Technical Data：
Suitable for different kinds of projector
VESA standard: Unlimited
The tle angle can be freely adjusted
The complete set of installaon
screws are included
Maximum loading: 18KGS
Material: SPCC
Color: Black.
Product Height: 135mm
* Note: the projector you are installing may differ in appearance from the sample illustrated below.
Place projector upside down. Locate Product Assembly (A) with Universal Plate facing forward as
close to projector center of gravity as possible without covering any mounng holes Loosen
Extension Bracket, and if there are only three mounng holes remove fourth Extension Bracket.
Using one Extension Bracket for each mounng hole posion Extension Bracket,boom washer
(D) and washers (E, G) over mounng holes as shown in fig 1
Important: if projector dose not have at least three mounng holes, do not use this adapter plate
*Note: Some projectors have feet, which can be removed, and the corresponding threaded insert
can be used for a mounng hole.
*Note: Once Extension Bracket are in posion reghten fasteners.
*Aach Product Assembly (A) to projector using one screw (B,C) for each channel as shown in fig2.
Tighten all screws, while keeping the center of gravity. Be sure that Prodect Assembly (A) is
straight. Tighten all screws with Phillips screwdriver, while keeping the center of gravity.
*Note: Projectors will require different size screws for mounng. Use a suitable screws (B,C) and
Washers (E, F, G) that will result in Extension Bracket of Product Assembly (AA) fing ghtly
against projector. Important : In order to properly engage the threads in the mounng holes,
the screw must be turned at least 3full turns. Cauon: it is the responsibility of the installer to
ensure that the projector is properly verlated.
Item Description Qty.
Parts List
A
B
C
D
E
F
G
H
I
J
K
Product Assembly
Truss Head Screw M4x25
Button Head Cap Screw
Truss Head Screw M6x25
Bottom washer
1mm washer
2mm washer
3mm washer
Square Nut
Tighten tool
Tighten tool
Extens on Bracket 1
Extens on Bracket 2
1
4
4
3
4
4
4
4
1
1
2
Fig 1
Fig 2
Installation tools (not included)
Electric drill 8mm-dril
Hammer Screwdriver
-20°
/
+20°
60°
MODEL NO. RPJM030
UNIVERSAL PROJECTOR CEILING AND TABLE MOUNT
INSTRUTION MANUAL
PLEASE READ BEFORE OPERATING THIS EQUIPMENT
This product is manufactured and sold by Curtis International Ltd.
RCA, the RCA logo, the two dogs (Nipper and Chipper) logo, are registered
trademarks or trademarks of RCA TrademarkManagement and are used
under license by Curtis International Ltd. Any other product, service,
company, trade or product name and logo referenced herein are neither
endorsed nor sponsored by RCA Trademark Management or its affiliates.
For service assistance and product information, please call: 1-800-968-9853.
Curtis International Ltd.
7045 BECKETT DRIVE, UNIT 15,
MISSISSAUGA, ON, L5S 2A3 www.curtisint.com
A1
4
1
L
L2
IJ
B
A
