Rega Ear Manuale utente
--
CONNECTIVITY
METHOD 1
Used in-between the Record output on the amplifier and the chosen connected device.
The Ear will amplify any signal fed to the output sockets.
Connect the two sockets on the back marked INPUT (Red = Right, Black = Left) to the
amplifier output sockets. The two sockets on the back marked LINK (Red = Right, Black
= Left) are connected to the input (record) sockets on the recording device. The mute
on the front panel will mute the signal to the chosen device. The volume control on the
amplifier will not affect the volume level of the headphones; use the volume control on
the Ear to adjust the level of the headphones.
METHOD 2
The Ear can act as a stand alone amplifier that will amplify any signal fed into the input
sockets.
Connect the two sockets on the back marked INPUT (Red = Right, Black = Left) to the
source output sockets (CD, Tuner or other digital device). The sockets on the back
marked LINK (Red = Right, Black = Left) could be used to feed the signal to another
amplifier if required. The volume control on the Ear may be used to adjust the level of
the headphones.
When connecting a digital source such as CD, DVD or DAC, these devices generally output
higher signal than a standard line level. This apparent increase can be easily adjusted via
the volume control.
In the standalone mode ( ETHOD 2) where the ear is not required to feed a signal to
another amplifier, the LINK sockets can be used as an input, this means it is possible to
mute the EAR headphone signal by using the mute control on the front of the EAR.
METHOD 3
When using an integrated amplifier with pre-amplifier output and power amplifier input
sockets, the EAR will be connected between the pre-amplifier output and power amplifier
input sockets on the integrated amplifier, the Ear will amplify any signal fed to the pre-
amplifier output sockets of an amplifier. The volume on the amplifier will control the
headphone level and the main speakers can be muted via the Ear.
Connect the two sockets on the back marked INPUT (Red = Right, Black = Left) to the
pre-amplifier output sockets on the back of the main amplifier. The two sockets on the
back marked LINK (Red = Right, Black = Left) are connected to the power amplifier input
sockets on the back of the main amplifier.
The mute on the front panel of the Ear will mute the signal to the speakers connected to
the main amplifier. The volume control on the amplifier and the volume control on the Ear
will affect the volume level of the headphones. The best setting for the Ear volume
Rega Research Ltd, exceptional Hi-Fi designed and made in ENGLAND.
control is where the level of the headphones is the same as that of the main speakers
(the volume level on the Ear should be approximately 12:00 hours on the dial).
METHOD 4
When using seperate pre amplifier and power amplifier combination, you may use the Ear
in-between a pre-amplifier output and power amplifier input, the Ear will amplify any
signal fed to a pre-amplifier output and the link will feed the required power amplifier.
The volume control on the pre-amplifier will control the headphone level and the main
speakers can be muted via the Ear.
Connect the two sockets on the back marked INPUT (Red = Right, Black = Left) to the pre-
amplifier output sockets on the back of the pre-amplifier. The two sockets on the back
marked LINK (Red = Right, Black = Left) are connected to the input sockets on the back
of the power amplifier.
The mute on the front panel of the ear will mute the signal to the speakers connected to
the power amplifier. The volume control on the pre-amplifier and the volume control on
the Ear will affect the volume level of the headphones. The best setting for the Ear volume
control is where the level of the headphones is the same as that of the main speakers
(the volume level on the Ear should be approximately 12:00 hours on the dial).
To prevent possible hearing damage, do not listen at high volume for long periods.
EAR SPECIFICATIONS
aximum output level and required input sensitivity
25Ω load = 775mW, input sensitivity = 175mV
32Ω load = 685mW, input sensitivity = 185mV
50Ω load = 530mW, input sensitivity = 205mV
100Ω load = 320mW, input sensitivity = 225mV
600Ω load = 60mW, input sensitivity = 235mV
Open circuit voltage (no load) = 6V, input sensitivity = 240mV
Output impedance = 0.175Ω / Input impedance = 20KΩ / Gain = 28dB
Frequency response 12Hz to 37KHz (-0.5dB points)
THD = typically 0.003% (1dB below clip into 100Ω)
Signal to noise ratio referenced to maximum output level = -100dB (22Hz – 22KHz)
aximum Power requirements 24VAC at 225mA (685mW 32Ω)
POWER SUPPLY SPECIFICATIONS
PS1 UK
Input.............................................................................................230V ~ 50Hz 0.05A
Output..............................................................................................24V ~ 300 A AC
PS1 EU (Euro 2 pin)
Input.............................................................................................230V ~ 50Hz 0.05A
Output..............................................................................................24V ~ 300 A AC
PS1 UL (A erican)
Input..........................................................................................................115V~60Hz
Output..............................................................................................24V ~ 300 A AC
Headphone Amplifier
Ear
Indice
Altri manuali Rega Amplificatore
Rega
Rega io MK1 Manuale utente
Rega
Rega io MK1 Manuale utente
Rega
Rega Mira 3 Manuale utente
Rega
Rega Exon Manuale utente
Rega
Rega FONO MINI A2D MK2 Manuale utente
Rega
Rega Aura Manuale utente
Rega
Rega AETHOS Manuale utente
Rega
Rega Ios Manuale utente
Rega
Rega Elex-R Manuale utente
Rega
Rega Ear Headphone Manuale utente
Rega
Rega Brio-R Manuale utente
Rega
Rega Radio Mk 3 Manuale utente
Rega
Rega IO Manuale utente
Rega
Rega fono mini A2D Manuale utente
Rega
Rega Brio-R Manuale utente
Rega
Rega ELEX MK4 Manuale utente
Rega
Rega ELICIT MK5 Manuale utente
Rega
Rega Brio 3 Manuale utente
Rega
Rega Brio Integrated Amplifier Manuale utente
Rega
Rega Osiris Manuale utente
