SentrySafe SFW123GTF Manuale utente
Fire-Safe – USB Connected
Owner’s Manual
REGISTRATION
registermysafe.com
Reasons to register: By registering your SentrySafe product you can easily retrieve forgotten
codes and combinations, which would otherwise require a notary letter and payment.
Contents include:
• Safe with 2 keys
• External USB-Y cable
(for computer connection)
• Magnetic clips to hold cable
• Owner's Manual/Warranty Card
Bolt-down hardware includes:
(2) Lag screws
(2) Washers
(2) Masonry anchors
2
Warnings
WARNING
Gun warning:This product is not intended for the secure storage of all materials. Items such as
firearms, other weapons, combustible materials, or medication should NOT be stored in this unit.
NOTICE
DO NOT store delicate items directly in your safe.
SentrySafe products, which offer fire protection, have a proprietary insulation that has a high
moisture content. In addition, the SentrySafe advanced safes close airtight to offer water resistance,
which may also cause moisture to accumulate inside your safe. The desiccant packet included in
your safe during shipment should be left in your safe. DO NOT DISCARD IT. It is intended to help
absorb moisture which may accumulate inside your safe. Please open your unit once every two
weeks to avoid moisture accumulation.
If you choose to store delicate items such as jewelry with working parts, watches, stamps, or
photos in your safe, we recommend putting them in an airtight container prior to placing them in
the safe for storage.
NOTE: Sentry Group will not be responsible for any damage or loss of items placed in the unit
due to moisture.
DO NOT store pearls in this safe unit. In the event of a fire, potential damage to delicate pearls
occurs at temperatures much lower than the 350°F interior performance measure which the UL
classification performance standard indicated guarantees. Therefore, DO NOT store pearls in your
SentrySafe product.
DO NOT store computer disks, audio-visual media or photo negatives.This product is not intended
to protect computer floppy or 2-1⁄4" diskettes, cartridges and tapes, audio or video cassettes, or
photo negatives. For fire-resistant storage of these materials, ask your retailer for the SentrySafe
Fire-Safe Media storage products.
YOUR SAFE IS ONLY PART OF YOUR TOTAL SECURITY PROTECTION.
SentrySafe recommends that you store your safe in closets, offices, basements, bedrooms and other
locations that are convenient for you but out of direct line of sight from prying eyes. The location of
the safe does not affect the safe’s ability to protect your
valuables inside.
3
English
Table Of Contents
Thank you for your purchase of a SentrySafe Product. SentrySafe is committed to securing,
organizing and protecting your most important documents, valuables and keepsakes.
Français ........................................................................................................................17
Español.........................................................................................................................33
English
Warnings ......................................................................................................................2
Table of Contents ..........................................................................................................3
Programmable Electronic Lock................................................................................... 4-7
Installing Computer Connector Cable.............................................................................8
Installing Storage Devices..............................................................................................9
Operating the Light .....................................................................................................10
Bolting Down Your Safe......................................................................................... 11-12
Troubleshooting Your Safe ...........................................................................................13
Replacement & Fire Specifications................................................................................14
Customer Service.........................................................................................................15
IMPORTANT
If you experience any problems or challenges with your safe, please contact us.
Many issues can be quickly resolved without the product being returned.
4
Programmable Electronic Lock
NOTE: Store code and keys in a secure location (other than in the safe).
NOTE: SentrySafe offers a secure online location for the entry and retrieval of your code.
Go to registermysafe.com and register your safe.
Ensure any shipping screws have been removed.
(Located on the inside of the door.)
ASlide out the battery drawer on the side of the keypad.
BInsert 4 AAA alkaline batteries (do not use rechargeable
batteries or other types of non-alkaline batteries).
CSlide battery drawer back into keypad.
NOTE: Do not use rechargeable batteries or any other type of non-alkaline battery. Do not mix
old and new batteries. Do not mix alkaline and other battery types.
Find your code on the back of this owner’s manual.
Remove key and store in a safe place.
WARNING
Test your code several times before putting valuables inside.
Insert key into the lock, turn to the “unlocked” position,
then remove the key.
This is a secondary locking feature, not an override key.
Without the key you will not be able to open your safe.
Preparing your safe for first-time use
Unlocking your safe
1
2
3
1
M100TEST
SN100TEST01*
12345
5
English
Programmable Electronic Lock
AEnter the 5-digit factory code on the back of the
owner’s manual.
BA green light will indicate the code is correct. You
will have 4 seconds to turn the handle to unlock your safe.
Rotate the handle downward to open the door.
This may take a limited amount of force if you have a
water-resistant safe.
NOTE: Make sure the handle is in the horizontal position when unlocking the safe.
NOTE: If you exert too much force on the handle, the handle will move without moving the bolts.
When this happens, you will hear a “click.“ DO NOT be alarmed.This feature is designed
to protect the bolts from being over-powered by force. If this occurs, simply exert force in
the opposite direction (lifting up) until the handles “clicks” back into place and repeat
steps 1-3 to open your safe.
AClose the door and pull the handle upward until the handle
is horizontal. For water-resistant units, additional pressure
to the front left side of the door may need to be applied
prior to rotating the handle.
BInsert key into the lock, turn to the “locked” position, then
remove the key. Store key in a safe place.
NOTE: The 5-digit factory code cannot be deleted. However, you may add and delete
additional codes.
NOTE: If your safe does not appear to be working properly, please check to make sure you are
using NEW alkaline batteries before contacting SentrySafe Customer Service.
Locking your safe
2
3
6
Programmable Electronic Lock
Three code options:
FACTORY CODE:
The safe will ALWAYS unlock using this 5-digit code (found on the back of the owner’s manual).
This code cannot be deleted.
USER CODE:
A 5-digit programmable code of your choosing that can be changed or deleted.
SECONDARY CODE:
A 5-digit programmable code of your choosing that can be changed or deleted. Can only
be programmed after a user code has been activated.
NOTE: The “C” key is a clear key. This can be used at any time to clear the system and return
to standby mode – unless you are in delay mode (3 consecutive invalid entries).
NOTE: Only one user code can be programmed at a time.
To ADD a user code:
1Press the “P” key.
2Enter the 5-digit factory code.
3The light will flash green and then you will have five
seconds to enter your own 5-digit personal user code.
To DELETE a user code:
1Press the “P” key.
2Enter the 5-digit factory code.
3Enter 0,0,0,0,0.
NOTE: The electronic lock will NOT indicate that it has deleted the user code – please test
the code to make sure it has been deleted.
Programming information
Programming the user code
7
English
Programmable Electronic Lock
NOTE: Only one secondary code can be programmed at a time.
To ADD a user code:
1Press the “P” key two times.
2Enter the 5-digit user code.
3The light will flash green and then you will have five
seconds to enter your own 5-digit personal secondary code.
To DELETE a secondary code:
1Press the “P” key two times.
2Enter the 5-digit user code.
3Enter 0,0,0,0,0.
NOTE: The electronic lock will NOT indicate that it has deleted the secondary code –
please test the code to make sure it has been deleted.
NOTE: Delay mode will occur if three consecutive invalid entries have been tried.This will cause
the system to shut down for two minutes. Do NOT remove the batteries to restart the
system – it will only increase the length of time for the system to shut down.
Programming the secondary code
8
Installing Computer Connector Cable
Take the high-performance USB cable (included) and connect
the USB type B connection into the USB port on the outside
of the safe.
Plug the red USB connector into your computer or laptop.
Some USB devices require additional power to run properly.
If you find that your device does not function properly, plug the
“aux power only” labeled connector into another USB port on
the computer.
To manage the cable position, attach magnetic clips to the side
of the safe to secure the cable to your desired position.
Connecting your computer and USB device
1
2
3
4
9
English
Installing Storage Devices
NOTE: Plug your USB powered storage device (Hard Drive/Flash Drive/etc.) into the internal USB
port on the inside of the safe door.
NOTE: For ease of storage, your external hard drive can be placed in the door pocket on the back
of the door.
Connecting a USB powered storage device
External Hard Drive
(not included)
Internal USB Port
Cable
(not included)
Internal USB Port
USB/Flash Drive
(not included)
WARNING
NEVER place or store magnetic clips (or anything magnetic) near electronic storage devices.
Loss of data and permanent damage to your electronic device(s) may occur.
10
Operating The Light
The safe you have purchased may include a light. This is a long-lasting LED light. Not all safes
include a light.
The batteries that operate the keypad are the same batteries that operate the light. If the light in
your unit does not turn on, please change your batteries. Refer to page 4 to change the batteries.
The light will turn on every time you enter your code and will remain on for 30 seconds.The light
duration has three options – off, 30 seconds, and 60 seconds*.
To turn the light off:
1Press the “0” button.
2Press the “P” button.
3Press the “3” button.
To turn the light on for 30 seconds:
1Press the “0” button.
2Press the “P” button.
3Press the “4” button.
To turn the light on for 60 seconds:
1Press the “0” button.
2Press the “P” button.
3Press the “5” button.
*If the light duration is 60 seconds, the battery life will decrease at a faster rate.
How to operate the light
Indice
Lingue:
Altri manuali SentrySafe Sicuro
SentrySafe
SentrySafe DH-109E Manuale utente
SentrySafe
SentrySafe Home Defense Center Manuale utente
SentrySafe
SentrySafe P005K Manuale utente
SentrySafe
SentrySafe F2300 Manuale utente
SentrySafe
SentrySafe X055 Manuale utente
SentrySafe
SentrySafe T8-331 Manuale utente
SentrySafe
SentrySafe FIRE SAFE Manuale utente
SentrySafe
SentrySafe Quick Access Pistol Manuale utente
SentrySafe
SentrySafe Fire-Safe Manuale utente
SentrySafe
SentrySafe Fire-Safe Manuale utente
SentrySafe
SentrySafe Master Lock Fire-Safe FPW082FS Manuale utente
SentrySafe
SentrySafe Fire-Safe Manuale utente
SentrySafe
SentrySafe Fire-Safe SFW123DSB Manuale utente
SentrySafe
SentrySafe H060ES Manuale utente
SentrySafe
SentrySafe PL048E Manuale utente
SentrySafe
SentrySafe P008E Manuale utente
SentrySafe
SentrySafe Fire-Safe Manuale utente
SentrySafe
SentrySafe SF123ES Manuale utente
SentrySafe
SentrySafe SentrySafe Manuale utente
SentrySafe
SentrySafe EF4738E Manuale utente
Manuali Sicuro popolari di altre marche
Honeywell
Honeywell 2077D - 1.21 Cubic Foot Anti-Theft Safe Manuale utente
Hornady
Hornady SnapSafe Trunk Safe II Manuale utente
SPORTS AFIELD
SPORTS AFIELD SA-HD5-BIO Manuale utente
Honeywell
Honeywell 5912 Manuale utente
Phoenix
Phoenix FS1280F Manuale utente
Phoenix
Phoenix SS0992K Scheda informativa del prodotto
