Reliant RXGD-7 Manuale utente
1
Countertop Display Refrigerators
Models: RXGD-7 RXGD-5
PLEASE READ THE MANUAL THOROUGHLY PRIOR TO
EQUIPMENT SET-UP, OPERATION AND MAINTENANCE.
THIS EQUIPMENT SHOULD BE PUT INTO USE FOR ITS
INTENDED PURPOSE AS DESCRIBED IN THIS MANUAL.
PRODUCT USAGE
This appliance belongs to Display Refrigerator series designed to storage and display bottle beverage.
Notice: Users shall put the unit into use for its intended purpose, or they should completely take the
consequences that may occur.
INSPECTION BEFORE INSTALLATION
Before installing your equipment, please do carefully inspect it for any possible shipping damage.
If any damage is detected when unloading or uncrating your unit, please le a claim with the
transportation company as quickly as possible.
Notice: Manufacturer takesnoresponsibilityfor shipping loss or damage.
SAFETY INSTRUCTIONS
Particular Safety Precautions
Flammable and explosive refrigerant (Hydro-carbon R290) is used in the unit. The following Particular
Safety Precautions should be strictly enforced due to the use of R290 refrigerant.
• Leave enough space from the wall to the cabinet and the ceiling. Do not be sealed completely in the
back part of the cabinet, prepare an air vent to the outside.
Caution: It needs more than 8 inches from the cabinet to wall.
• Please move away all out-package for bottom heat radiation to avoid re.
• It’s prohibited to store ammable and volatile chemical, or leading to exploding.
• Individual single-phase socket must be used. It should be reliably connected to a grounding wire.
Caution: Do not connect grounding wire to a water or gas pipe.
• Do not be hard collided or ercely vibrated when in transportation. It is not larger than 45° for the
inclination of the cabinet.
• Please refer to the Trouble Shooting references when the unit is facing some problems. Do not
attempt to solve the problem on your own. Please refer to certied technician only.
For complete specications on all Reliant products, please visit www.paragondirect.ca
Countertop Disply Refrigerator
USER’S MANUAL
Reliant_Countertop_User Manual August 2019
2
Reliant_Countertop_User Manual
DANGER - Risk of re or explosion, ammable refrigerant used. Do not use mechanical devices to
defrost refrigerator. Do not puncture refrigerant tubing.
DANGER - Risk of re or explosion, ammable refrigerant used. To be repaired only by trained service
personal. Do not puncture refrigerant tubing.
CAUTION - Risk of re or explosion, ammable refrigerant used. Consult repair manual/owner’s guide
before attempting to service this product. All safety precautions must be followed.
CAUTION - Risk of re or explosion. Dispose of properly in accordance with federal or local
regulations. Flammable refrigerant used.
CAUTION - Risk of re or explosion due to puncture of refrigerant tubing; Do follow handling
instructions carefully. Flammable refrigerant used.
CAUTION - Keep clear of obstruction all ventilation openings in the appliance enclosure or in the
structure for building-in.
CAUTION - Servicing shall be done by factory authorized service personal, so as to minimize the risk
of possible ignition due to incorrect parts or improper service.
BASIC SAFETY PRECAUTIONS
The following Basic Safety Precautions should be strictly enforced when using any electrical appliance
including your unit.
• The electrical unit must be installed and placed appropriately by qualied mechanics in the light of
Installation/ Operation Instructions.
• The electrical unit must be kept far away from ammable vapors and liquids.
• The electrical unit must be unplugged from the electrical outlet before cleaning or repairing.
• Children are strictly banned from climbing, standing or hanging on the appliance so as to avoid
hurting themselves or damaging the unit.
• Hands and other body parts must be kept dry when touching the cold surface in the refrigerated
compartment, or your skin may stick to the badly cold surfaces.
INSTALLATION INSTRUCTIONS
To ensure smooth running of your unit from the very beginning, it must be installed appropriately based
on all the following instructions.
Notice: Competent or qualied personnel are highly recommended to install the unit.
Uncrating/ Unpacking
• Shipping damage should be inspected once again when uncrating the unit. If any damage is
detected, do le a claim with the transportation company immediately.
• The unit should be entirely uncrated and unpacked before installation.
• Remove the xed base brackets so as to get rid of the wooden shipping skid.
• Remove packing materials including cardboards and dust cover.
POSITIONING
• The unit should be positioned in a rm and level place in order to avoid vibration and noise. Use the
leveling feet properly to keep the unit stable.
• The unit should be positioned in a dry and cool place so as to prevent the compartment body from
getting rusty and warm.
• The unit should be positioned in a ventilated place and there should be at least 8 inches away staffs
around the cabinet for the air circulation.
Caution: It may result in potential safety hazard and the poor performance of the unit, if it is positioned
in place where it is directly exposed to rays of sun or near a direct source of radiant heat or airow.
3
Reliant_Countertop_User Manual
ELECTRICAL
• The unit must be properly grounded at all times.
• Never use an adapter plug or extension cords to power the unit.
• The wall outlet, circuit and supply voltage must be checked carefully by qualied electricians.
• The unit should be plugged into its own dedicated circuit at rated voltage.
• Broken or frayed power cords are forbidden to be put into use.
• Power cords should be prevent from being ran over or damaged when removing the unit.
• Power supply should be switched off before servicing electrical components in the unit.
• Wiring diagram can be referenced if needed.
Warning: Failure to follow the above instructions may lead to dangerous occurrence.
THERMOSTAT
Electronic Refrigeration control system maintains temperatures between
33˚ and 41˚ (0.5˚ to 5˚ ) based on factory settings. Please do refer to Digital
Control User Manual inside the product or consult qualied technicians
prior to adjusting a different temperature ranges.
STARTUP
• Plug the unit in to make it run.
• The unit should be running for 2 to 3 hours before loading products so as to detect any potential
electrical failure and concealed shipping damage.
• Do not replace the temperature controller or change its parameters at random without the help of
qualied technicians.
• Do not restart the unit immediately when it is disconnected or shut off. Please wait several minutes
before restarting it.
CLEANING AND MAINTENANCE
Proper maintenance and cleaning can prolong service life and contribute to a better performance of the
unit. It is recommended to clean the unit without loading products every 1 to 2 months.
Notice: The unit should be cut off before cleaning.
STAINLESS STEEL CLEANING
• Ammonia and soap can be used to polish the stainless steel surfaces and wipe off ngerprints and
smears.
• Other specialized commercial detergents can be used to remove grease and oil.
• Soft cloths, towers and sponges are recommended to be used along with detergents.
• Steel wool cannot be used for stainless steel cleaning.
• Hydrochloric acid or chlorine-based products cannot be used for stainless steel cleaning.
• Any detergents that contains quaternary salts cannot be used for stainless steel cleaning.
• Stainless steel surfaces should be wiped dry after cleaning.
Warning: Failure to follow the above instructions may result in abrasion, pitting and rusting of stainless
steel surfaces.
4
Reliant_Countertop_User Manual
CONDENSER CLEANING
The condenser should be cleaned at least every 1 month since dirt, grease, lint and dust can be easily
accumulated around it.
The following proper and regular cleaning instructions for the condenser help to reduce compressor
failure and minimize your maintenance expense.
• Tools such as screwdriver, adjustable wrench and stiff bristle brush are required when cleaning the
condenser.
• Unscrew all screws with a screwdriver to take off the grill which covers the condenser.
• Use a stiff bristle brush to get rid of the accumulated dirt, grease, lint and dust from the condenser.
• Clean the coils and fan blades of the condenser carefully and cautiously so as to avoid any damage.
• Ensure that the condenser and other accessories are assembled correctly before reinstalling the grill.
• Reinstall the grill and tighten all the screws.
• Connect the unit and check if it can function well.
INTERIOR CLEANING
• Remove the door gasket. Clean it weekly with soapy water and dry with soft cloth for better sealing
performance.
• Clean the interior of the unit every one month with soft cloth and soapy water.
• Detergents and cleaners that may cause corrosion, scrape and damage to the product are prohibited
to use.
• Take out the shelves and shelf brackets. Clean them and the inside of the unit with soapy water in
order to remove beverage stain and dry them with soft cloth.
• Clean the glass door periodically for better display.
• Place all the accessories properly, and restart until the unit is totally dry. Please remind that the high
side of the shelf is toward the back of the unit for better ventilation.
• Check the unit for normal operation after cleaning.
Notice: Unplug and empty the unit before cleaning the interior.
5
Reliant_Countertop_User Manual
TROUBLESHOOTING
Before requesting any service on your unit, please check the following points.
Please note that this guide serves only as a reference for solutions to common problems.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
Compressor
not running.
Fuse blown or circuit
breakertripped.
Replace fuse or reset circuit breaker.
Power cord unplugged. Plug in power cord.
Thermostat set too high. Set thermostat to lower temperature.
Cabinet in defrost cycle. Wait for defrost cycle to nish.
Condensing
unit runs for
long periods
of time.
Excessive amount of warm product
placed in cabinet.
Allow adequate time for product to cool
down.
Prolonged door opening or
doorajar.
Ensure doors are closed when not in use.
Avoid opening doors for long periods
oftime.
Door gasket(s) not sealing properly. Ensure gaskets are snapped in
completely. Remove gasket and wash
with soap and water. Check condition of
gasket and replace if necessary.
Dirty condenser coil. Clean the condenser coil.
Evaporator coil iced over. Unplug unit and allow coil to defrost.
Make sure thermostat is not set too
cold. Ensure that door gasket(s) are
sealingproperly.
Cabinet
temperature
is too warm.
Thermostat set too warm. Set thermostat to lower temperature.
Blocking air ow. Re-arrange product to allow for proper
air ow. Make sure there is at least four
inches of clearance from evaporator.
Excessive amount of warm product
placed in cabinet.
Allow adequate time for product to
cooldown.
Fuse blown or circuit breaker
tripped.
Replace fuse or reset circuit breaker.
Dirty condenser coil. Clean the condenser coil.
Prolonged door opening or
doorajar.
Ensure doors are closed when not in use.
Avoid opening doors for long periods
oftime.
Evaporator coil iced over. (see above)
Cabinet is
noisy.
Loose part(s). Locate and tighten loose part(s).
Tubing vibration. Ensure tubing is free from contact with
other tubing or components.
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Reliant Frigorifero
