Ricoh P 501 Manuale utente
安装指南
Setup Guide 安装指南
为了安全正确地使用本机器，在使用之前，请务
必仔细阅读“安全信息”。
CN
Setup Guide
For safe and correct use, be sure to read the
Safety Information before using the machine.
EN
2
CN
EN
1. 准备工作/Preparing
确认组件。
• 安装指南（本手册）
• 安全信息
• 光盘
• 电源线
确认环境条件。
• 请将机器安装在机器周围温度和湿度均在上图中所示允许
范围（白色区域）的地方。（蓝色区域：建议范围）
• 请将机器安装在高度差在3 mm以内的水平位置上。
确认空间。
Confirm the components.
• Setup Guide (This manual)
• Safety Information
• CD-ROM
• Power cord
Confirm the environmental conditions.
• Install the machine in a place where the temperature
and humidity around the machine is within the permis-
sible range (white area) shown above. (Blue area: Rec-
ommended range)
• Install the machine on a level spot where the difference
in height is within 3 mm.
Confirm the space.
1
DVK204
DYR241
2
DVL227
220-240 V、7 A、50/60 Hz
110 V、12 A、60 Hz
2
DVL205
3
DYR011
35 cm
(13.8 inches)
40 cm
(15.7 inches)
47 cm
(18.5 inches)
3
CN
EN
2. 安装机器/Installing the Machine
如上图所示，两人握住机器两侧的内嵌把手，然后慢
慢抬起并移动机器。
在定位机器时将其慢慢放下。
请勿在机器周围的空间里放置任何物品，以便可以轻
松地装入纸张、更换耗材和清除卡纸。
从机器外部撕下所有窄胶带和保护膜。 按机器右侧的前盖打开按钮，然后打开前盖。
Hold the inset grips on both sides of the machine
with two people as shown above, and slowly lift
and move the machine.
Lower the machine slowly when positioning it.
Do not put anything in the space around the ma-
chine, so that you can load paper, replace consum-
ables, and clear paper jams easily.
Remove all the narrow adhesive tapes and pro-
tective sheet from the outside of the machine.
Press the front cover open button on the right
side of the machine, and then open the front
cover.
1
DYQ013
2
DYR012
35 cm
(13.8 inches)
10 cm
(4.0 inches)
35 cm
(13.8 inches)
10 cm
(4.0 inches)
20 cm
(7.9 inches)
3
DYQ015
4
1
2
DYQ016
设置/設定/Setup
4
CN
EN
设置/Setup
向您所在方向拉出胶带。
碳粉会沾到胶带边缘。请务必小心，不要触碰碳粉。
• 如果没有拉出胶带，则会发生错误。
合上前盖。
Pull out the tape straight towards you.
Toner adheres to the edge of the tape. Be careful
not to touch it.
• An error occurs if you do not pull out the tape.
Close the front cover.
5
DYQ017
6
DYQ018
5
CN
EN
3. 装入纸张/Loading Paper
向您所在方向拉出胶带。
碳粉会沾到胶带边缘。请务必小心，不要触碰碳粉。
• 如果没有拉出胶带，则会发生错误。
合上前盖。
Pull out the tape straight towards you.
Toner adheres to the edge of the tape. Be careful
not to touch it.
• An error occurs if you do not pull out the tape.
Close the front cover.
小心地拉出纸盘，直到它停住为止。提起纸盘前侧，
再将它从机器中拉出。
握住背面挡板的控制杆，并将其与纸张尺寸对齐。之
后，握住右侧挡板的控制杆，并将右侧挡板和左侧挡
板与纸张尺寸对齐。
将打印面朝下装入纸张。
• 纸张堆叠不要超过限制标记（上图所示的气球上的
标记）。
转动位于纸盘右前方的纸张尺寸拨盘，以便从窗口看
到纸盘中的纸张尺寸和进纸方向。
Pull the paper tray carefully until it stops. Lift the
front side of the tray, and then pull it out of the
machine.
Pinch the lever of the back fence and align it with
the paper size. Next, pinch the lever of the right
fence and align the right and left fences with the
paper size.
Load the paper print side down.
• Do not stack paper over the limit mark (the mark in
the balloon shown above).
Rotate the paper size dial, which is located at
the front right of the tray, so that the size and the
feed direction of the paper in the paper tray can
be seen from the window.
1
DYQ019
2
DVL229
3
DVK220
4
A5
DVL230
6
CN
EN
设置/Setup
抬起纸盘的前侧，将其插入机器，然后小心地把它推
进去，直到它停止为止。
Lifting the front side of the tray, insert it into the
machine, and then push it in carefully until it
stops.
5
DYQ020
7
CN
EN
4. 打开电源/Turning the Power On
抬起纸盘的前侧，将其插入机器，然后小心地把它推
进去，直到它停止为止。
Lifting the front side of the tray, insert it into the
machine, and then push it in carefully until it
stops.
将电源线连接到机器背面的电源接头上。 将电源线连接到墙壁电源插座。 按下主电源开关。
机器启动。在开始画面之后，将出现语言选择画面。
安装选件时，请参阅网络手册，并查看“设置”中的
“安装和设置选件”。
Connect the power cord to the power connector
at the back of the machine.
Connect the power cord to the wall outlet. Press the main power switch.
The machine starts up. Following the start screen,
the language select screen appears.
When installing option, see “Installing and Setting
Options”, Setup in the web manual.
1
DYQ021
2
DVL204
3
DYQ022
8
CN
EN
6. 时区/Time Zone
5. 语言/Language
按 [ ] 或 [ ] 键选择要使用的语言，然后按 [确定]
键。
例如，本手册使用英文屏幕。
按右侧选择键（[开始]）。 按 [ ] 或 [ ] 键选择 [时区]，然后按 [确定] 键。 按 [ ] 或 [ ] 键输入时区，然后按 [确定] 键。
Press the [ ] or [ ] key to select the language
that you want to use, and then press the [OK]
key.
English screens are used in this manual for exam-
ple.
Press the right selection key ([Start]). Press the [ ] or [ ] key to select [Time Zone],
and then press the [OK] key.
Press the [ ] or [ ] key to enter the time zone,
and then press the [OK] key.
1
DYR013
2
DYR014
[Start] Installation
Settings. You can
Change the settings
later.
StartBack
1
DYR015
2
DYR016
初始设置/初始設定/Initial Settings
9
CN
EN
7. 日期和时间/Date and Time
按 [ ] 或 [ ] 键选择要使用的语言，然后按 [确定]
键。
例如，本手册使用英文屏幕。
按右侧选择键（[开始]）。 按 [ ] 或 [ ] 键选择 [时区]，然后按 [确定] 键。 按 [ ] 或 [ ] 键输入时区，然后按 [确定] 键。
Press the [ ] or [ ] key to select the language
that you want to use, and then press the [OK]
key.
English screens are used in this manual for exam-
ple.
Press the right selection key ([Start]). Press the [ ] or [ ] key to select [Time Zone],
and then press the [OK] key.
Press the [ ] or [ ] key to enter the time zone,
and then press the [OK] key.
按 [ ] 或 [ ] 键选择 [日期和时间]，然后按 [确定]
键。
按 [ ] 或 [ ] 键输入日期、月份和年份，然后按
[确定] 键。
按 [ ] 或 [ ] 键输入时间，然后按 [确定] 键。
Press the [ ] or [ ] key to select [Date and
Time], and then press the [OK] key.
ress the [ ] or [ ] key to enter the date, month,
and year, and then press the [OK] key.
Press the [ ] or [ ] key to enter the time, and
then press the [OK] key.
1
DYR017
2
DYR018
3
DYR019
10
CN
EN
8. 夏令时/Daylight Saving Time
按 [ ] 或 [ ] 键选择 [夏令时]，然后按 [确定]
键。
按 [ ] 或 [ ] 键选择 [有效/无效]，然后按 [确定]
键。
按 [ ] 或 [ ] 键选择 [有效] 或 [无效]，然后按 [确
定] 键。
如果选择 [无效]，请按右侧选择键（[退出]）完成设
置。
如有必要，请配置夏令时的设置。
您可以设置 [开始时间]、[结束时间] 和 [偏差]。
按右侧选择键（[退出]）。
当夏令时设置完成后，画面将返回到安装设置画面。
Press the [ ] or [ ] key to select [Daylight Sav-
ing Time], and then press the [OK] key.
Press the [ ] or [ ] key to select [Active/Inac-
tive], and then press the [OK] key.
Press the [ ] or [ ] key to select [Active] or [In-
active], and then press the [OK] key.
If you select [Inactive], press the right selection key
([Exit]) to complete the setting.
Configure the settings for daylight saving time if
necessary.
You can set the [Start Time], [End Time], and [Offset].
Press the right selection key ([Exit]).
When the daylight saving time settings are complete,
the screen returns to the installation settings screen.
1
DYR020
DYR021
2
DYR022
3
DYR023
4
DYR024
Altri manuali per P 501
1
Altri manuali Ricoh Stampante
Ricoh
Ricoh Ri 1000 Manuale utente
Ricoh
Ricoh Aficio SPC220N Istruzioni per l'installazione
Ricoh
Ricoh Ri 100 Manuale utente
Ricoh
Ricoh SP C240 Series Istruzioni per il montaggio
Ricoh
Ricoh MP C6502SP Guida utente
Ricoh
Ricoh Aficio AP400 Manuale utente
Ricoh
Ricoh Aficio SP 3400N Manuale utente
Ricoh
Ricoh Martini-C3 Manuale di servizio
Ricoh
Ricoh Pro L4130 Manuale di manutenzione
Ricoh
Ricoh CL3500N - Aficio Color Laser Printer Manuale utente
Ricoh
Ricoh GX e7700N Manuale utente
Ricoh
Ricoh SP 210 Manuale utente
Ricoh
Ricoh Sirius-PJ2 Guida all'installazione
Ricoh
Ricoh SP 311DNW Manuale utente
Ricoh
Ricoh Pro C7100s Manuale utente
Ricoh
Ricoh AP610N - Aficio B/W Laser Printer Manuale operativo
Ricoh
Ricoh Priport JP5500 Manuale utente
Ricoh
Ricoh FAX Option Type 2500 Manuale di servizio
Ricoh
Ricoh Aficio SP 8200DN Manuale utente
Ricoh
Ricoh SP 311SFNw Manuale utente
