RTI VXP-82 Istruzioni operative
1
It’s Under Control®
Installation and Operation Guide
70-210210-13 V1.1
It’s Under Control®
VXP-82
VXP-82 All-in-one Presentation System
All-in-One Presentation System
VXP-82
2
Copyright © 2019
Remote Technologies Incorporated
All rights reserved.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. Any changes
or modications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the device.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that may
cause undesired operation.
Industry Canada Compliance Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that may
cause undesired operation.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son
fonctionnement est soumis aux deux conditions suivantes:
1. Ce dispositif ne peut causer des interférences nuisibles.
2. Cet appareil doit accepter toute interférence reçue y compris des interférences qui
peuvent provoquer un fonctionnement indésirable.
FEDERAL COMMUNICATIONS COMMISSION NOTICE
DECLARATION OF CONFORMITY (DOC)
The Declaration of Conformity for this product can be found on the RTI website at: www.
rticorp.com/declaration
3
It’s Under Control®
Read Instructions. Read all safety and operating instructions before operating the unit.
Retain Instructions. Keep the safety and operating instructions for future reference.
Heed Warnings. Adhere to all warnings on the unit and in the operating instructions.
Follow Instructions. Install and operate in accordance with the manufacturer’s
instructions.
Accessories. Only use attachments/accessories specied by the manufacturer.
Portable Cart Warning. Use only with the cart, stand, tripod, bracket, or table specied
by the manufacturer, or sold with the apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury from tip-over.
Heat. Do not block any ventilation openings.
Heat. Keep the unit away from heat sources such as radiators, heat registers, stoves, etc.,
including ampliers that produce heat.
Power. Unplug this apparatus during lightning storms or when unused
for long periods of time.
Power Sources. Connect only to the power cord that was included with
the unit.
Power Cord Protection. Route power supply cords so that they are
not likely to be walked on or pinched by items placed on or against them, paying particular
attention to the cords at plugs, at convenient receptacles, and at the point at which they
exit from the unit.
Power Cord Grounding Plug. Do not remove the grounding prong of the grounding-type
plug. A grounding type plug has two blades and a third grounding prong. The third prong
is provided for your safety. If the provided plug does not t into your outlet, consult an
electrician for replacement of the obsolete outlet.
MAINS Outlet. Where MAINS outlets are used, the apparatus shall be connected to a
MAINS socket outlet with a protective earthing connection.
MAINS Plug. Where the MAINS plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
Water and Moisture. Do not use the unit near water—for example, near a sink, in a wet
basement, near a swimming pool, near an open window, etc.
Object and Liquid Entry. Do not allow objects to fall or liquids to be spilled into the
enclosure through openings.
Cleaning. Clean only with dry cloth.
Servicing. Do not attempt any service beyond that described in the operating instructions.
Refer all other service needs to qualied service personnel.
SAFETY SUGGESTIONS
WARNING!
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THE UNIT TO RAIN OR MOISTURE.
Damage Requiring Service. The unit should be serviced by qualied service personnel
when:
Objects have fallen or liquid has been spilled into the unit.
The power supply cord or the plug has been damaged.
The unit does not appear to operate normally or exhibits a marked change in
performance.
The unit has been dropped or the enclosure has been damaged.
All-in-One Presentation System
VXP-82
4
DISCLAIMER
All rights are reserved. No part of this document may be photocopied, reproduced, or
translated without the prior written notice of Remote Technologies Incorporated.
The information contained in this document is subject to change without notice. Remote
Technologies Incorporated shall not be liable for errors or omissions contained herein or
for consequential damages in connection with the furnishing, performance, or use of this
guide.
VXP-82, Integration Designer, and the RTI logo are registered trademarks of
Remote Technologies Incorporated.
Other brands and their products are trademarks or registered trademarks of their
respective holders.
Remote Technologies Incorporated warrants its products for a period of three (3) years
from the date of purchase from Remote Technologies Incorporated or an authorized
Remote Technologies Incorporated distributor.
This warranty may be enforced by the original purchaser and subsequent owners during
the warranty period, so long as the original dated sales receipt or other proof of warranty
coverage is presented when warranty service is required. Except as specied below, this
warranty covers all defects in material and workmanship in this product. The following are
not covered by the warranty:
Damage resulting from:
1. Accident, misuse, abuse, or neglect.
2. Failure to follow instructions contained in this Guide.
3. Repair or attempted repair by anyone other than Remote Technologies Incorporated.
4. Failure to perform recommended periodic maintenance.
5. Causes other than product defects, including lack of skill, competence or experience
of user.
6. Shipment of this product (claims must be made to the carrier).
7. Being altered or which the serial number has been defaced, modied or removed.
Remote Technologies Incorporated is not liable for any damages caused by its products or
for its failure of its products to perform, including any lost prots, lost savings, incidental
damages, or consequential damages.
Remote Technologies Incorporated is not liable for damages based upon inconvenience,
loss of use of the product, loss of time, interrupted operation, commercial loss, any claim
made by a third party or made by you for a third party.
Remote Technologies Incorporated’s liability for any defective product is limited to repair or
replacement of the product, at our option.
If any component of your VXP-82 needs service, please contact Remote Technologies
Incorporated by telephone or E-mail for return information. Please do not return
products to Remote Technologies Incorporated without return authorization.
LIMITED WARRANTY
5
It’s Under Control®
Federal Communications Commission Notice.................................... 2
Safety Suggestions........................................................................... 3
Limited Warranty ............................................................................. 4
Disclaimer ........................................................................................ 4
Table of Contents ............................................................................. 5
Chapter 1 - Welcome ........................................................................ 7
- Important Notes ..................................................................... 8
- Product Contents .................................................................... 8
Chapter 2 - Features and Description ............................................... 9
- Front Panel ............................................................................ 10
- Rear Panel ............................................................................. 11
- Pinout .................................................................................... 14
Chapter 3 - Installation and Operation ............................................ 15
- Wiring and Connections ......................................................... 15
- Web Interface........................................................................ 17
- Audio Control......................................................................... 18
-Conguration ......................................................................... 19
- Settings ................................................................................. 22
Chapter4-Specications................................................................ 25
Chapter 5 - Service and Support...................................................... 27
TABLE OF CONTENTS
All-in-One Presentation System
VXP-82
6
7
It’s Under Control®
Thank you for using the VXP-82 All-in-One Presentation System.
The VXP-82 combines robust AV switching with powerful control to deliver the ultimate
presentation solution for boardrooms, lecture halls, classrooms and conference rooms. The
all-in-one switcher features video scaling and switching, audio mixing, control and KVM
functionality in a 2U rack-mountable unit. With support for multiple AV inputs and outputs,
built-in control and HDBaseT communication, the VXP-82 enables presentations in two
rooms simultaneously.
The VXP-82 8x2 multi-format matrix switch scales content from a wide range of sources,
delivering high quality video via HDMI and HDBaseT outputs. Support for de-embedded
audio, mic inputs, and mixing capability enables exible audio output options. With a built-in
control processor and compatibility with the entire range of RTI controllers, the VXP-82 also
oers complete automation of the installation.
CHAPTER 1 | WELCOME
All-in-One Presentation System
VXP-82
8
Contents within the box include the following items:
One (1) VXP-82 All-in-One Presentation System
Two (2) Rack Mount Ears
Six (6) Mounting Screws
One (1) U.S. Power Cord
Three (3) International Power Cords
Two (2) Phoenix Connectors (3.5mm, 3 Pins)
Two (2) Phoenix Connectors (3.5mm, 5 Pins)
Three (3) Terminal Blocks (4 Position)
Three (3) Terminal Blocks (2 Position)
Two (2) RS-232 Adapters
One (1) Installation Guide
UNPACKING AND INSPECTION
After unpacking the VXP-82, save all of the packing materials in case you need to ship the
unit.
Thoroughly inspect the VXP-82 and packing materials for signs of damage. Report any
damage to the carrier immediately. Report any equipment malfunctions to RTI or an
authorized RTI distributor.
IMPORTANT NOTES
Please read these important notes about the VXP-82:
The VXP-82 should be placed in an area where it is around normal room temperature
(between 60°F to 90°F).
Avoid installing the VXP-82 in a location with little or no air circulation.
Avoid installing the VXP-82 in a location where it can come in contact with direct
sunlight.
Do not let the VXP-82 system get wet. It should not be handled with wet hands or
placed in an area where it could get wet.
Do not subject the VXP-82 to smoke, dust, or vibrations.
Only use the power cord that is supplied with the VXP-82. Using the wrong type of
power cord may result in damage.
Do not disassemble the unit. Service of the VXP-82 should be performed by
authorized personnel only.
CHAPTER 1 | PRODUCT CONTENTS
9
It’s Under Control®
The VXP-82 provides superior quality and reliability as well as these features:
• 8x2 4K All-in-One Scaling Presentation Matrix Switcher.
• Support for HDCP 2.2 and HDMI 2.0
• Seamless audio and video switching.
• Built-in scaler supports up to 4K@60Hz 4:4:4 8bit video output.
• HDBaseT inputs/output:
- Transmission via Cat55 cable: 4K@60Hz 4:2:0 8bit signal up to 90m/300ft,
1080p@60Hz 4:4:4 8bit signal up to 100m/330ft
- Transmission via Cat-6/6a/7 cable: 4K@60Hz 4:2:0 8bit signal up to 100m/330ft,
1080p@60Hz 4:4:4 8bit signal up to 100m/330ft.
• HDBaseT outputs support PoH (Power over HDBaseT) to power extenders in addition
to Ethernet, IR and RS-232 pass-through.
• Supports Auto-CEC control, set through driver commands or Web UI.
• Bi-directional KVM functionality for HDMI or HDBaseT outputs - Ideal for presentation
settings.
• Supports de-embedded audio of HDMI and HDBaseT outputs, set independently to
output any mixed result.
• Control via front panel, built-in processor, and Web UI.
• Built-in control processor with 128Mb of non-volatile ash memory.
• Control of devices via six routable IR ports, two RS-232 ports, three relays, three
voltage triggers, and three voltage sense inputs.
• Support for RTI wired and wireless controllers (remote controls require RTI RM-433
433MHz or ZM-24 2.4GHz Zigbee antennas).
• Support for with RTiPanel App.
• Flexible installation options with tabletop or rack-mount design.
CHAPTER 2 | FEATURES AND DESCRIPTION
All-in-One Presentation System
VXP-82
10
CHAPTER 2 | FEATURES AND DESCRIPTION
VXP-82 FRONT PANEL DESCRIPTION
No. Name Function
1 POWER LED Indicator Turns red when powered on.
2STATUS LED Indicator When powered on, the status LED is red, then turns
yellow, and then goes out. This indicates the status of
the built-in processor.
3HDMI IN1 Selection Press to select HDMI IN1 source as input.
4HDMI IN2 Selection Press to select HDMI IN2 source as input.
5HDMI IN3 Selection Press to select HDMI IN3 source as input.
6DP IN4 Selection Press to select Display Port IN source as input.
7VGA IN5 Selection Press to select VGA IN5 source as input.
8VGA IN6 Selection Press to select VGA IN6 source as input.
9HDBT IN7 Selection Press to select HDBT IN7 source as input.
10 HDBT IN8 Selection Press to select HDBT IN8 source as input.
11 Input Selection
Indicator
Indicators are located above the selection buttons.
When the button function is enabled, the LED is blue.
12 HDMI OUT Selection Press to select HDMI output.
13 HDBT OUT Selection Press to select HDBT video output.
14 Output Selection
Indicator
LED is located above the selection button. When the
button function is enabled, the LED is blue.
15 Reset Use a pointed stylus to hold down the RESET button for
three or more seconds and then release to reset the
VXP-82 control processor only.
16 USB USB port
1 2 3 4 5 1615131210
986 7
11 14
Indice
