Scolii SF004 Manuale utente
User Manual
Model: SF004
Size: 19.7”
Weight: 9.6lbs
CELLING FAN SF004
IMPORTANT
Always shut off power to the circuit before starting installation work.
In some countries electrical installation work may only be carried out
by a authorised electrical contractor. Contact your local electricity
authority for advice.
Safty rules
1. Before you begin installing the fan, shut power off the circuit breaker for the
fuse box.
2. Read all instructions and safety information before installing your new fan.
3. Do not bend the blades while installing, balancing the blades,or cleaning the
fan.
4. Do not insert foreign objects in between rotating fan blades.
5. Make sure the installation site you choose allows the fan blades to rotate
without any obstructions.
6. When installing, using and servicing the ceilling fan, please carefully check that the
screws are rmly locked. When the fan rotates, no objects should touch the blades to
avoid danger.
7. The power supply should not exceed the voltage range (wide voltage
AC110v-AC230v ±10% frequency 50/60Hz). If it is used for a long time above the
rated voltage range, it may cause the lamp to overheat and cause damage.
8. Please pay attention to check whether the cables and switches are in good condi-
tion before use, and make sure that the local voltage is consistent with the voltage of
this product.
9. We suggest that if you have insucient knowledge of electrical appliances, please
be sure to ask a professional to install it.
10. If you have any questions, please contact us in time via E-mail, we will reply you
within 24 hours.
1
Tool kit
Spare tool
2
Expansion screw Gasket
Connection terminal
Safety gloves
Extension line
Installation steps
1. Open the hanging plate of the lamp first, and use the hole position of the
hanging plate to measure and locate the position of the installation hanging
plate hole on the ceiling.
2. Drill holes at the positioning mark points according to the size of the expan-
sion screw, and then use a hammer to punch the expansion screw into the hole
and leave one centimeter outside, and unscrew the nut counterclockwise to lock
the board.
Tip: If your ceiling is not a cement board, but a wooden ceiling, please fix
the cross hanging board directly with self-tapping screws.
Hanging Bracket
Mounting point
(Expansion screw 2)
Mounting point
(Expansion screw 1)
3
3. Padded washers with nuts to lock the hanging plate on the ceiling. Make sure
that the hanging plate and the ceiling are connected and fixed firmly, and make
sure that the hanging plate and the expansion screw are connected enough for
the weight of the lamp body.
4. Use the 110v power supply and the main line of the lamp body to connect the
test power to see if the lamp is working properly. It is recommended to ask a
professional electrician to install it. If the lamp does not light, please check
whether the LED line connection plug is loose.
WARNING: Disconnect the electrical supply circuit before wiring to reduce the
risk of electric shock.
4
5. The hole of the lamp body corresponds to the ceiling screw. Check whether
the lamp chassis is completely sucked to the ceiling, and then tighten the
self-tapping screw. Make sure that the lamp body is connected to the ceiling
firmly.After installation, please turn on the power to see if all the lamps can be
turned on.
5
1. Download APP “ApplianceSmart”
2. Open “ApplianceSmart” to allow APP to connect to Bluetooth, click "+" below,
click fan lamp.
ApplianceSmart
6
3. Name your lamp, get the console, click on the console, follow the picture to
pair and remotely control your lamp.
For Any Problems Contact
Customer Service:
7
Indice
Altri manuali Scolii Fan
