8
ZULU Series
GPRS/UMTS/LTE ARM Cortex M4 Modem Range
with USB Serial Port Interface
ZULU Interface
Standard Hardware Interfaces
As standard, the ZULU series modem comes with the following interfaces:
»1 x RS232 serial port interface for direct serial connection to microprocessor / module
»1 x USB serial port interface
»1 x RJ12 power connection with 2 power lines and 4 input interfaces (5 - 42V)
»1 x SMA female GSM antenna connector
»1 x SIM card reader (push-push)
»1 x internal LED charge status indicator (Green)
»9 x internal LED GPIO status indicators (Orange)
»3 x external LED status indicators (Red, Blue, Green)
»128Mbit internal SPI ash
»3-axis high sensitivity accelerometer to detect motion, rotation and freefall
»High power relay with independent microprocessor control (600mA 60V DC normally open)
»Intelligent Li-Ion battery charge management controller with battery protection
»Standard 36-Way Connector Interfaces
○1 x wired (36-way) power supply
○1 x wired (36-way) Vcc_IO general purpose output voltage control line
○1 x wired (36-way) hardware boot loader control signal
○1 x wired (36-way) RS232 serial command port
○1 x wired (36-way) RS232 debug port for direct serial connection to module
○1 x wired (36-way) Ignition interface
○1 x wired (36-way) CAN interface
○1 x wired (36-way) I2C interface
○1 x wired (36-way) 1-wire interface
○1 x wired (36-way) 3.3V power supply output interface
○1 x wired (36-way) relay interface
○2 x wired (36-way) 12-bit DAC interfaces (0-42V)
○2 x wired (36-way) 12-bit ADC interfaces (42V tolerant)
○5 x wired (36-way) general purpose input interfaces
○4 x wired (36-way) general purpose output interfaces
