Release Version 1.2
1
Caution (If you do not keep any of the below guidelines, you may get injured or suffer
property loss.)
■Be sure to disconnect the power cord during installation or working.
■Proper ambient temperature and humidity are recommended.
- Avoid extremely high temperature (over 50C) or low (below -10C) and humid conditions.
■Do not place heavy items on the product or let foreign substances enter inside the device.
- It may cause failure.
■Install in well ventilated place, and avoid direct sunlight or heat appliance.
■Install at a flat and stable place. Do not use an upright or slanted position.
- It may not operate properly or might be dangerous due to the fall of the device.
■Strong shock or vibration may cause device failure. Be careful when using the device.
- Install in a place without severe vibration.
■Make sure to check the specification and usage of the device before performing the installation.
■During installation, secure space to emit heat between devices.
■Refer the device to the service center and get regular checkup to maintain the performance of the
system.
- We are not responsible for any damages caused by user’s carelessness.
■Place the power plug in a location that is easy to operate.
- If a failure of the product occurred, the power plug must be unplugged to power down completely.
■Disconnect the power plug with care during thunder and lightning.
■Do not use this device in close proximity to a device that produces strong wave such as radio set
(TRANCEIVER, Walkie-talkie, etc.) or a repeater. It may affect the image signal, or cause disorders such as
noise or crack on the screen.
■Refer to the user’s manual for problems or questions besides the above. Contact our service center if
you need assistance from a professional technician.
1. Introduction
1-1. Overview
SC-HOC01S is a compact type module that transmits 3G, HD-SDI, EX-SDI 1.0 video signal by optical
cable. This product consists of Transmitter and Receiver, and can transmit 3G, HD-SDI, EX-SDI 1.0
signal by optical cable with minimum loss. The transmitter converts 3G, HD-SDI, EX-SDI 1.0 signal
into optical data, and the receiver converts optical data received from optical cable into 3G, HD-SDI,
EX-SDI 1.0 signal.
1-2. Features
•Separated Transmitter and Receiver
•Can transmit 3G, HD-SDI, EX-SDI1.0 maximum 20Km by Single mode fiber
•BNC connector applied to SDI, LC connector applied in Optical
•DC12V/AC24V power supply available
