistry of Health (Canada) Safety Code 6. Limits of Human Exposure to Radio

Frequency Electromagnetic Fields in the Frequency Range from 3KHz to 300GHz,

1999

Operational Instructions and Training Guidelines

To ensure optimal performance and compliance with the occupational/controlled

environment RF energy exposure limits in the above standards and guidelines, users

should transmit no more than 50% of the time and always adhere to the following

procedures:

Transmit and Receive

To transmit (talk), push the Push-To-Talk (PTT) button; to receive, release the PTT button.

Hand-held radio operation

Hold the radio in a vertical position with the microphone one to two inches (2.5 to 5 cm)

away from the lips.

Body-worn operation

zAlways place the radio in a Quantun approved clip, holder, holster, case, or body

harness for this product. Use of non-Quantun-approved accessories may exceed

FCC RF exposure guidelines.

zIf you do not use a Quantun approved body-worn accessory and are not using the

radio in the intended use position in front of the face, then ensure the antenna and the

radio are kept one inch (2.5 cm) from the body when transmitting.

Antennas & Batteries

zUse only Quantun approved, supplied antenna or Quantun approved replacement

antenna. Unauthorized antennas, modifications, or attachments could damage the

radio and may violate FCC regulations.

zUse only Quantun approved, supplied batteries or Quantun approved replacement

batteries. Use of non-Quantun-approved batteries may exceed FCC RF exposure

guidelines.

Approved Accessories

For a list of Quantun approved accessories, see the accessories page of this user manual

or visit the following website which lists approved accessories: http://www.Quantun.com

FCC Compliance

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

zReorient or relocate the receiving antenna.

zIncrease the separation between the equipment and receiver.

zConnect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

zConsult the dealer or an experienced radio/TV technician for help.

Industry Canada Compliance

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numerique de la classe B est conforme à la norme NMB-003 Canada.

FCC Requirements

Your radio must be properly licensed by the Federal Communications Commission prior to

use. Your Quantun Wireless dealer can assist you in meeting these requirements. Your

dealer will program each radio with your authorized frequencies, signaling codes, etc.,

and will be there to meet your communications needs as your system expands.

Caution: 

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment. This device complies with part 15

of the FCC Rules. 

Operation is subject to the condition that this device does not cause harmful interference

CONTENTS

Unpacking and Checking Equipment

Supplied Accessories

Battery Pack information

Charging Notices

Charging Instructions

Care and cleaning

Accessories Installation

Installing and Removing the Battery Pack

Installing and Removing the Antenna

Installing and Removing the Belt Clip

Installing the Optional Mic. And Speaker

Radio Overview

Basic Operation

Switch On/Off

Adjusting Volume

Selecting Channel

Transmitting

Features

Battery Save

Low Battery Alert

Squelch Tail Elimination

Time-Out Timer [TOT]

Monitor

Priority Scan

Wired Clone

PC Programming

Selectable Squelch Level(0-9)

Busy Channel Lockout[BCL]

Programmable 12.5kHz/25kHz Channel Spacing

DTMF ANI Encode

CTCSS/DCS Signalling

Frequecy List

Troubleshooting

VOX operation

Channel Annunciation

Key function programmable

VOX

High/low power

Battery Information

Charging Notice

The battery is not charged at the factory, which can not reach its full

capacity for the first charging.After being charged and discharged

two or three times,it will get optimum.When the battery power is low,

it either needs to be charged or replaced by a new one.

Notices:

Do not short the battery terminals or throw the battery into the fire.

In order that the battery attached to the radio is fully charged, the

radio needs to be turned off.

Do not leave the battery or the radio with battery into the charger

if it needs not to be charged.Otherwise,the battery life will be

shortened.

Do not charge the battery whose power is high.Overcharging will

shorten the battery life.

Store the battery in a place about room temperature (25 ) if

possible.Charging the battery in temperature less than 10 may

cause electrolyte leakage and damage the battery.

Charging the battery in temperatures greater than 35 will affect

work of the battery and further affect the use of the radio.

Unpacking and Checking Equipment

Carefully unpack the transceiver. We recommend that you identify

the items listed in the following table before discarding the packing

material. If any items are missing or have been damaged during

shipment, please contact Sureave dealers immediately.

Supplied Accessories

ITEM QUANTITY

Antenna

Charger

Switch Power Supply

Li-ion battery pack

Belt Clip

Strap

Instruction Manual

Charging Instruction

Insert the battery or the radio with the battery into the charger,

and make sure than the battery connectors are in contact with

the charging terminals.The LED indicators glows red during

charging and green when the battery is fully charged.

Do not carry your radio by the antenna or remot microrhone;

Wipe the battery contacts with a lint-free cloth to re-move dirt,

grease,or other material that may prevent good electrical

connection;

When not in use,keep the accessory jacks covered with the

protective caps;

Clean the shell,controls and keys of your radio wyth neutral

detergent and warm water after a long period df usage.Avoid

using strong chemicals.

Care and Cleaning

LED INDICATOR CHARGING STATUS

Red Charging

Green Fuil Charge

Accessory lnstallation

Attaching the Battey

1.Turn off the radio.

2.Insert the tabs at the bottom of the battery intothe slots at the

bottom of the radio chassis.

3.Press the top of the battery towards the radio until a click is

heard.(See Figure 1)

Removing the Battery

1.Turn off the radio.

2.Push the battery latch on the back panel towards the top of the

radio.

3.Pull the top of the battery away from the radio chassis, and lift

the battery from the radiio.(See Figure2)

1.Align the grooves of the belt clip those of the battery.

2.Press the belt clip downwards until the belt clip tab locks.

(See Figure 4)

Note: attach the belt clip before installing the battery.

Removing the antenna

1.Turn the antenna counterclockwise until you can remove it.

(See Figure 3)

Attaching the Belt Clip

Figure1

Figure2

Attach Remove

Figure 3

Figure 4

Attaching the antenna

1. Align the threaded end of the antenna with the Radio’s antenna

connector.

2. Turn the antenna clockswise to tighten.(See Figure 3)

1.Remove the cover of earphone jack.

2.Rotate the cover until earphone jack comes into view.

Insert the earphone plug into the jack.(See Figure6)

1.Press the belt clip tab upwards until it releases.

2.Slide the belt clip upwards to remove it.(See Figure 5)

Note: remove the battery pack prior to removing the belt clip.

Removing the Belt Clip

Attaching External Earphone(Optional)

Radio Overview

Figure 5

Figure 6

Indice

Altri manuali Quantum Radio

Quantum

Quantum QM-790-V Manuale utente

Manuali Radio popolari di altre marche

EisSound

EisSound KBSound iSelect Manuale utente

Midland

Midland 1001LWX Manuale utente

Konig

Konig HAV-SR41 Manuale utente

Roberts

Roberts exprssion Manuale utente

VDigi

VDigi DD3.0 Manuale utente

Radio Shack

Radio Shack 21-1863 Manuale utente

Roberts

Roberts Stream 207 Manuale utente

Sony

Sony Walkman SRF-M97 Manuale utente

Stanley

Stanley FatMax FMC770 Manuale utente

auna

auna DAB-Radio 10026947 Manuale utente

SOUNDMASTER

SOUNDMASTER UR190 Manuale utente

HYT

HYT TC-320 Manuale utente

auna multimedia

auna multimedia Yellowstone 10026851 Manuale utente

B-Tech

B-Tech GMRS-V2 Manuale utente

Weierwei

Weierwei VEV-V8 Manuale utente

SOUNDMASTER

SOUNDMASTER DAB750 Manuale utente

Telefunken

Telefunken TF-1505 Manuale utente

Makita

Makita LXRM03 Manuale utente