Skypatrol ST7200 Manuale utente
- 1 -
ST7200 Users Guide:
ST7200
ST7200
User Guide
Revision 1.0
06/03/2014
Confidential and Proprietary Information – © 2012 Skypatrol, LLC.
Do not duplicate without express permission from Skypatrol, LLC
- 2 -
Terms of Use
TERMS OF USE OF NEW MATERIALS - PLEASE READ CAREFULLY
From time to time, SkyPatrol, in its sole discretion, may make available for download on its website
(www.SkyPatrol.com), or may transmit via mail or email, updates or upgrades to, or new releases of, the
firmware, software or documentation for its products (collectively, 'New Materials'). Use of such New
Materials is subject to the terms and conditions set forth below, and may be subject to additional terms
and conditions as set forth in SkyPatrol's Technical Support Policy (posted on its website) and/or any
written agreement between the user and SkyPatrol.
All New Materials are provided AS IS. SkyPatrol makes no warranty or representation with respect to the
merchantability, suitability, functionality, accuracy or completeness of any such New Materials. The user
of such New Materials assumes all risk (known or unknown) of such use. SkyPatrol reserves all rights in
such New Materials. The user shall have only a revocable and limited license to use such New Materials
in connection with the products for which they are intended. Distribution or modification of any New
Materials without SkyPatrol's consent is strictly prohibited.
IN NO EVENT WILL SKYPATROL BE RESPONSIBLE FOR ANY INCIDENTAL, INDIRECT, CONSEQUENTIAL OR
SPECIAL DAMAGES AS A RESULT OF THE USE OF ANY NEW MATERIALS. SKYPATROL'S MAXIMUM
LIABILITY FOR ANY CLAIM BASED ON THE NEW MATERIALS SHALL NOT EXCEED FIFTY U.S. DOLLARS
($50).
Copyright
© 2011 SkyPatrol, LLC. All rights reserved. Complying with all applicable copyright laws is the
responsibility of the user. Without limiting the rights under copyright, no part of this document may be
reproduced, stored in or introduced into a retrieval system, or transmitted in any form or by any means
(electronic, mechanical, photocopying, recording or otherwise), or for any purpose, without the express
written permission of SkyPatrol, LLC.
SkyPatrol and the SkyPatrol logo are either registered trademarks or trademarks of SkyPatrol, LLC. in the
United States.
3055NW 84th Ave
Doral, Florida 33122
Email: [email protected]
www.SkyPatrol.com
- 3 -
Revision History
Version Primary Author(s) Description of Version Date Completed
1.0 Humberto Hernandez Initial revision. 06/03/2014
- 4 -
Table of Contents
Objective ................................................................................................................ 5
Equipment Needed ...................................................................................................... 5
Configuration Recommendation ................................................................................. 6
Procedures .............................................................................................................. 7
SkyPatrol ST7200 Panel Descriptions .......................................................................... 7
Battery Specifications .................................................................................................. 8
Installation ................................................................................................................... 8
Installing Cables ........................................................................................................... 8
Main Connector (7) Pin ................................................................................................ 9
SkyPatrol ST7200 Cables and Connections ................................................................ 10
Inserting the SIM ........................................................................................................ 10
Insert the SIM per the Following Procedure: ......................................................... 10
Install the power cable as described in the following procedure: ......................... 11
Connecting the Power Source ................................................................................... 11
LED Operation ............................................................................................................ 12
Configure the Computer and Verify Correct Communications ................................. 12
Configure the SkyPatrol ST7200 to Communicate with the Server ........................... 18
Serial Loop-back Testing ............................................................................................ 18
Verify GPS Operation ................................................................................................. 22
Additional Software Features ................................................................................. 23
Index .................................................................................................................... 24
ST7200 User Guide
- 5 -
Objective
The objective of this document is to provide the user with basic information on how to configure the
SkyPatrol ST7200 and verify communication with the server.
Equipment Needed
In this example the requirements are:
SkyPatrol ST7200
Power supply, 12 VDC, 2A
Computer with one available USB port
GSM/GPRS SIM with GPRS data enabled.
APN (Access Point Name).
Username and Password, if GPRS is operating on a non-transparent network.
Note: If you don’t know the name of the APN you need to use, please contact your cellular
network carrier for that information.
ST7200 User Guide
- 6 -
Configuration Recommendation
The SkyPatrol Mobile Tracker family of products is designed with features to support a robust
connection with the network. However, there can be conditions when the connection to the network or
the ability to transfer data across the network is beyond the control of the device alone.
For installations that require maximum connectivity, we strongly recommend implementing the
fallowing choices.
i. Insure that the ignition wire is connected to a switched ignition source.
ii. Use type 4 (ACKED) UDPC is the same as UDP (w/o Ack) except allows server commands
sent via UDP (SMS cmd still supported)..
ST7200 User Guide
- 7 -
Procedures
SkyPatrol ST7200 Panel Descriptions
1. Front View
Figure 1 – SkyPatrol ST7200 Front View
2. Top View
Figure 2 – SkyPatrol ST7200 Top View
ST7200 User Guide
- 8 -
Battery Specifications
The SkyPatrol ST7200 uses power either from the vehicle battery, or from an optional internal battery.
The battery specifications are as follows:
Nominal voltage: 3.7 VDC
Nominal Capacity: 650 mAH
Max charge voltage: 4.2 VDC
The features of the battery include the following:
No memory effect
Reliable service life
Long-lasting performance
No leakage and no explosion
Installation
When mounting the ST7200, locate an area out of view, such as under the dash or inside a front
fairing. Be sure to place the device where it will not be obstructed by metal. Make sure that the label
is facing the ground to ensure a better GPS fix. Power to the ST7200 can be taken directly from the
battery, or from a wire that read the same voltage as the battery. A voltage on a wire that is slightly less
than the battery voltage indicates that the wire is not directly from the battery and should not be used.
Installing Cables
During installation, the following precautions will help ensure proper operation of the SkyPatrol ST7200
!
The SkyPatrol ST7200 is NOT a waterproof or sealed device.
Care must be taken to ensure the device is kept away from
water or any other liquids.
ST7200 User Guide
- 9 -
Remove power from the SkyPatrol ST7200.
Do not create loops, sharp bends or crimps in the cables
All cables should be attached to the vehicle and equipment in such a way to reduce stress or
wear caused by vibration generated by moving vehicles.
Use proper terminations on all power cables
Main Connector (7) Pin
Table 1 describes the pin functionality for the 7 pin I/O connector. Pins that are not planned for usage
can be left open without anything connected to them.
Pin # Pin Name I/O
Functional Description
Logic State Port Characteristics
1 IN1 I Ignition Sense High: Ignition ON
Low: Ignition OFF
8 to 24 V
< 5 V
Note: Internally pulled low
2 IN2 I Input Port 2 High:
Low :
2.4 to 24 V
< 0.2 V
3 GND Ground
4 OUT O Output Port Open:
Short:
> 1MOhm to ground
< 1Ohm to ground,
250 mA max sink current
5 UART-RX I Serial Receive Port 3.3V Logic Interface Com Port
Settings:
Baud rate: 115200 bps; Flow
control: None; 8N1
6 UART-TX O Serial transmit Port 3.3V Logic Interface Com Port
Settings:
Baud rate: 115200 bps; Flow
control: None; 8N1
7 VBATT I Main Battery Voltage 6-24 V
Table 1 - 7 pin I/O Connector Interface
ST7200 User Guide
- 10 -
SkyPatrol ST7200 Cables and Connections
SkyPatrol ST7200 programming cable provides mini USB serial interface and power to the unit. The
cable would be used for loading new software onto the SkyPatrol ST7200 and configuration of the
device.
Figure 4 - USB Connection
Inserting the SIM
Insert the SIM per the Following Procedure:
Note: The SIM card is not provided with the SkyPatrol ST7200 device. The SIM must be obtained
from the GSM/GPRS service provider and must be provisioned by the operator for data and/or
voice. Always take care to protect the SIM.
The SIM Lock Switch is used to ensure the SIM remains in position.
1. Insert the SIM card into the SIM slot with the notch up and facing toward the left
side of the SkyPatrol ST7200.
(INSERT PICTURES OF THE SIM HOLDER)
Altri manuali per ST7200
1
Indice
Altri manuali Skypatrol GPS
Skypatrol
Skypatrol SP9700 Manuale utente
Skypatrol
Skypatrol SP8600 Manuale utente
Skypatrol
Skypatrol SP1824 Manuale utente
Skypatrol
Skypatrol Evolution Manuale utente
Skypatrol
Skypatrol TT8540 Manuale utente
Skypatrol
Skypatrol TT8950 Manuale utente
Skypatrol
Skypatrol SP4600 Manuale utente
Skypatrol
Skypatrol SP2600 Manuale utente
Skypatrol
Skypatrol SP4700 Manuale utente
Skypatrol
Skypatrol TT8750 Istruzioni per il montaggio
