Sangean PR-D3 Manuale utente
PR-D3
Version 1
D中文
GB
1
GB
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including ampliers) that
produce heat.
Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider
than the other. A grounding type plug has two blades and
a third grounding prong. The wide blade or the third prong
are provided for your safety. If the provided plug does not fit
into your outlet. Consult an electrician for replacement of the
obsolete outlet.
Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
IMPORTANT SAFETY INSTRUCTIONS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
2
Only use attachments/accessories specified by the
manufacturer.
Use only with the cart, stand, tripod, bracket, or table specied
by the manufacturer, or sold with the apparatus. When a cart is
used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
Unplug this apparatus during lightning storms or when unused
for long periods of time.
Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged. liquid has been
spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate
normally, or has been dropped.
To Reduce the Risk of Fire or Electric Shock, Do not Expose
This Appliance To Rain or Moisture.
11.
12.
13.
14.
15.
3
GB
The Shock Hazard Marking and Associated Graphical Symbol
is provided on the rear of unit.
Apparatus shall not be exposed to dripping or splashing and no
objects lled with liquids, shall be placed on the apparatus.
Excessive sound pressure on ear- and headphones could
impair the hearing ability. Higher setting that idle on the
equalizer leads to higher signal voltages on the output for ear
and headphones.
The power plug should be close to the radio, and easy to be
approached that during the emergency, to disconnect the power
from the radio, just unplug the power plug from the AC power
slot.
Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnected device shall remain readily
operable.
16.
17.
18.
19.
20.
4
5
GB
Controls
Power/Sleep button
Preset button
AM NARR button/FM mono button
Band button
Tuning up/down button
Display button
Clock set button
Buzzer alarm button
Radio alarm button
Treble/Bass button
Tuning control rotary
Lock switch
Volume control rotary
Headphone socket
Telescopic aerial
Mains input socket
External AM antenna
Battery compartment
Reset button
2
1
3
5
7
19
18
17
16
15
14
13
12
11
10
9
4
6
8
6
Display icon
Battery power level indicator and Signal strength meter
Battery symbol
Key lock symbol
Preset indicator
Stereo indicator
Sleep timer/Snooze indicator
Indicates Band in use
Radio alarm indicator
AM/PM indicator
Buzzer alarm
Frequency/Clock display
Clock seconds
H
G
F
E
D
C
B
A
L
K
J
I
7
GB
CHOOSING A POWER SUPPLY
This radio can be operated using: 4 Alkaline UM-1 (D size)
batteries or AC power (230V/50 Hz or 240V/50 Hz)
AC operation
Before you plug the AC cord into the radio be sure the AC voltage
is 230 Volts/50 Hz (European version)/240 Volts/50 Hz (Australian
version). If you have batteries in the radio and you use the AC
power cord, the batteries will automatically be disconnected.
The AC cord should be disconnected from the mains supply when
not in use.
Note:
If you remove the power cord without turning the radio OFF, the
radio will automatically revert to the batteries
8
Power with batteries
● INSTALLING BATTERIES
1. Position the radio face down on a soft surface to protect it.
2. Press the catch and pull out the battery compartment cover.
3. Insert 4 UM-1 (D size) batteries as indicated in the drawing on
the right hand side.
4. Replace the battery cover.
● BATTERY REPLACEMENT
The battery indicator will temporarily display the battery level when
the radio is power off. The battery indicator will show ( ) when
the battery in full power level, whereas ( ) indicates the batteries
are low.
When battery indicator flashes, the batteries should be
replaced. After removing the batteries, you have approximately
3 minutes to replace the batteries after which clock and memory
information will be lost (if the radio is not plugged in).
Note:
When the radio is power on, the bar indicates as the signal strength
meter.
9
GB
Clock time setting
After the batteries are installed or AC power is plugged in, the
screen will display all icons, then the display will show -:--.
1. Clock time can be set while radio is on or off.
2. Press and hold the Clock set button, the hour digits will flash,
press the Tuning Up/Down (or use the Tuning control rotary) to
adjust the required hour time.
3. Press and release the Clock set button again, the minute digits
will flash, press Tuning Up/Down button again to adjust the
required minute time.
4. Press and release the Clock Set button again to complete time
setting. This also sets the seconds to “00.”
Setting the alarm
Setting the type of alarm
There are two different alarm modes in this unit. You can choose to
wake up to the radio ( ) or to a buzzer ( ). You
can set the alarm with the radio on or off.
1. Press and hold the Alarm button until you hear a beep and see
one of these symbol or ashing on the display.
2. Now both the hour digit and alarm symbol will ash. Press the
Tuning up/down button to set the required hour. Then press the
Alarm button again.
Indice
Altri manuali Sangean Radio
Sangean
Sangean ATS 909 Manuale utente
Sangean
Sangean WR-2 Manuale utente
Sangean
Sangean DDR-7 Manuale utente
Sangean
Sangean WFR-28C Manuale utente
Sangean
Sangean DDR-66BT Manuale utente
Sangean
Sangean DT-210 Manuale utente
Sangean
Sangean DT-110 Manuale utente
Sangean
Sangean H202 Manuale utente
Sangean
Sangean ATS-909 Manuale utente
Sangean
Sangean WFR-28BT Manuale utente
Sangean
Sangean WR-2CL Manuale utente
Sangean
Sangean WFT-2D Manuale utente
Sangean
Sangean SR-3 Manuale utente
Sangean
Sangean HDR-18 Manuale utente
Sangean
Sangean H205 Manuale utente
Sangean
Sangean DPR-69B Manuale utente
Sangean
Sangean U4 DBT+ Manuale utente
Sangean
Sangean HDR-1 Manuale utente
Sangean
Sangean PR-D4 Manuale utente
Sangean
Sangean SR-2 Manuale utente
