6
Diagramshows
minimum
clearances from
combustible
materials
qualified service technician to inspect
theroom heaterandto replaceanypart
ofthecontrolsystemandanygascontrol
whichhas beenunder water.
16 Adequateclearancesforaccessibilityfor
purposes of servicing and proper
operationshouldbe provided.
17 Adequate clearances around air
openingsintothe combustion chamber
shouldbeprovided.
18 Do not install in areas where curtains,
drapes, clothing, or other moving
flammables are within 15 inches of this
unit.
23 The drafthoodon the applianceshould
be installed in the same atmospheric
pressurezoneasthecombustionairinlet
tothe applianceandshall belocatedso
that the relief opening is accessible for
checkingvent operation.
24 The appliance,wheninstalled, must be
electricallygroundedinaccordancewith
local codes or, in the absence of local
codes, with the National Electrical
Code,ANSI/NFPA70, or the Canadian
Electrical Code, CSA C22.1
25 A gasappliancemustnotbe connected
to a chimney flue serving a solid fuel
burningappliance.
26 Do not restrict the warm air discharge
byplacingarticles infrontof heater.
27 This appliancemust notbe usedfor any
purposeother thanheating.
28 Do not allow anyone to post articles
throughthelouvres.
29 Do not allow anyone to sit or lean
againsttheappliance.
30 DUETOHIGHTEMPERATURES,THE
APPLIANCE SHOULD BE LOCATED
OUT OF TRAFFIC AND AWAY FROM
FURNITUREANDDRAPERIES.
31 CHILDRENANDADULTSSHOULDBE
ALERTED TO THE HAZARDS OF
HIGH SURFACE TEMPERATURES
ANDSHOULDSTAYAWAYTOAVOID
BURNSORCLOTHINGIGNITION.
32 CLOTHING OROTHERFLAMMABLE
MATERIALSHOULDNOTBEPLACED
ONORNEAR THEAPPLIANCE.
33 INSTALLATIONANDREPAIRSHOULD
BEDONEBYAQUALIFIEDSERVICE
PERSON. THEAPPLIANCESHOULD
BE INSPECTED BEFORE USE AND
AT LEAST ANNUALLY BY A
PROFESSIONALSERVICE PERSON.
MORE FREQUENT CLEANING MAY
BE REQUIRED DUE TOO
EXCESSIVELINTFROMCARPETING
19 Periodic examination of the venting
systemisrequired.
20 The flow of combustion and ventilation
airshouldnot beobstructed.
21 A manufactured home (USA only) or
mobile home OEM installation must
conform with the Manufactured Home
Constructionand SafetyStandard,Title
24CFR, Part 3280, or, when such a
standardisnot applicable,theStandard
for Manufactured Home Installations,
ANSI/NCSBCSA225.1 or Standardfor
Gas Equipped Recreational Vehicles
and Mobile Housing, CSA Z240.4.
22 The appliance and its appliance main
gasvalvemustbedisconnectedfromthe
gas supply piping system during any
pressure testing of that system at test
pressuresinexcessof1/2psi(3.5kPa).
Theappliancemustbeisolatedfromthe
gas supply piping system by closing its
equipment shutoff valve during any
pressuretestingofthegassupplypiping
systematpressuresequaltoorlessthan
½ psi (3.5 kPa).
12”
RIGHT
36”
CEILING
36”
FRONT
12”
LEFT
