Samsung VAC9073BP Foglio di istruzioni

Operating lnstructions

For household use only

Guide de l’utilisateur

VACUUM CLEANER

☞Before operating this unit, please read the instructions carefully.

☞Avant de fonctionner cet appareil, lisez les instructions avec soin.

ASPIRADORA

DJ68-40015Q 7/3/02 1:31 PM Page 1

-1

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER

When using an electrical appliance, basic precautions should always be fol-

lowed, including the following :

WARNING

To reduce the risk of fire, electric shock, or injury.

1. Do not leave appliance when plugged in. Unplug from outlet when not in

use and before servicing.

2. Do not use outdoors or on wet surfaces.

3. Do not allow to be used as a toy. Close attention is necessary when used

by or near children.

4. Use only as described in this manual. Use only manufacturer’s recom-

mended attachments.

5. Do not use with damaged cord or plug. If appliance is not working as it

should, has been dropped, damaged, left outdoors, or dropped into

water, take it to a service center.

6. Do not pull or carry by cord, use cord as a handle, close a door on cord,

or pull cord around sharp edges or corners. Do not run appliance over

cord. Keep cord away from heated surfaces.

7. Do not unplug by pulling on cord.To unplug, grasp the plug, not the cord.

8. Do not handle plug or appliance with wet hands.

9. Do not put any object into openings. Do not use with any opening

blocked: keep free of dust, lint, hair, and anything that may reduce air

flow.

10. Keep hair, loose clothing, fingers, and all other parts of the body away

from openings and moving parts.

11. Do not vacuum anything that is burning or smoking, such as cigarettes,

matches, or hot ashes.

DJ68-40015Q 7/3/02 1:31 PM Page 3

-2

SAVE THESE INSTRUCTIONS

To reduce the risk of electric shock, this appliance has a polarized

plug(one blade is wider than the other). This plug will fit in a polarized out-

let only one way. If the plug does not fit fully in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician to install the proper out-

let. Do not change the plug in any way.

12. Do not use without dust bag and filters in place.

13. Turn off all controls before unplugging.

14. Use extra care when cleaning on stairs.

15. Do not use to vacuum flammable or combustible liquids such as gaso-

line or use in areas where they may be present.

16. Store your vacuum cleaner indoors in a cool, dry area.

17. Do not use extension cords or an outlet with inadequate current carry-

ing capacity.

18. Hold plug when rewinding onto cord reel. Do not allow plug to whip

when rewinding.

19. Unplug electrical appliances before vacuuming them.

20. The hose contains electrical wires. Do not use if damaged, cut, or punc-

tured. Avoid picking up sharp objects.

21.Always turn off this appliance before connecting or disconnecting either

hose, wand or motorized nozzle.

DJ68-40015Q 7/3/02 1:31 PM Page 4

-3

DUST-FULL INDICATOR

If the “Dust-Full” indicator switches to “RED” while you are cleaning, the dust bag is full

and must be replaced.

If the “Dust-Full” indicator continues to display “RED” even after changing the

dust bag, turn the cleaner off and check whether the hose, tube or nozzle is

clogged.

NOTE :

PARTS IDENTIFICATION

DJ68-40015Q 7/3/02 1:31 PM Page 5

-4

ASSEMBLING THE VACUUM CLEANER FOR USE

The Extension wand can be adjusted to your

height.

Hold the central area with one hand while pulling

the smallest tube out or pushing into the desired

length with the other hand.

Attaching the Hose to the Canister

Slide the Hose Clamper into the canister Inlet until

it “Clicks” into place.(Fig. A-A)

Attaching the Extension Wand to the Hose

Slide the handle end of hose over the end of the

wand until it “Clicks” into place. (Fig. A-B)

They can be removed by pressing the button on

the Hose.

Attaching the Power Brush

Slide the end of the Extension Wand onto the

Power Brush Wand unitl it “Clicks” into place. (Fig.

A-C)

They can be removed by pressing the button on

the Extension Wand.

EXTENSION WAND

DJ68-40015Q 7/3/02 1:31 PM Page 6

-5

ON/OFF SWITCH

POWER CONTROL

With the cord plugged into an electrical outlet, start or

stop the vacuum cleaner by stepping lightly on the

switch button.

The suction power can be adjusted with the electrical

power control to suit any situation.

MIN = For delicate fabrics, like net curtains.

MAX = For hard floors and heavily soiled carpets.

* Manual suction power control

The flexible hose hose handle(suction control) has a

manual air flow regulator which allows you to briefly alter

the suction level : the further open the regulator is, the

weaker the suction power.

POWER CORD

1) PULLING OUT

The power cord is long enough to be drawn out for

convenience.

2) REWINDING

Upon finishing cleaning, disconnect the plug from the

electrical outlet and press the cord rewind button lightly

with your toe.

When removing the power cord from the electrical outlet, grasp the plug, not

the cord.

NOTE :

DJ68-40015Q 7/3/02 1:31 PM Page 7

-6

TRANSPORTING AND STORING THE VACUUM CLEANER

For easy storage and transportation, this vacuum cleaner has a clip

system built onto the body, which will keep the tube, hose and noz-

zle in a vertical position.

USING THE ACCESSORIES

• Dusting brush - for furniture, shelves, books, etc.

• Upholstery brush - for cushions and drapery.

• Crevice tool - for radiator, crevices, corners, between cushions.

• Power brush -The rotating brush ensures that cleaning

is carried out more thoroughly.

OPERATING THE BRUSH HEAD

PARK POSITION

Push the ON/OFF switch(A) down.

(The brush switches on)

Located in the top rear side of the vacuum cleaner, there

is a support for a convenient park position during pauses

when using the nozzle.

DJ68-40015Q 7/3/02 1:31 PM Page 8

-7

REPLACING THE DUST BAG

3) After removing the used dust bag,insert

the cardboard bag collar of the new

dust bag into the suction inlet all the

way.

1) To open the dust cover of the dust bag

compartment, press the clamp upward

located at the side of the dust cover.

4) Press the dust cover down gently until

the clamp relocks.

If you are using a cloth filter bag, clean it when it’s full and use it again.

NOTE :

A used dust bag can be sealed by removing the paper from the adhesive

strip and sealing the strip over the suction opening.

NOTE :

2) Remove the dust bag from the cleaner.

DJ68-40015Q 7/3/02 1:31 PM Page 9

-8

VACUUMING WITH THE POWER BRUSH

1. Attaching the Power Brush

The hose must be plugged into the canister and the power

brush must be plugged into the hose and extension wand

(see page 3).

2. Vacuuming

● For best results, move the power brush slowly using short, over-

lapping strokes.

● For heavily soiled areas, repeat strokes in several directions.

● Turn height adjustment knob to match the surface

beingcleaned.(optional)

3. Checking the Performance of the Power Brush

You may check whether the power brush is operating correctly by lifting up the

extension tube slightly to view the back of the brush.

The Power Brush will not operate when it is jammed or the unit is turned off.

If the Power Brush is jammed, Unplug the power cord from the electrical outlet. Turn the

power brush over and remove the jammed object.

Turn the power brush back to vacuuming position and resume vacuuming.

CAUTION: Do not invert the power brush while it is running

MAINTAINING THE POWER BRUSH

1. Removing the Brush Cover

● Before replacing any parts, unplug the vacuum

cleaner from the electrical outlet.

● Remove 6 screws from the bottom plate and

open the brush cover.

1) Remove the Brush Cover as

described below. 2) Remove the old bulb from the bulb

socket.

Insert the new bulb. You can use a

vacuum cleaner lamp rated 120V,

20W.

2. Replacing the Headlight Bulb(optional)

DJ68-40015Q 7/3/02 1:31 PM Page 10

-9

2) Remove the flat belt from the motor

shaft and the brushroller. Loop the new

belt around the motor shaft and then

loop it around the brushroller.

1) Remove the brush cover. Grasp the

brushroller firmly, and pull it out.

Use with caution when replacing the belt that drives the brushroller. Tension on

the belt is high.

3. Replacing the Brushroller Belt

4) Be sure that the belt is not twisted.

Rotate the belt 3 or 4 times to position

it correctly on the roller and to make

sure all rotating parts move smoothly.

Replace the brush cover.

3) Reinsert the brushroller, making sure

that both ends of the brushroller are fit

ted into the grooves of the nozzle head.

1) Turn off the vacuum cleaner and unplug the

power cord.

2) Remove the cover to expose the

brushroller.

3) Cut off any lint, carpet pile or hair that has

accumulated around the brushroller with a

pair of scissors. Replace the brush cover.

4. Cleaning the Brushroller

DJ68-40015Q 7/3/02 1:31 PM Page 11

Questo manuale è adatto per i seguenti modelli

Indice

Lingue:

Altri manuali Samsung Aspirapolvere

Samsung

Samsung VCMA16 series Manuale utente

Samsung

Samsung SC18M31 Series Manuale utente

Samsung

Samsung VR30T85513W/WA Manuale utente

Samsung

Samsung SC88 series Manuale utente

Samsung

Samsung SC15F30 Series Manuale utente

Samsung

Samsung SR8875 Manuale utente

Samsung

Samsung VS15A6032R5 Manuale utente

Samsung

Samsung VC- W113 Manuale utente

Samsung

Samsung VS20A95 Series Manuale utente

Samsung

Samsung VC-8828E Manuale utente

Samsung

Samsung VS15A60 Series Manuale utente

Samsung

Samsung SC7030 Manuale utente

Samsung

Samsung VS15A6031R7 Manuale utente

Samsung

Samsung SR8855 Guida di riferimento

Samsung

Samsung VAC8913EP Manuale utente

Samsung

Samsung DJ68-00341G Manuale utente

Samsung

Samsung SS75N80 Series Manuale utente

Samsung

Samsung SC5250 Manuale utente

Samsung

Samsung VC-6000 SERIES Foglio di istruzioni

Samsung

Samsung SC5370 Manuale utente

Samsung

Samsung SU12F40 SERIES Manuale utente

Samsung

Samsung Vacuum cleaner Manuale utente

Samsung

Samsung SC67 series Manuale utente

Samsung

Samsung POWERbot SR20J925 Series Manuale utente

Manuali Aspirapolvere popolari di altre marche

Bissell

Bissell LittleGreen Proheat 1425 Series Manuale utente

Panasonic

Panasonic MC-YL637S147-AE Manuale utente

NEFF

NEFF N17XH10 0 Series Manuale utente

LG A9 Series Manuale utente

Oreck

Oreck Cordless Captura BK51700 Series Manuale utente

Kogan

Kogan KAVACROBVWA Manuale utente

Kränzle

Kränzle VENTOS 50 ID Guida utente

EVVO

EVVO Ai35 Manuale utente

DeWalt

DeWalt DWH200D Manuale utente

Pontec

Pontec Pondomatic Vacuum Cleaner Manuale utente

Cleanmaxx

Cleanmaxx PC-P007E Manuale utente

Exido

Exido 240-114 Manuale utente

RIDGID

RIDGID WD1685AU0 Manuale utente

Ezviz

Ezviz RE4P Manuale utente

STG global

STG global TANVAC HDV3000 Manuale utente

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Manuale utente

Factory

Factory M3340 Manuale utente

Shop-Vac

Shop-Vac VN92 SERIES Manuale utente