Skypatrol SP4600 Manuale utente
SP4600 Kit
SP4600 Relay (Optional)
SP4600 Installation Steps
When mounting the SP4600, locate an area out of view, such as under the dash or inside a front fairing. Be sure to
place the device where it will not be obstructed by metal. Make sure that the label is facing the ground to ensure a
better GPS fix. Power to the SP4600 can be taken directly from the battery, or from a wire that read the same voltage as the
battery. A voltage on a wire that is slightly less than the battery voltage indicates that the wire is not directly from the battery
and should not be used.
1. Connect the Red power wire “PIN 16”from the device to a constant 12V power source.
2. Connect the Black ground wire “PIN 15”from the device to chassis ground, or directly from the battery terminal.
3. For the starter interrupt installation follow the steps shown in figure 1.
4. To use the starter interrupt feature, connect the White wire from the device to ignition source.
LED Status
Rev 1.0
.
Figure 1
Indice
Altri manuali Skypatrol GPS
Skypatrol
Skypatrol ST7200 Manuale utente
Skypatrol
Skypatrol TT8850 Manuale di istruzioni
Skypatrol
Skypatrol TT8540 Manuale utente
Skypatrol
Skypatrol Evolution Manuale utente
Skypatrol
Skypatrol TT8950 Manuale utente
Skypatrol
Skypatrol SP1824 Manuale utente
Skypatrol
Skypatrol SP4700 Manuale utente
Skypatrol
Skypatrol SP2600 Manuale utente
Skypatrol
Skypatrol SP9600 Manuale utente
Skypatrol
Skypatrol SP8600 Manuale utente
