Quatech SPPXP-100 Manuale utente
CONNECT WITH
RELIABILITY
QUATECH, INC.
5675 Hudson Industrial Parkway
Hudson, Ohio 44236-5012
Toll free: 1-800-553-1170
TEL: (330) 655-9000
FAX: (330) 655-9010
http://www.quatech.com.
SPPXP-100
User’s Manual P/N: 940-5001-100
Rev. 1.00 – Jul
y
2007
ExpressCard Parallel Port
Adapter User’s Manual
SPPXP-100
Copyright Copyright © 1998 - 2007, Quatech, Inc. All rights are reserved. The
information contained in this document cannot be reproduced in any form
without the written consent of Quatech, Inc. Any software programs that
might accompany this document can be used only in accordance with any
license agreement(s) between the purchaser and Quatech, Inc. Quatech
Inc. reserves the right to change this documentation or the product to
which it refers at any time and without notice.
Trademarks QUATECH® is a registered trademark of Quatech, Inc. Other product
and brand names listed in this manual may be trademarks of their
respective owners.
Disclaimer The information in this manual is believed to be accurate and reliable at
the time of posting. Notwithstanding the foregoing, Quatech assumes no
responsibility for any damage or loss resulting from the use of this
manual, and expressly disclaims any liability or damages for loss of data,
loss of use, and property damage of any kind, direct, incidental or
consequential, in regard to or arising out of the performance or form of
the materials presented herein or in any software program(s) that may
accompany this document.
Changes or modifications to this device not explicitly approved by
Quatech will void the user's authority to operate this device.
Feedback Quatech, Inc. encourages and appreciates feedback concerning this
document. Please send any written comments to the Technical Support
department at the address listed on the cover page of this manual.
Quatech ExpressCard Parallel Port Adapter User’s Manual Table of contents
Table of contents
Table of contents------------------------------------------------------------------------------------------------------------------ i
Figures ------------------------------------------------------------------------------------------------------------------------ ii
Introduction----------------------------------------------------------------------------------------------------------------------- 1
System requirements ----------------------------------------------------------------------------------------------------- 1
Installing the Parallel Port Adapter --------------------------------------------------------------------------------------- 2
Installing under Windows XP ------------------------------------------------------------------------------------------ 2
Uninstalling under Windows XP -------------------------------------------------------------------------------------- 6
Installing under Windows Vista--------------------------------------------------------------------------------------- 7
Uninstalling under Windows Vista----------------------------------------------------------------------------------11
Making external connections -----------------------------------------------------------------------------------------------12
Using Device Manager--------------------------------------------------------------------------------------------------------13
Accessing Device Manager ---------------------------------------------------------------------------------------------13
Exploring Device Manager screens ----------------------------------------------------------------------------------13
Windows XP / Vista -------------------------------------------------------------------------------------------------13
Troubleshooting-----------------------------------------------------------------------------------------------------------------18
Appendix A -----------------------------------------------------------------------------------------------------------------------19
Specifications---------------------------------------------------------------------------------------------------------------19
Warranty information ---------------------------------------------------------------------------------------------------20
Page i Rev 1.00 (July 2007)
Table of Contents Quatech ExpressCard Parallel Port Adapter User’s Manual
Figures
Figure 1 - Windows XP Found new hardware prompt.............................................................................. 2
Figure 2 - Windows XP Choose your installation options prompt............................................................ 3
Figure 3 - Windows XP “software has not passed Windows logo testing” prompt ................................ 4
Figure 4 - Windows XP “please wait” message......................................................................................... 5
Figure 5 - Windows XP Finished installing prompt.................................................................................. 5
Figure 6 - Device Manager.......................................................................................................................... 6
Figure 7 - Windows Vista "Found new hardware" prompt ....................................................................... 7
Figure 8 - "Windows needs your permission to use this program" prompt ............................................. 7
Figure 9 - Windows Vista "Insert the disc that came with your hardware" prompt............................... 8
Figure 10 - Windows Vista “Windows can’t verify the publisher of the driver software” prompt ........ 9
Figure 11 - Windows Vista “Installing driver software” message......................................................... 10
Figure 12 - Windows Vista "the software has been successfully installed" prompt............................. 10
Figure 13 - Device Manager...................................................................................................................... 11
Figure 14 - DB-25 female parallel port connector ................................................................................... 12
Figure 15 - Windows XP Device Manager - Adapter properties, General tab....................................... 14
Figure 16 - Windows XP Device Manager - Adapter properties, Port Settings tab .............................. 15
Figure 17 - Windows XP Device Manager - Adapter properties, Driver tab ......................................... 16
Figure 18 - Windows XP Device manager - Adapter properties, Driver file details box....................... 17
Page ii Rev 1.00 (July 2007)
Quatech ExpressCard Parallel Port Adapter User’s Manual Introduction
Introduction
This User’s Manual describes how to setup and install your Quatech
Parallel Port Adapter.
The Quatech SPPXP-100 provides one parallel port to the host PC via
the ExpressCard port.
The adapter is a Plug-and-Play device and requires no hardware
configuration.
System requirements
Quatech Parallel Port Adapters are supported under the Windows XP
(and later) operating systems. All device drivers are available for
download from the Quatech World Wide Web site at
http://www.quatech.com/.
Rev 1.00 (July 2007) Page 1
Installing the software Quatech ExpressCard Parallel Port Adapter User’s Manual
Installing the Parallel Port Adapter
This section explains how to install the Parallel Port Adapter under
different operating systems. Please locate and follow the procedure
for your computer’s operating system.
Caution! Be sure to allow
the installation process to
finish without interruption. The Parallel Port Adapter uses the Windows system-supplied parallel
drivers that enables the port to appear to Windows as a standard
LPT port.
Installing under Windows XP
Follow these steps to install the adapter under Windows XP.
Step Procedure Description
Step 1 Turn on the power to your computer
system.
This is the system in which the device is to
be installed.
Step 2 Plug the ExpressCard into an available
ExpressCard slot on the computer.
Windows tells you that it has found new
hardware and launches the Found New
Hardware Wizard.
Figure 1 - Windows XP Found new hardware prompt
Step Procedure Description
Step 3 When the “welcome to the found new
hardware wizard” appears, select the “No,
not this time” option
Please do NOT allow Windows Update
to search for the software on the internet.
Step 4 Click the Next button Windows will continue to the next step.
Figure 1 illustrates the
Windows XP Found new
hardware prompt. The Found
New Hardware Wizard
launches automatically when
you first plug in the Parallel
Port Adapter.
Page 2 Rev 1.00 (July 2007)
Quatech ExpressCard Parallel Port Adapter User’s Manual Installing the software
Figure 2 - Windows XP Choose your installation options prompt
Procedure Description
Step 5 Insert the Quatech installation CD into
your CD-ROM drive.
This is the CD that shipped with the
product.
Step 6 Select the “install automatically
(Recommended)” option.
The installation options prompt
displays.
Step 7 Click the Next button. Windows searches for drivers for the
adapter.
Rev 1.00 (July 2007) Page 3
Installing the software Quatech ExpressCard Parallel Port Adapter User’s Manual
Figure 3 - Windows XP “software has not passed Windows logo testing” prompt
Step Procedure Description
Step 8 In the case of a new unsigned driver, the
“software has not passed Windows logo
testing” prompt will appear. Please click
the [Continue Anyway] button to continue
with the installation.
Windows displays a warning prompt if
the software drivers are not signed with
the Windows logo. New drivers have
been tested at our lab facilities, but may
not yet have received the official logo
from Microsoft.
Step 9 The Wizard locates and starts to install
the necessary software.
The “wait while the Wizard installs the
software” prompt displays (fig.4),
followed by the “Finished installing”
prompt (fig.5).
Figure 3 illustrates the
“software has not passed
Windows logo testing” prompt.
This prompt will only appear
in the case of a new unsigned
driver.
Page 4 Rev 1.00 (July 2007)
Quatech ExpressCard Parallel Port Adapter User’s Manual Installing the software
Figure 4 - Windows XP “please wait” message
Figure 5 - Windows XP Finished installing prompt
Step Procedure Description
Step 10 Press the Finish button to continue. The ExpressCard Adapter installation is
complete.
Rev 1.00 (July 2007) Page 5
Installing the software Quatech ExpressCard Parallel Port Adapter User’s Manual
Uninstalling under Windows XP
Follow these steps in the event that you need to uninstall or reinstall
the Parallel Port software.
1. From the Control Panel, select System.
2. Press the Hardware tab.
3. Click on Device Manager.
Figure 6 - Device Manager
4. Scroll down to PORTS and expand.
5. Highlight your Quatech Parallel Port Adapter; for example,
Quatech SPPXP-100 ExpressCard IEEE-1284 Parallel Adapter
(LPT3)
6. Select the Action menu option.
7. Select Uninstall from the drop down menu.
8. Click OK at the Confirmation screen. Note that this also removes
the parallel port associated with your Parallel Port Adapter.
Page 6 Rev 1.00 (July 2007)
Indice
Altri manuali Quatech Adattatore
Quatech
Quatech SSP-100 Manuale utente
Quatech
Quatech SS-USB-100 Manuale utente
Quatech
Quatech DSC-100 Manuale utente
Quatech
Quatech QSP-100 Manuale utente
Quatech
Quatech MPAP-200 Manuale utente
Quatech
Quatech SSU2-100 Manuale utente
Quatech
Quatech DSCLP-200 Manuale utente
Quatech
Quatech PCD-X/U142-E Manuale utente
Quatech
Quatech SS-BLT-100 Manuale utente
Quatech
Quatech SS-BLT-100 Manuale utente
Quatech
Quatech SS-BLT-100 Manuale utente
Quatech
Quatech QSCLP-200 Manuale utente
Quatech
Quatech DSU2-100 Manuale utente
Quatech
Quatech Audio/Video Capture USB 2.0 Manuale utente
Quatech
Quatech PCD-X/U132-E Manuale utente
Quatech
Quatech DSC-300 Manuale utente
Quatech
Quatech RS-485 Manuale utente
Quatech
Quatech QSP-200/300 Manuale utente
Quatech
Quatech Asynchronous Communications Adapter... Manuale utente
Quatech
Quatech DSU2-100 Manuale utente
