Fig. A
Introduction
The Sima Xenon Universal Video
Light Model SL-9X can be mounted on
the accessory shoe of any camcorder
by sliding it into place and tightening
the mounting screw. If your camcorder
does not have a shoe mount, the Sima
Video Bracket, (Model SVB-1) can
provide a mounting platform. The SL-
9X also comes with a universal clip for
use with camera phones.
Batteries.
The SL-9X comes with two
rechargeable AAA NiMH batteries. The
batteries must be charged 8 to 10 hrs.
prior to use. Use the supplied AC
adapter/charger to charge the
batteries.
Installing the batteries
To install the batteries – slide open
the battery compartment located on
top of the unit. Insert the two AAA size
batteries according to the +/- markings
on the unit. Close top.
To charge the batteries:
1. Insert the jack on the power cord into the
power input jack on the side of the SL-9
(Fig. A). Red
LED indicator
light, located
below the
power jack, will
turn on.
2. Plug AC
transformer into
standard 120
VAC wall outlet.
3. Batteries must charge 8 to 10 hours before
fully charged. Note: indicator light will not
turn off when charging is complete.
4. Fully charged batteries will provide approx.
20 to 25 minutes continuous run time.
Note: Light does not work with AC adapter
plugged in unit’s power jack.
Warning! Do not overcharge. Unplug after 8-
10 hours charging.
Special Notes
The SL-9X video light can also be operated
with two standard AAA alkaline batteries.
Running time will be less than when using the
rechargeable NiMH batteries included with
your unit. If using non-rechargeable batteries,
do not use AC charger. Supplying current to
non-rechargeable batteries can cause them to
leak or explode and may damage the unit.
Warning! Never charge alkaline batteries.
Damage to AC charger or light can occur.
Operation:
Turn light on by sliding
the on/off switch up to
the ON position as shown
in Fig. B
Specifications
Lamp: 3W Xenon lamp
Power: 2 AAA NiMH batteries
Run Time: 20 to 25 min.
with 600 mA hour NiMh batteries.
Charger: 120V AC input; 3V DC
output
Weight: 2.2 oz. (with batteries).
Size: 2.75” x 1.5”
Replacing the lamp:
Contact Sima at 800-345-7462 for
instructions on replacing the lamp.
Note: Touching bulb with bare fingers
will damage bulb and cause bulb
failure.
© 2005 Sima Products Corporation
P/N 21717 Made in China
Fi
