Rotronic CF5/8 Series Manuale
Setup and adjustment CO2transmitter
Required material:
•CO2 Transmitter (CF5/8-Series)
•CF5/8 Comm Cable
•ROLINE USB to Serial Converter (Article No. 12.02.1089)
•Software UIP5 from SenseAir, link
•CO2 CALIBRATOR (for CO2calibration only)
Installation of USB to Serial Converter Cable:
•Insert installation disk and follow the instructions on the screen.
•IMPORTANT: The cable must be configured from COM-Port 1 to 8 (Device Manager)
Hardware Setup:
•CO2Transmitter must be powered
•Connect CF5/8 Comm Cable with your computer (USB) and with the CO2Transmitter
Software (UIP5) setup
•Start UIP5 , go to menu Help – Check for updates...
•Software Manuals: go to Menu Help – Contents
•Go to menu Meter – Connection configuration
•Tick SA-Bus and select the right COM-Port and Save settings
•Go to menu Meter – Connect to any
•Check connection status on the bottom right (OK)
Device setup
Outputs
The most important settings are Outputs (see outputs tab)
Select block No. 3 (PRegulator) to adjust the CO2 scaling. (here 0...2000 ppm)
CO2(calibration)
Select the CO2 tab to calibrate the sensor
Connect the CO2 calibrator tube with the sensor (see screenshot) and turn
on the device (green light). Wait until to CO2 value is more or less stable.
Enter 25(ppm) as Target and push “Calibrate” in the Software. Device is
now calibrated.
Indice
Altri manuali Rotronic Trasmettitore
Rotronic
Rotronic HygroClip IC-1-EX Manuale utente
Rotronic
Rotronic HygroFlex Manuale utente
Rotronic
Rotronic HygroFlex 1 Manuale utente
Rotronic
Rotronic CF5-D Manuale utente
Rotronic
Rotronic HygroFlex 1 Manuale utente
Rotronic
Rotronic HygroFlex TF5 Manuale utente
Rotronic
Rotronic HygroFlex HF3 Series Manuale utente
Rotronic
Rotronic XB Manuale utente
Rotronic
Rotronic HF120 Manuale utente
Rotronic
Rotronic PF4 Manuale utente
