Rath SmartPhone VI Guida rapida

Wiring Diagrams: 24vac/dc Models

Direct 24vac/dc Powered

120vac to 24vac/dc Powered

Black

Hot Green

Ground

White

Neutral

120vac

1. Connect your annunciator’s audio output to the TB1 connection

on this board.

2. When utilizing this board to drive a 24v LED, you must apply

power to the wire leads at the TB2 connection. You may tap into

a direct 24vdc supply that has battery backup. Connect the wire

leads at the J5 connection to your LED.

3. If you are not utilizing this board to drive a 24v LED, you need

to disconnect the LED harness from the SmartPhone board,

disconnect the LED harness from this board, connect it to the

SmartPhone board, and then wire to your standard LED.

4. If you want to activate Relay 2 in unison with Alarm Relay on

SmartPhone board, follow these programming steps (default

activates upon call out):

a. Press ENTER

b. Press 3, 0, ENTER, 4

c. Press STOP for 3 seconds

To 24vac/dc

Power Supply

To Phone Line:

Requires a twisted

shielded pair.

When used with

SmartRescue,

requires two

twisted shielded

pairs.

To Phone Line:

Requires a twisted

shielded pair.

When used with

SmartRescue,

requires two

twisted shielded

pairs.

Note:

If Elevator

Communications

Failure is required,

connect to our

Alarm Relay *

RP8200950

Ver. 9

09/19

Annunciator Interface,

Auxiliary Relay & 24v LED Board

To Speaker

Relay 1

Relay 2

To H1 on SP VI To Speaker connection

on SP VI Circuit Board

To Audio output

of Annunciator

To LED on SPVI

24v LED 24vdc Power for LED

TB2

- + - +

- + J3

TB1 AUX1

AUX2

COM

Relay Alarm

LED Switch

MIC Speaker

Bat

24vac/dc

RJ11

1 2 3

4 5 6

7 8 9

0 #

Enter

Record

Play/Pause

Stop

RJ11

Relay Alarm

LED Switch

MIC Speaker

Bat

RJ11

1 2 3

4 5 6

7 8 9

0 #

Enter

Record

Play/Pause

Stop

RJ11

Note:

If Elevator

Communications

Failure is required,

connect to our

Alarm Relay *

24v

RP7300144-24/5VA

Troubleshooting & Diagrams

SmartPhone VI

N56W24720 N. Corporate Circle • Sussex, WI 53089

800-451-1460 • www.rathcommunications.com

MADE IN THE USA

3 YEAR WARRANTY

Initial Set-Up:

Troubleshooting:

Wiring Diagrams: 12vac/dc Models:

Direct 12vac/dc Powered 120vac to 12vac/dc Powered

Note: If Elevator Communications Failure is

required, connect to our Alarm Relay.

To 12vac/dc

Power Supply

To Phone Line:

Requires a twisted

shielded pair.

When used with

SmartRescue,

requires two

twisted shielded

pairs.

To Phone Line:

Requires a twisted

shielded pair.

When used with

SmartRescue,

requires two

twisted shielded

pairs.

1. Diagnostic Test: Press Enter, 2, 6, Play/Pause phone will play back (5) Beeps (1st Beep=External Power Supply; 2nd

Beep=LED; 3rd Beep=Microphone; 4th Beep=Speaker; 5th Beep=Backup Battery). If any item fails during test you will hear

a Blat not a Beep. If you hear a Blat, contact RATH® Technical Support.

Note: If you receive a Blat for the LED, check the LED operation to be sure it is not working before contacting RATH® Technical Support.

2. Connect to standard RJ11 phone jack. If splicing connection, only hook up Red and Green Wires from the phone cable. If

connecting to a SmartRescue unit, you must connect all four wires (check for 24vdc or 48vdc supply at the splice).

1. If the phone dials only one digit and hangs up, there is another Auto-Dialer on the line. You need to re-wire the system so

that the RATH® unit is either in parallel or ahead of it.

2. If the phone dials a couple of digits and gets a busy signal, the unit is installed on a switchboard line and needs to be

programmed to dial the appropriate access code to get an outside line (usually an 8 or 9).

3. If the phone does not respond, make sure the green LED (D1) on the circuit board is lit. If not, check to be sure the power is

properly connected.

4. If the phone is making phantom calls, it is installed on a Ring Down Line. You must turn off the “Telephone Line Check”

feature (see Optional Programming Instructions).

RP8200950

Ver. 9

09/19

Relay Alarm

LED Switch

MIC Speaker

Bat

12vac/dc

RJ11

1 2 3

4 5 6

7 8 9

0 #

Enter

Record

Play/Pause

Stop

RJ11

Relay Alarm

LED Switch

MIC Speaker

Bat

RJ11

1 2 3

4 5 6

7 8 9

0 #

Enter

Record

Play/Pause

Stop

Transformer

12v

RJ11

White/Neutral

To 120vac

Black/Hot

Troubleshooting & Diagrams

SmartPhone VI

N56W24720 N. Corporate Circle • Sussex, WI 53089

800-451-1460 • www.rathcommunications.com

MADE IN THE USA

3 YEAR WARRANTY

Altri manuali per SmartPhone VI

Altri manuali Rath Telefono di emergenza

Rath

Rath 2100-TPL Landline 120v Tower Manuale utente

Rath

Rath Multi-Line Command Center Manuale utente

Rath

Rath 2100-986DA Manuale utente

Rath

Rath 2100-986VAI Manuale utente

Rath

Rath Dusk2Dawn 2100-CD9 Series Manuale utente

Rath

Rath 2100-986GSM Manuale utente

Rath

Rath 2100-PPL Manuale utente

Rath

Rath 2100-CL9 Manuale utente

Rath

Rath 2100-CP9 Manuale utente

Rath

Rath SmartRescue 5 Manuale utente

Rath

Rath 2100-CPV Manuale utente

Rath

Rath 2100-CPL Manuale utente

Rath

Rath 2100-TLL Landline 12v Tower Manuale utente

Rath

Rath 2100-CPL Manuale utente

Rath

Rath 2100-PLL Landline 12v Pedestal Manuale utente

Rath

Rath 2500-205D Manuale utente

Rath

Rath 2100-ELL2 Manuale utente

Rath

Rath 2100-EPV2 VoIP Manuale utente

Rath

Rath 2100-CDC Manuale utente

Rath

Rath 2100-CD9 Manuale utente

Rath

Rath 2100-CSL Manuale utente

Rath

Rath 2100-CS9 Manuale utente

Rath

Rath 2100-TL9 Manuale utente

Rath

Rath 2100-PL9 900 MHz 12v Pedestal Manuale utente

Manuali Telefono di emergenza popolari di altre marche

Dosch&Amand

Dosch&Amand DA1450 Manuale utente

Viking

Viking E-1600A series Istruzioni per l'installazione e il funzionamento

LogicMark

LogicMark GUARDIAN ALERT 911 Manuale utente

Wind n Go

Wind n Go 7700 Manuale utente

Wind Crest

Wind Crest ILO1 Manuale utente

Bell System

Bell System Master 200Plus Manuale utente

Linear

Linear PERS-3600 Istruzioni per l'installazione

ooma

ooma Safety Phone 700-0129-203 Manuale utente

CareTech

CareTech Gina Manuale utente

Paso

Paso PA8506-V Manuale utente

JNY Safetycare

JNY Safetycare FDC Manuale utente

Eldat

Eldat Easywave Fon Alarm Manuale utente

Merak

Merak MMk-656 Manuale utente

Assistive Technology Services

Assistive Technology Services TOUCH N TALK FD Istruzioni per il montaggio

Great Arnoldi

Great Arnoldi Just in Case Manuale utente

Disty

Disty Notruf Manuale utente

Prime

Prime PR100 Manuale utente

Rocom

Rocom EC II GSM SE Manuale utente