Siemens Cellion primax Manuale utente

Hearing

Systems

Cellion primax

Guide for Hearing Care Professionals

Content

Introduction 3

Before and after 󰄈tting 4

Assembling 4

Activating 4

Charging 5

Connecting 5

Noting the serial number 6

Disconnecting 6

Replacing the housing 7

Disassembling 7

Assembling 9

Important safety information 11

General warnings 11

Disposal 12

Further information 13

Storage periods 13

Symbols used in this document 13

Introduction

This guide is intended for Hearing Care Professionals. It

provides important information on hearing in󰘵ruments with

permanently built‑in power cells (lithium‑ion batteries).

CAUTION

It is important to read this guide, the user guide and

the safety manual thoroughly. Follow the safety

information to avoid damage or injury.

Before and after 󰄈tting

You have to prepare the hearing in󰘵ruments before you

can 󰘵art 󰘰tting.

Assembling

XA power cell is in󰘵alled in every hearing in󰘵rument on

delivery. There is no need to insert a battery.

XAttach the suitable receiver unit and

a suitable ear piece to the hearing

in󰘵ruments. The procedure is the

same as for any other of our RIC

hearing in󰘵ruments.

Activating

Before 󰘰r󰘵 use or 󰘰r󰘵 󰘰tting you have to activate the

hearing in󰘵ruments by putting them into the charger.

Wait until the 󰘰r󰘵 orange LED lights up.

Note:

● Hearing in󰘵ruments that are activated and not used

may discharge fa󰘵er than hearing in󰘵ruments that

have not been activated. Only activate the hearing

in󰘵ruments before 󰘰r󰘵 use or 󰘰r󰘵 󰘰tting.

Charging

The hearing in󰘵ruments are pre-charged on delivery.

They should have suﬃcient power for a 󰘰r󰘵 󰘰tting

session.

We recommend to fully charge the hearing in󰘵ruments

before 󰘰r󰘵 󰘰tting and handover to the client. A full

charging cycle takes approximately 4 hours.

Follow the operating conditions in both the hearing

in󰘵rument's and the charger's user guide.

Connecting

You can either 󰘰t the hearing in󰘵ruments wirelessly with

ConnexxLink or use the CS44 connection beneath the

push button:

XUse the included tool to lift

the push button.

Do not use sharp tools.

XPlug the CS44 cable as

shown in the picture.

Noting the serial number

You can 󰘰nd the hearing in󰘵rument's

serial number beneath the push

button, next to the CS44 connection.

Disconnecting

Depending on the charging 󰘵atus, the hearing

in󰘵ruments may switch o󰘯 after being disconnected

from the programming device. This safety feature avoids

deep‑discharge of the power cell.

To turn the hearing in󰘵ruments back on:

XPut them into the powered charger for a moment.

After removal from the charger the hearing in󰘵ruments

are automatically turned on.

XOr press the push button for several seconds.

Replacing the housing

NOTICE

XThis maintenance task mu󰘵 be performed by

the Hearing Care Professional.

Disassembling

XRemove the receiver unit and the axles.

XInsert the included tool into the front end of the hearing

in󰘵rument and detach the bottom housing.

You may feel some resi󰘵ance since the hearing

in󰘵rument sits 󰘰rmly in the bottom housing.

XUse the included tool to

remove the top housing.

Do not use sharp tools.

XTo remove the push button, 󰘰r󰘵 remove the axle then

lift the push button.

Assembling

XPlace the push button on the in󰘵rument and insert the

axle.

XIn󰘵all the top housing. Ensure that on both sides of

the hearing in󰘵rument the notches of the top housing

match the marked lines.

The top housing clicks noticeably in place.

XIn󰘵all the bottom housing from back 󰘰r󰘵, then push in

the front.

XAttach the axles. Note

the di󰘯erent lengths and

diameters of the axles.

XCheck the joint between top and bottom housing. It

mu󰘵 be even and very narrow.

If it is uneven or wide, the silicone wrapper may not sit

correctly. Disassemble the hearing in󰘵rument again

and improve the position of the silicone wrapper.

XAttach the receiver unit.

Indice

Altri manuali Siemens Apparecchio acustico

Siemens

Siemens IMPACT ITE Manuale utente

Siemens

Siemens BTE Manuale utente

Siemens

Siemens Life 500 BTE Manuale utente

Siemens

Siemens Aquaris 701 Manuale utente

Siemens

Siemens Insio binax Manuale utente

Siemens

Siemens IT Manuale utente

Siemens

Siemens Motion 701 BTE Manuale utente

Siemens

Siemens Motion 701 BTE Manuale utente

Siemens

Siemens Nitro BTE Manuale utente

Siemens

Siemens CIELO Manuale utente

Siemens

Siemens Pure Binax Manuale utente

Siemens

Siemens SX micon Manuale utente

Siemens

Siemens CIELO 2 ACTIVE Manuale utente

Siemens

Siemens Orion SP Manuale utente

Siemens

Siemens Vibe Manuale utente

Siemens

Siemens ePocket Manuale utente

Siemens

Siemens Motion SX Manuale utente

Siemens

Siemens Lotus BTE Life Manuale utente

Siemens

Siemens BTE series Manuale utente

Siemens

Siemens Octiv Custom+ Manuale utente

Siemens

Siemens INTUIS Manuale utente

Siemens

Siemens Nitro Manuale utente

Siemens

Siemens Impact R Manuale utente

Siemens

Siemens ePen Manuale utente

Manuali Apparecchio acustico popolari di altre marche

Sonic

Sonic Bliss miniBTE Manuale utente

Lexie

Lexie B1 Manuale elenco delle parti

Widex

Widex FM+DEX Manuale utente

Camplicomms

Camplicomms HC-200 Manuale utente

Widex

Widex SUPER 220 S2-VSD Manuale utente

Phonak

Phonak Q90 Manuale utente

Williams Sound

Williams Sound SoundPlus WIR 237 Guida

Oticon Medical

Oticon Medical Ponto SoundConnector Manuale utente

Starkey

Starkey Destiny Manuale utente

Audicus

Audicus The Icon Manuale utente

Advanced Bionics

Advanced Bionics Slim HP Standard Manuale utente

Widex

Widex DREAM440 THE DREAM SERIES Manuale utente

Phonak

Phonak myPilot Manuale utente

NIKEN

NIKEN NK-401 Manuale utente

ON Semiconductor

ON Semiconductor Ezairo 7111 Pre Suite Manuale utente

Sonetik

Sonetik GOHEAR Manuale utente

Widex

Widex FL-9 Manuale utente

Panasonic

Panasonic WH-216KZ Istruzioni per il montaggio