Smart power OF400USB-TBF Manuale utente
P.N.16001400 Rev.3/17
USER'S GUIDE
Uninterruptible
Power Supply
400VA / 600VA
Models:
Office-TBF UPS Series
OFFICE Series
OF400-TBF, OF400USB-TBF,
OF600-TBF, OF600USB-TBF
1
Important Safety Instructions
Save These Instructions
CAUTION!!!
WARNING!!!
Please read the following information carefully and save this manual
for future reference. Ignoring these safety warnings may endanger
your life or health, as well as the function of the equipment and safety
of your data.
To reduce the risk of fire, replace only with same type of fuse.
Refer servicing to qualified service personnel only.
To reduce the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants.
Risk of Electric Shock. Battery circuit is not isolated from AC input,
hazardous voltage may exist between battery terminals and ground.
Risk of Electric Shock. Do not remove cover. No user serviceable
parts inside. Refer servicing to qualified service personnel.
Risk of Electric Shock. This unit receives power from more than
one source. Disconnection of AC sources and the DC source is
required to de-energize this unit before servicing.
Risk of Electric Shock. Hazardous live parts inside this unit are
energized from the battery supply even when the input AC power
is disconnected.
2
Important Safety Instructions
Save These Instructions
NOTICE!!!
The output of the Office 400 is not sinusoidal. It has a total harmonic
distortion of 61% and a maximum single harmonic distortion of 46.6%.
The output of the Office 600 is not sinusoidal. It has a total harmonic
distortion of 46% and a maximum single harmonic distortion of 33%.
TYPICAL BATTERY RUNTIME IN MINUTES
Desktop PC with
15" monitor
Desktop
15" monitor
PC with
Desktop
17" monitor
PC with Desktop
17" monitor
PC with
OF400 OF600
3
System Description
Top View:
1. Power On/Off Switch
2. Green LED: On AC Line Mode
3. Amber LED: Battery Mode
4. Red LED: Fault
5. Power conditioning (TBF™) only receptacle
6. Battery power plus power conditioning
(TBF™) receptacles
Rear
7. AC input
8. Network/Phne Line Protection
9. USB Port
10. Circuit breaker
View (USB Model):
Rear View:
7. AC input
8. Telephone Line Protection
9. DB9 (RS-232) Interface
10. Circuit breaker
SmartPower
SYSTEMS
••••••••••••••••
RS232
REAR VIEW
OF400USB-OF600USB
REAR VIEW
OF400-OF600
T10A 125VAC
T10A 125VAC
10
10
Troubleshooting
If the UPS failed to operate properly, please review the following:
Green LED is "ON",
but audible alarm is
heard intermittently.
UPS is functioning
but audible alarm is
heard continuously
UPS shuts down
after a few seconds
and circuit breaker
protected.
1. UPS is not connected
properly to the main power.
2. Line breaker protected
UPS is overloaded.
UPS output is short-
circuited, possibly due to
defective load.
1. Connect the UPS
according to the installa-
tion guide.
2. Press the breaker.
Verify that the load
matches the UPS
capacity specified in
the spec.
Disconnect your
load from the UPS
and then press the
breaker.
Symptom Possible Cause Solution
4
Installation and Operation
Installing the Office Series UPS is as easy as following the steps
shown. Be aware that the Power Switch must be kept in the "ON"
position and all equipment must be plugged into the "Battery Power
Supplied" receptacles. Otherwise the UPS will be disabled and your
equipment will not be protected during a power failure.
Inspection
Unpack the UPS carefully and note the packing method. Retain the box
and packing material for possible future shipment. Visually inspect the
UPS for freight damage. Report damage to the carrier and your dealer.
Placement
Install the UPS unit in any protected environment that provides adequate
airflow around the unit, and is free from excessive dust, corrosive fumes
and conductive contaminants. DO NOT operate your UPS in an
environment where the ambient temperature or humidity is high.
1
2
5
SmartPower
SYSTEMS
••••••••••••••••
Charging
This unit is shipped from the factory with its internal battery fully charged,
however, some charge may be lost during shipping and the battery
should be recharged prior to use. Plug the unit into an appropriate power
supply and allow the UPS to charge fully by leaving it plugged in for at
least 8-10 hours with no load (no electrical devices such as computers,
monitors, etc.) connected.
Computer Connection
Connect one computer-related device into one of the battery supplied
receptacles on the top of UPS. Office Series UPSs provide six
receptacles, three battery supplied receptacles and three surge
protected only receptacles.
3
4
6
PC
REAR VIEW
OF400USB-OF600USB
T10A 125VAC
UTBF
UTBF
7
Office TBF™ Connection
6
UTBF
UTBF
~
~
REAR VIEW
OF400TBF-OF600TBF
1.Turn off and un-plug all devices.
2.Plug UPS unit into grounded wall outlet.
3.Place the UTBF where monitoring lights can be observed.
UTBF INDICATORS:
Green light only - It confirms properly connected equipment is fully protected.
Green and Red light - Reverse polarity or loss of ground at the wall outlet.
Call your electrician to correct the problem.
Green light off - Power failure or UTBF fault. Contact customer service.
T10A 125VAC
USB Connection with Network Protection (OF-USB models only)
connect the USB cable as shown in the diagram below. To protect the
Network connection, plug incoming Network line into the "in" socket at
the rear panel of the Office-USB Series UPS. Use provided CAT5 Network
cable and plug one end to the "Out" socket at the rear panel of the UPS.
Plug the other end of the Network socket of the PC as shown below.
To allow for unattended system shutdown for your operating system,
5
Incoming
Network Line
IN OUT
PC
REAR VIEW
OF400USB-OF600USB
USB
USB
T10A 125VAC
Turn On/Off
Press power switch to turn on the Office Series UPS. Press power switch
again to turn off the UPS.
Installation instructions for wall-mountable models
without the use of rulers, making the installation a snap.
The "EIP" (Easy Installation Plate) lets you mount your Office UPS
8
7
8
SmartPower
SYSTEMS
••••••••••••••••
RETAIL
APPLICATION
Bracket Installation
To mount your Office UPS to a wall or
other surface, first, install the provided
"EIP" on the wall (see Figure 1) by using
the provided screws that will hold the "EIP"
to the wall. Make sure to place the unit
where monitoring lights can be observed.
Figure 1
(Easy Installation plate)
"EIP"
Vertical
Option
BRACKET
Horizontal Option
Securing unit to wall
Use the two mounting
slots in the back of the
Office UPS by sliding
them into the bracket
pins installed on the
wall and lock into place.
Battery Replacement
Follow the charts below to replace the batteries.
After removing the battery cover, gently extract batteries from the case.
Disconnect the two wires connecting it to the Office Series UPS and
replace it with the same type of batteries. Dispose of the old batteries
properly at an appropriate recycling facility.
10
11
13
12
Chart 1
Chart 2
Chart 3
9
Bottom View
Bottom View
Bottom View
Remove the screws located on the bottom of the UPS to open the
battery cover.
DC Start Function
DC Start Function enables UPS to be started up when AC utility power is
not available and battery is fully charged. Just simply press the power
switch to turn on the UPS.
Green Power Function
All Office Series UPS are equipped with Green Power Function. If no load
connects to the UPS, it will automatically shut down in 5 minutes for
energy saving during power failure. The UPS will restart while AC
recovery.
9
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali Smart power UPS
Smart power
Smart power 2L Manuale utente
Smart power
Smart power SBP1000TBF Manuale utente
Smart power
Smart power DSS1500RT-TBF Manuale utente
Smart power
Smart power SPV0400U-TBF Manuale utente
Smart power
Smart power SBP0400TBF-6U Manuale utente
Smart power
Smart power Venus Series Manuale utente
Smart power
Smart power SBP-TBF Series Manuale utente
Smart power
Smart power Smart Sine Pro Series Manuale utente
Smart power
Smart power SBP Plus Series Manuale utente
Smart power
Smart power OFFICE Plus Series Manuale utente
Manuali UPS popolari di altre marche
Pylontech
Pylontech Victron & Pylontech US5000 Manuale utente
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Manuale utente
Mecer
Mecer ME-1000-WTU Manuale utente
Mustek
Mustek PowerMust 530(B) Plus Manuale di installazione e funzionamento
Emerson
Emerson Liebert NXL series Manuale utente
MAKELSAN
MAKELSAN BOXER SERIES Manuale utente
