How to set the monitor as a Guard Monitor
How to set the slave monitor address
6. Monitor Parameter Setting
You can set the parameter setting on monitor
directly.
To open Installation setting page:
1. On the home screen, touch About
icon.Some informations about the monitor will be
shown.
2. In this information page,press Unlock
button and hold for approximately 3 seconds.
3. A digital keypad and some setting informations
will be shown.The setting informations are as right:
[0010] #: Remove all remote control
[0011] #: Add remote control
[8000] #: Set as master unit 0
[8001] #: Set as slaver unit 1
[8002] #: Set as slaver unit 2
[8003] #: Set as slaver unit 3
[8004] #: Set as guard unit
[8005] #: Set as Not guard unit
[8006] #: Panel on as slaver unit called
[8007] #: Panel off as slaver unit called
[8008] #: Date format:MM/DD/YYYY
[8009] #: Date format:DD/MM/YYYY
[8010] #: Set lock mode to 0
[8011] #: Set lock mode to 1
[8012] #: 12-Hour system
[8013] #: 24-Hour system
[8021]~[8029] #: Set the lock time of 1~9s
8
A Monitor can be assigned as Guard Unit Monitor; when the Guard Unit Monitor answers the
call, conversation with the guard person is started..
The code number of 8004 is used to set the monitor as a guard unit monitor and 8005 is used
to cancel this function.
Maximum 4 monitors can be connected in one apartment,one master monitor together with 3
slave monitors, so you should set the address correctly.(note:must have one monitor to be set as
master monitor)
The code of 8000 is used to set the master monitor.
The code of 8001 is used to set the rst slave monitor .
The code of 8002 is used to set the second slave monitor .
The code of 8003 is used to set the third slave monitor .
Note:touch * button to cancel the input,touch # to save the settings.
