Reflecta IMAGEBOX Manuale utente
PACKAGE CONTENT
ImageBox Scanner Unit
Printed Quick Installation Guide
USB 2.0 cable
Software DVD-ROM
(Cyberview CS Scanner Driver and Adobe Photoshop Elements 5.0 included)
Media Holders – 1 for film strip, 1- for mounted slides, 1 for photo prints
(Additional holders available for purchase) 4
5
2
1
3
PARTS OF THE SCANNER
1Power Status LED - This LED indicates whether
the scanner is powered on/off, it also indicates
the scan mode selected Photo for prints or
Film/Slide for negative or slide media
2Scan button
3Film/Slide Holder insertion slot
4Photo Holder insertion slot
5USB 2.0 Connecter
h
The USB interface cable connects here.
hFilm/Slide Holder exit door
1
INSTALLING THE SOFTWARE
STEP #1 Install the Adobe Photoshop Elements.
Insert the DVD and follow the onscreen prompts to install. When prompted to enter the serial
number, please refer to the Serial Number sticker on the DVD envelope that the DVD disc came
in.
STEP #2: Install the Cyberview CS Driver.
Follow the onscreen prompts to complete the installation, and reboot the PC when prompted to
do so.
Note: If your PC does not have the version Direct X needed it will be installed first.
STEP #3:
Once the system has fully rebooted, connect the device to a live USB port (hubs are not
supported). You will see a message about Found New Hardware, click on Locate and install
driver software.
2
The following progress screens will appear
Click close, your hardware is installed and ready to use.
3
PLACING PHOTOS IN THE HOLDER
Holder for photo print:
To place photo on the holders, release the 2 magnetic strips.
These holders keep photo in place for scanning, you can slide them inward to hold smaller than 4
x 6 inches photos.
To remove photo once scanned, release the 2 magnetic strips holding it in place.
4
Once the photo is inserted and locked in place via the 2 magnetic strips, place the holder into the
slot at the back of the unit
Once the Photo is loaded, SEE USING THE SCANNER page 8of this manual to begin
5
PLACE FILM STRIP IN THE HOLDER
Holder for 35mm film strips:
PLACE SLIDES IN THE HOLDER
Holder for 35mm Slides:
Insert slides with the top facing up so that you can see the entire image visible in the holder,
regardless of the orientation in which the picture was taken. Please note that improper insertion
will cut off the top of the image. Also insert film and slides shiny side away from you opposite of
the numbers on the film holders (shiny side facing back of the unit)
6
INSERT HOLDERS IN THE SCANNER
Holders must be inserted from the right only and removed from the left. Please make sure that
the numbers are on top.
Once the film/Slides are loaded,SEE USING THE SCANNER page 8of this manual to begin
7
USING THE SCANNER
SCANNING INTO THE APPLICATION SOFTWARE
– Save and Organize option
Open the Adobe Photoshop Elements by going to
Start - All
Programs – Adobe Photoshop Elements
.
Once the welcome screen appears select the View
and
Organize Photos
option.
Click on
File
-
Get Photos
and Videos From
Scanner
–Select
Cyberview CS
– ImageBox select
your JPEG compression quality.
8
The higher the number is, the less compression
is being used, which results in larger JPEG files.
If you desire smaller file size, please set the
number to medium or low.
Keep in mind that anything below medium is
generally not good for printing quality images.
Make sure the unit is empty when calibration
page pops up.
Next a calibration message will appear, make
sure the photo holder is empty and there is no
film/Slide holder inserted then Click OK to
calibrate the unit.
9
Once Calibration is completed, the scanning interface
will open.
Please note this calibration screen only appears on
the first use after driver has been installed, after that
manual calibration may be selected on the tool bar by
clicking on the “Calibrate button” when images appear
to be too dark or look strange
Continued on page 12
10
Indice
Altri manuali Reflecta Scanner
Reflecta
Reflecta x10-Scan Manuale utente
Reflecta
Reflecta X120 Manuale utente
Reflecta
Reflecta X33-Scan Manuale utente
Reflecta
Reflecta x66-Scan Manuale utente
Reflecta
Reflecta x7-scan Manuale utente
Reflecta
Reflecta Docking Scanner Manuale utente
Reflecta
Reflecta X1-Scan Manuale utente
Reflecta
Reflecta CyberView X5 MF Manuale utente
Reflecta
Reflecta 64220 Manuale utente
Reflecta
Reflecta xScan Film Scanner Manuale utente
Reflecta
Reflecta Combo Album SCAN 64400 Manuale utente
Reflecta
Reflecta Combo Album Scanner Manuale utente
Reflecta
Reflecta CyberView X5 MF Manuale utente
Reflecta
Reflecta X120 Manuale utente
Reflecta
Reflecta RPS 10M Manuale utente
Reflecta
Reflecta x10-Scan Manuale utente
Reflecta
Reflecta x11-Scan Manuale utente
Reflecta
Reflecta Super 8 Manuale utente
Reflecta
Reflecta ProScan 10T Manuale utente
Reflecta
Reflecta x22-Scan Manuale utente
