● Use the the supplied power cord to connect the heat press to a 230V socket.
● The red toggle switch turns the press ON.
● After a short self-test, dashes appear in the display.
● Press the OK button.
● Now you can use the arrow keys to choose between °C and °F. Confirm your selection by
clicking "OK".
● Now configure the desired temperature using the arrow keys and also confirm with OK.
● Next, use the arrow keys to set the desired pressing duration in seconds and again confirm
with OK.
● You're now ready to perform your first transfers. The clock starts counting as soon as the
press is closed with the press lever.
● 3 seconds before the set time elapses, a warning signal sounds, at which time you should
open the press again by folding back the press lever.
● You can regulate the contact pressure by turning the black handwheel between the lever
and the heating sleeve to the left or right.
● No settings can be changed during the press operation.
● With each completed pressing process, the counter displays increases by one, as soon as
the specified time has elapsed.
● The counter can be reset by pressing and holding RESET for approx. 5 seconds.
Note: Please keep in mind that it takes some time for the press to cool off after it is
switched off.
Note: Do not leave the press standing around in its heated up state. If you're no longer
using the press, always turn it off.
Heating elements
Heating elements are generally wearing parts and not covered by the warranty
To extend the service life, the following points should be noted:
● When heating up, it is recommended to insert a mug to protect the element, the same
advice applies to cooling down.
● It is advisable to turn the mug press off, even if it will not be used for just a short
period of time.
● All heating elements must be checked for their function on the day of receipt.
Maintenance and cleaning
All maintenance work must be carried out with the press switched off and cooled off, no
exceptions! First, remove the plug from the wall socket. Only perform maintenance work after
consultation with our technical support team.
The press should be cleaned regularly using a soft cloth and a mild household cleaner to remove
