PROGRAMMING FOR SCENE OPERATION
Scene can provide specic brightness of multiple lights with a press of a button. This
can create specic atmosphere. The remote provides 9 different scene settings,
brightness of light control from 0% [off] to 100% [brightest], (i.e. common scenes are
morning scene, evening scene, movie scene and etc.)
To setup a scene:
1. Press the [PROG] button 4 times to
enter the Scene Programming mode.
2. Press [1 – 9] to select the scene number
you would like to program.
3. Use the Up [▲] and Down [▼] button to increase
or decrease the brightness from 0% to 100%.
For instant, select 60% brightness for your setting.
Once you selected the setting, Press [ ] to conrm.
4. Once the remote is programmed, the receiver module will quit from
programming mode and the programmed remote is now ready to be used.
Follow the same instructions above to program the zone number into various re-
ceiver modules to form a zone with multiple lights (i.e. Zone 1 signal programmed
to both Family Room Ceiling Light receiver module and Family Room Floor Light
receiver module).
Zone Operation:
To turn on a zone:
1. Press the Function button “ ” until you see
“on zone”.
2. Press [1 – 9] to select the desired zone. (i.e.
Enter [1] for Zone 1 and all the lights in Zone 1
will be on.)
To turn off a zone:
1. Press the Function button “ ” until you see
“off zone”.
2. Press [1 – 9] to turn off the zone. i.e. Enter [1]
to turn off all the lights in Zone.
