9
Small Supine Stander mainboard
(E420)
Adjusting the mainboard:
The hand crank (A) controls the transfer
height adjustment and the tilt angle of
the mainboard. By turning the crank, the
board will begin to tilt. Continue to turn
the crank until the desired angle is reached
(see Figure 9a).
Tilt angle is indicated on the board angle
label. This can be used to record the correct
angle setting for each user.
Attaching laterals:
Laterals (B) ship unassembled. Follow
instructions below to attach them.
1. Remove knob and plastic washer,
leaving rubber washer on the lateral.
2. Slide the bolt of the lateral through the
slot in the board.
3. Replace knob (C) and plastic washer on
bolt on back of board, and tighten knob
(C) securely (see Figure 9b).
Adjusting laterals and straps:
Any lateral or strap can be adjusted in and
out or up and down. To adjust in or out,
loosen the appropriate knobs, slide the
lateral or strap to the desired position, and
tighten the knobs securely.
To adjust up and down or to completely
remove a lateral or strap, loosen the
knob(s) completely and remove the lateral
or strap. The lateral or strap can then be
moved to a different set of slots, and the
knobs tightened securely.
Figure 9a
Figure 9b
