S.R.Smith Rogue2 Manuale utente

06-821 S.R. SMITH, LLC 2006 OCT13

CORPORATE HEADQUARTERS

WESTERN SALES AND MANUFACTURING PLANT

P.O. Box 400 1017 SW Berg Parkway

Canby, Oregon 97013

Phone: (503) 266-2231 Fax: (503) 266-4334

www.srsmith.com

SLIDE OWNERS MANUAL

Table of Contents

Topic Page#

SLIDE WARNING AND SAFETY SUMMARY........................................................................................................3

INTENDED USE INSTRUCTIONS...........................................................................................................................4

INSTALLED ROGUE2 STRUCTURAL & INSTALLATION CHECKLIST...........................................................5

DAILY/WEEKLY MAINTENANCE OF THE ROGUE2..........................................................................................5

APPLICABLE STANDARDS AND CODES ............................................................................................................5

ASSEMBLY AND INSTALLATION...........................................................................................................................5

DRAWINGS.................................................................................................................................................................6

SUBSEQUENT OWNERS.........................................................................................................................................6

MANUFACTURER’S PLACEMENT INSTRUCTIONS..........................................................................................6

CLEANING INSTRUCTIONS....................................................................................................................................8

SLIDE WARNING AND SAFETY SUMMARY

DANGER – FAILURE TO FOLLOW THESE WARNINGS, INSTRUCTIONS AND THE

OWNER’S MANUAL MAY RESULT IN SEROUS INJURY OR DEATH

HEAD FIRST SLIDES ARE STRICTLY PROHIBITED

TO REDUCE THE POSSIBILITY OF INJURY, IT IS NECESSARY THAT THE USER

KNOW THAT THE CHIEF DANGER OF HEAD FIRST SLIDING IS SERIOUS SPINAL

INJURY. INJURIES TO THE SPINE MAY RESULT IN TEMPORARY OR

PERMANENT PARALYSIS OR EVEN DEATH. RESEARCH STUDIES HAVE

SHOWN THAT YOU CANNOT RELY ON THE WATER TO SLOW YOU DOWN

SUFFICIENTLY TO AVOID INJURY.

DO NOT SLIDE HEAD FIRST

READ AND FOLLOW ALL SAFETY RULES

LISTED BELOW.

MAKE SURE THAT EVERYONE WHO USES

THE ROGUE 2 KNOWS AND FOLLOWS ALL

RULES.

CHILDREN MUST BE SUPERVISED BY AN

ADULT AT ALL TIMES WHEN USING THE

SLIDE.

INTENDED USE INSTRUCTIONS

THE ROGUE2 SLIDE IS DESIGNED AND MANUFACTURED FOR INSTALLATION

AND USE ON INGROUND SWIMMING POOLS ONLY. DO NOT INSTALL THE

ROGUE2 SLIDE ON ABOVE GROUND POOLS, HOUSEBOATS, BOAT DOCKS,

FLOATING DOCKS OR PLATFORMS, OR OTHER BODIES OF WATER SUCH AS

LAKES, PONDS, RIVERS, ETC. PROPER ASSEMBLY, INSTALLATION, USE, AND

SUPERVISION IS ESSENTIAL FOR PROPER OPERATION AND TO REDUCE THE

RISK OF SERIOUS INJURY OR DEATH.

1. ONLY ONE PERSON ALLOWED ON THE SLIDE AT ANY GIVEN TIME.

2. SLIDE FEET FIRST ONLY AS SHOWN IN FIGURE 1. DO NOT SLIDE HEAD

FIRST

3. HOLD ONTO HANDRAILS AT ALL TIMES WHEN USING THE LADDER.

4. NO ROUGHHOUSING OR HORSEPLAY ON SLIDE.

5. DO NOT JUMP OR DIVE FROM ANY PART OF THE SLIDE.

6. FAMILIARIZE YOURSELF WITH THE SHAPE OF THE POOL BOTTOM AND

THE WATER DEPTH BEFORE YOU SLIDE. SLIDE FEET FIRST ONLY.

7. DO NOT SLIDE UNTIL ALL SUBMERGED OBSTACLES, SURFACE OBJECTS

OR OTHER SWIMMERS ARE CLEAR OF THE SLIDER’S PATHWAY.

8. DO NOT USE THE SLIDE WHILE UNDER THE INFLUENCE OF ALCOHOL OR

DRUGS.

9. DON’T SLIDE ALONE; USE THE BUDDY SYSTEM.

10.TAKE YOUR TIME IN PREPARING TO SLIDE. MOVE FORWARD SLOWLY

AND GET YOURSELF POSITIONED PROPERLY BEFORE STARTING THE

SLIDE.

11.ONLY PERSONS HEALTHY ENOUGH FOR WATER ACTIVITIES SHOULD

USE THE SLIDE. PERSONS WITH MEDICAL CONDITIONS, INCLUDING

PREGNANCY, SHOULD CONSULT THEIR DOCTOR BEFORE USING THE

SLIDE. PERSONS WITH PHYSICAL DISABILITIES SHOULD USE CAUTION

AND MAY REQUIRE ASSISTANCE.

12.DO NOT USE THE SLIDE IF ANY PART OF IT BECOMES DAMAGED,

WEAKENED, OR BROKEN. HAVE THE SLIDE INSPECTED AND, IF

NECESSARY, REPAIRED BY A POOL PROFESSIONAL, WHO IS FAMILIAR

WITH WATER SLIDES BEFORE USING THE SLIDE. SEE INSTALLED SLIDES’

STRUCTURAL & INSTALLATION CHECKLIST.

13.MAXIMUM WEIGHT CAPACITY FOR THE SLIDE IS 250 LBS.

PROPER SLIDING POSITION

Slide users must use the sitting slide position, facing forward, feet first as shown in

Figure 1.

Figure 1

INSTALLED ROGUE2 STRUCTURAL & INSTALLATION CHECKLIST

After installation and prior to the first use of the ROGUE2 and periodically (see

DAILY/WEEKLY MAINTENANCE OF THE ROGUE2) thereafter the owner must:

1. Inspect the runway for visible cracks or tears.

2. Inspect the ladder for sharp edges, protrusions, cracks or tears.

3. Inspect ladder and pedestal mounting areas for loose or corroded fasteners.

4. Measure the following dimensions and compare with the Manufacturer’s

Placement Instructions on pages 5, 6, and 7.

Measure the depth of water in front of the slide exit. (4-6”) min. depth at a

distance of (4-6”) from exit end of slide.

Measure the height of the slide runway exit above the water. (20” max.)

Measure the distance between the slide centerline and the edge of other

pool equipment.

5. Observe the position of the exit of the slide as shown in Figures 2, 3 and 5 on

pages 6 and 7.

6. Read, understand and enforce all safety and use instructions on the slide.

DAILY/WEEKLY MAINTENANCE OF THE ROGUE2

1. When hosing down the deck, hose your Rogue2 to wash away any dust, dirt or

other debris, which may have accumulated.

2. Be sure that all connections are secure. Tighten hardware if necessary.

3. All polyethylene parts require little maintenance. Hose and wipe to clean.

While cleaning slide, check and see that all nuts and bolts are tight and secure.

4. Inspect the runway for visible cracks or tears, sharp edges and protrusions.

5. Inspect all attachment points for loose or corroded fasteners.

6. Inspect all ladder tread or step-attachment points for evidence of shear, bending

yield, or fatigue in the ladder steps, rails, or attachments means. Yield is

evidenced by crystallization or fine cracking of the ladder tread and/or surface.

7. Inspect the ladder handrails for rigidity and attachment.

APPLICABLE STANDARDS AND CODES

The installation of the Rogue2 must comply with all applicable governmental and

building codes.

ASSEMBLY AND INSTALLATION

All S.R. Smith Rogue2 slides are inspected prior to shipment from the factory. Proper

assembly and installation is mandatory. Improper assembly and installation voids S.R.

Smith’s warranty and may affect the safety of the user. It is the installer’s responsibility

to ensure that the structural integrity of the concrete pad prior to installation of the slide.

DRAWINGS

All drawings in this Slide Owner’s Manual (Figures 1 through 5) are for illustration

purposes only and are NOT TO SCALE.

SUBSEQUENT OWNERS

The Owner’s Manual must remain with the owner of the slide. If the owner changes, the

Owner’s Manual shall be brought to the attention of the new owner.

MANUFACTURER’S PLACEMENT INSTRUCTIONS

THE SLIDE OWNER MUST REVIEW THE MANUFACTURER’S PLACEMENT

INSTRUCTIONS WITH THE INSTALLER TO ENSURE THAT THE MANUFACTURER’S

INSTALLATION REQUIREMENTS HAVE BEEN MET.

PROPER ASSEMBLY, INSTALLATION, USE, AND SUPERVISION IS ESSENTIAL FOR

PROPER OPERATION AND TO REDUCE THE RISK OF SERIOUS INJURY OR DEATH.

1. The critical dimensions for placement of the Rogue2 slide are as shown in Figures 2

and 3.

A. The slide exit runway surface shall not exceed twenty inches (20”) above the

water surface as shown in Figure 2.

B. The slide shall be positioned so that all water flowing off the runway exit drops

into the pool. Recommended overhang is (3”) inches.

C. The minimum depth of water below the exit lip of the slide shall be three feet (3’)

and increases to four feet six inches (4’-6”) at Pt. A, which is a distance of four

feet six inches (4’-6”) from the exit lip of the slide as shown in Figure 2.

D. A minimum depth of four feet six inches (4’-6”) shall be maintained at a distance

of nine feet (9’) along the extended centerline of the slide from Pt. A. as shown in

Figure 2.

FIGURE 2

DECK/COPING SURFACE

3' MIN.

EXIT

RUNWAY SURFACE

PLUMBLINE

20" MAX.

WATER LEVEL

ENTRANCE

Pt.A

13'-6" MIN.

9' MIN. 4'-6"

4'-6" MIN.4'-6" MIN.

2. A minimum clearance area in front of the slide shall be maintained at all times as

follows:

The minimum clearance distance on either side of

the extended centerline of the slide runway shall not

be less than three feet six inches (3’-6”) at a point

no less than two feet six inches (2’-6”) from the exit

lip of the slide and extending a distance of thirteen

feet six inches (13’-6”) in front of the slide as shown

in FIGURE 3.

3. SLIDE PLACEMENT INSTRUCTIONS FOR INSTALLATIONS ON POOLS WITH

OTHER SLIDES AND/OR DIVING BOARDS

A. The minimum clearance area in front of a properly installed diving board on an

inground swimming pool is a minimum distance of three feet six inches (3’-6”) on

either side of the board’s centerline as shown in FIGURE 4. Pt. C extends a

minimum distance of “C” from the tip end of the board as shown in FIGURE 4.

The width distance “W” on either side of Pt. C is given in CHART 1 and shown in

FIGURE 4.

FIGURE 3

“C” DIMENSION FOR BOARD = AB + BC

“W” DIMENSION FOR BOARD = WIDTH AT PT.C

A. The minimum clearance area of a slide or diving board shall not intersect any

coping or rope and float line as shown in FIGURE 5. The minimum clearance

area of a slide or diving board may intersect each other provided that they are

not used simultaneously.

CLEANING INSTRUCTIONS

Use nonabrasive soap and water when possible. In addition, you may safely use the

below listed products. Always try a test spot before applying to a large area.

Windex® With Ammonia Formula 409 ® Fantastik ®

Soft Scrub ® Scrubfree Tackle ®

Glass Plus ® Topjob ® Tilex ®

CHART 1

BOARD MINIMUM CLEARANCE AREA

POOL TYPE “C” DIMENSION “W” DIMENSION

I 14’-6” 5’-0”

II 14’-6” 6’-0”

III 16’-6” 6’-0”

IV 18’-6” 7’-6”

V 21’-0” 7’-6”

See Article 5 contained in ANSI/APSP/ICC-5 2011

STANDARD FOR RESIDENTIAL INGROUND SWIMMING

POOLS and refer to FIGURE 3 and Table 1 for Minimum

Water Envelope Dimensions AB, BC and Width at Point C.

FIGURE 5

FIGURE 4

Always read the label instructions on any cleaner carefully before applying it to a

polyethylene surface.

AVOID HARSH CHEMICALS AND DISINFECTANTS. DO NOT USE:

Dow with Scrubbing Bubbles ® Lysol ® Disinfectant Ajax ® Cleanser

Windex ® With Vinegar White Cap ® Ajax ® Liquid

Serious Equipment, Serious Fun!

Product Name: Rogue2

Serial Number: ___________________ (located on label attached to slide)

Purchase Date:____________________

To register your slide and find information on the full line of S.R. Smith deck equipment

please visit www.srsmith.com.

Like us www.facebook.com/srsmithpools

Altri manuali per rogue2

Indice

Altri manuali S.R.Smith Attrezzatura di illuminazione

S.R.Smith

S.R.Smith SlideAway Guida all'installazione

S.R.Smith

S.R.Smith rogue2 Manuale utente

S.R.Smith

S.R.Smith VORTEX Manuale di istruzioni

S.R.Smith

S.R.Smith LM10 Manuale utente

S.R.Smith

S.R.Smith PT-6001 Power Tower Manuale utente

S.R.Smith

S.R.Smith heliX2 Manuale di istruzioni

S.R.Smith

S.R.Smith TURBOTWISTER Manuale di istruzioni

S.R.Smith

S.R.Smith BYOS 2 Manuale di programmazione

S.R.Smith

S.R.Smith R Series Manuale utente

S.R.Smith

S.R.Smith pLX-PL60 Guida rapida

S.R.Smith

S.R.Smith CYCLONE Manuale di istruzioni

S.R.Smith

S.R.Smith EDGE 6 Manuale di programmazione

S.R.Smith

S.R.Smith FRONTIER II Manuale utente

S.R.Smith

S.R.Smith PAL Series Manuale utente

S.R.Smith

S.R.Smith Star Series Manuale utente

S.R.Smith

S.R.Smith SRS-TX-30 Manuale utente

S.R.Smith

S.R.Smith ROGUE GRAND RAPIDS Manuale utente

S.R.Smith

S.R.Smith 6004 Series Manuale utente

S.R.Smith

S.R.Smith TYPHOON Manuale di istruzioni

S.R.Smith

S.R.Smith SWIM CLUB II FUNSLIDE Manuale utente

S.R.Smith

S.R.Smith multiLift 2 Guida

S.R.Smith

S.R.Smith Power Tower PT-6002 Manuale utente

S.R.Smith

S.R.Smith AQUABLAST Manuale utente

Manuali Attrezzatura di illuminazione popolari di altre marche

Brizo

Brizo 8SP-MU-4 Manuale utente

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuale utente

IKEA

IKEA BJÖRKSPIREA Manuale utente

Laserworld

Laserworld Evolution Series ES-400RGB Manuale utente

Alien

Alien RG STAR Manuale utente

EuroLite

EuroLite LED B-40 Manuale utente

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuale utente

Commercial Electric

Commercial Electric 54568141 Manuale utente

CREE LIGHTING

CREE LIGHTING 304 Series Manuale utente

Goobay

Goobay 49867 Manuale utente

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuale utente

Alkalite

Alkalite Krypton KT-81 Manuale utente

Clas Ohlson

Clas Ohlson GU10 Manuale utente

DTS

DTS DELTA 10 F Manuale utente

ring

ring Solar Steplight Manuale utente

One Stop Gardens

One Stop Gardens 57696 Istruzioni per il montaggio

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuale utente

SIREM

SIREM Swimeo A2 Manuale utente