Once the battery is installed, it is
important to fully charge the unit before
using it the first time.
It takes approximately 4 hours to be fully
charged. Connect the supplied USB Type C
plug to CS108 and connect the Type A plug
into the included USB charger. The RED
charging LED will light. Charge the unit until
the red light goes out.
Now it’s time to configure your iPhone
1. First, scan this QR code using your
iPhone to download the Wave app:
Or you can search “SimplyRFiD” in
the app store to locate the Wave
Enterprise app.
2. Once the Wave app is installed, be
sure to enable Bluetooth by opening
the Settings app and switching
Bluetooth to On.
Note: Do not use the Bluetooth pairing
screen to connect the CS108 to your
iPhone, that step comes later.
3. To power on CS108, press and hold
the power button for 3 seconds and
then release, after that the GREEN
LED will light up continuously.
Finally, configure the Wave app
Tap on the Wave icon on your iPhone to
launch the app. The first time the app runs,
you will be prompted to connect to your
scanner. If the scanner is powered on it will
show up in the list of devices. Identify your
handheld by comparing the serial number of
your device to the number displayed on the
screen.
On the next screen you’ll be prompted to
check your email for a QR code. You’ll need
to use the CS108 handheld to scan this
code. Once the code is scanned the
handheld will be ready to use!
Copyright 2022 SimplyRFiD
www.simplyrfid.com Quickstart Page 2 of 2
