RGC P225 Manuale utente
P225 Plywood Carrier Attachment
1. Remove the two platform braces to allow the platform to drop down into a vertical position.
2. Attach the two plywood carrier brackets using the existing platform holes and platform stop
hardware as shown below.
3. For extra load thickness capability, remove the wheels from the platform. Loads can be bolted
using holes provided in the carrier.
4. Sheets of plywood can be placed on the carrier with either the 4 foot or 8 foot dimension “up.” If
the 8 foot dimension is up (vertical), the weight of the sheets will automatically tilt the stack when
the carrier reaches the top of the track. If the 4 foot dimension is up, more care must be taken to
balance the stack. The worker unloading must tilt the stack into the horizontal plane to slide it out
of the carrier.
5. Material should be held against the track with a rope fastened to the carrier as shown below. The
loose end is held by the worker above. Keep the rope taut as the load is raised. Raise material
slowly when nearing the top of the track.
6/1/15
6/1/15
Indice
Altri manuali RGC Sistema di sollevamento
RGC
RGC VL10K Guide On HD Manuale utente
RGC
RGC VL 70124T Manuale utente
RGC
RGC HL40120 Manuale utente
RGC
RGC VL3000 Manuale utente
RGC
RGC HL5-7K Manuale utente
RGC
RGC HL7000 Manuale utente
RGC
RGC HL5-7K Manuale utente
RGC
RGC HL20058-48 Manuale utente
RGC
RGC PRO Drive E Manuale utente
RGC
RGC HL20058 Manuale utente
Manuali Sistema di sollevamento popolari di altre marche
Genie
Genie Z-60/34 Manuale utente
Screen Technics
Screen Technics INTERFIT Vertical Up Lift Manuale utente
Mortuary Lift
Mortuary Lift ULTIMATE 1000 Manuale utente
Custom Equipment
Custom Equipment Hy-Brid 3 Series Manuale di programmazione
Custom Equipment
Custom Equipment Hy-Brid Lifts 2 Series Manuale di programmazione
Hy-Brid Lifts
Hy-Brid Lifts HB-P3.6 Manuale di programmazione
