signia miniPocket Manuale utente
miniPocket
User Guide
4
Your remote control
miniPocket is a remote control for hearing inruments. It
works with our specic hearing inruments. Your Hearing
Care Professional will advise you on the compatible models.
CAUTION
Read this user guide thoroughly and completely and
follow the safety information in this document to avoid
damage or injury.
5
Components
➊Status LED
➋Volume buttons
➌Keyring
➍Key lock switch
➎Program change button
➏Battery door remover tool
➎
➏
➍
➋
➊
➌
6
Key lock
XTo prevent any accidental
operation while the remote
control is in a pocket or bag,
move the key lock switch to
the lock position (red color visible).
When the key lock is active, all buttons on the remote control
are disabled.
7
Pairing hearing inruments
Your hearing inruments need to be paired with your
remote control. After that, the pairing is saved in the hearing
inruments and remembered each time they are turned on.
XLock the remote control (red color visible).
XFir turn the hearing inruments o:
Open the battery compartments. If your hearing
inruments do not have a battery compartment, turn them
o as described in the hearing inruments' user guide.
XThen turn the hearing inruments on:
Close the battery compartments. If your hearing
8
inruments do not have a battery compartment, turn them
on as described in the hearing inruments' user guide.
The hearing inruments are now in pairing mode. You have
3 minutes to complete the pairing. Follow the eps below.
XInsert the hearing inruments into your ears.
XHold down the button on the remote control while
switching the key lock to the unlock position (green color
visible).
XRelease the button.
The remote control is now in setup mode, the LED will be
on.
9
While the remote control is in setup mode, do not press
or . This would change other settings.
XHold down the button until the pairing conrmation
sound is played in the hearing inruments. It takes
approximately 2 seconds for the sound to art playing.
XEnsure that the conrmation sound is heard in both
hearing inruments. When heard, the pairing will be
complete.
10
The remote control will remain in setup mode for an
additional 30 seconds. The conrmation sound can be
played again by pressing during these 30 seconds.
XTo exit the setup mode of the remote control, wait
30 seconds or move the key lock switch to the lock
position (red color visible).
When pairing is nished, the remote control is ready for use.
XEnsure that it is unlocked (green color visible).
If the hearing inruments could not be paired, refer to
"Troubleshooting" section.
Altri manuali per miniPocket
1
Indice
Altri manuali signia Telecomando
