Smart power Venus Series Manuale utente

What's in the box: • Battery

• Instructions

Turn the UPS upside down

Unscrew all 4 screws located at the base of the UPS

with a screwdriver. Make sure you loosen up all screws

before going to step 3.

Photo 1

030/17 70526

INSTRUCTIONS FOR

BATTERY REPLACEMENT

IMPORTANT: Before replacing the battery, turn off the

UPS and unplug the UPS cord from the wall outlet.

PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY

TO AVOID INJURY OR DAMAGE TO THE UNIT

Venus UPS - Models 600VA & 800VA

Turn the UPS down side up and shake all 4 screws

off.

Pull top cover up about 1.5 inches from the back.

Then pull front panel up slightly and separate from

chassis as shown below.

Photo 2

Turn top cover on the side as shown in photo 3.

Photo 3

INSTRUCTIONS FOR BATTERY REPLACEMENT

Unplug the red wire first by pulling it from the

red terminal, then the black one.

Photo 4

Unscrew the bracket covering the battery with

a screwdriver as shown on photo 5.

WARNING: Do not make any contact with the

battery terminals with the screwdriver or any

other metal materials like watches, rings, etc.

Electric shock could occur and it could cause

harm to you and the battery.

Photo 5

BATTERY

BRACKET

BATTERY

BRACKET

INSTRUCTIONS FOR BATTERY REPLACEMENT

Photo 6

Remove the battery by pulling up. It should slide out

easily.

Screw cover bracket back on as shown on Photo 7.

There is only one screw for each side. Make sure

the bracket sits on top of the holes as shown on

photo 7b.

Photo 7

Photo 7b

Place new battery in by making sure the terminals

are facing as shown on photo 6. The battery should

slide in and fit comfortably in its place.

SCREWS FOR

BRACKET

SCREWS FOR

BRACKET

HOLES FOR

SCREWS

HOLES FOR

SCREWS

INSTRUCTIONS FOR BATTERY REPLACEMENT

Photo 9

Put top cover back as shown on photo 9. Make sure

there are no wires coming out when putting top cover

back on.

Connect the black wire first to the black terminal

then, the red wire to the red terminal.

Photo 8

INSTRUCTIONS FOR BATTERY REPLACEMENT

Connect the top of the front panel into the holes

on the top cover and push towards chassis.

Photo 10b

Photo 10

14 Push down the top cover together with the chassis

and snap the front panel in place completely, as

shown below.

Photo 11

HOLESHOLES

INSTRUCTIONS FOR BATTERY REPLACEMENT

Drop screws inside hole making sure the head of

the screw is up. Screw all 4 screws back in until

tight.

Hold all panels together tightly and turn UPS

upside down.

Photo 12

Photo 13b

Photo 13

INSTRUCTIONS FOR BATTERY REPLACEMENT

Test the UPS by pressing the button and making sure

the "Protected" green LED comes on (LED model) or

the LCD diagnostic display comes on (LCD model).

Turn UPS off by pressing the button again.

Finally, plug all your equipment back to the UPS and

turn UPS on by pressing the button.

Photo 14 - LED Model Photo 14b - LCD Model

19 Recycle the used battery:

• Never dispose the batteries in a fire. It may

explode.

• Do not open or mutilate the batteries. Released

electrolyte is harmful to the skins and eyes. It

may be toxic. A battery can present a risk of

electrical shock and high short circuit current.

To recycle properly the used battery, please do not

discard the battery into the trash bin. Please follow

your local laws and regulations; you may contact

your local recycling waste center for further

information to dispose of it properly.

1760 Stebbins Drive - Houston, Texas 77043

Tel:800-882-8285 - Fax:(713)984-0841

E-mail: [email protected]

www.smartpowersystems.com

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Smart power UPS

Smart power

Smart power Smart Sine Pro Series Manuale utente

Smart power

Smart power DSS1500RT-TBF Manuale utente

Smart power

Smart power SPV0400U-TBF Manuale utente

Smart power

Smart power SBP1000TBF Manuale utente

Smart power

Smart power SBP-TBF Series Manuale utente

Smart power

Smart power OFFICE Plus Series Manuale utente

Smart power

Smart power SBP0400TBF-6U Manuale utente

Smart power

Smart power 2L Manuale utente

Smart power

Smart power SBP Plus Series Manuale utente

Smart power

Smart power OF400USB-TBF Manuale utente

Manuali UPS popolari di altre marche

Pylontech

Pylontech Victron & Pylontech US5000 Manuale utente

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Manuale utente

Mecer

Mecer ME-1000-WTU Manuale utente

Mustek

Mustek PowerMust 530(B) Plus Manuale di installazione e funzionamento

Emerson

Emerson Liebert NXL series Manuale utente

MAKELSAN

MAKELSAN BOXER SERIES Manuale utente

Block

Block PC-0524-400-0 Manuale utente

CyberPower

CyberPower CP585LCD Manuale utente

Eaton

Eaton 3S Istruzioni per il montaggio

CyberPower

CyberPower Office Tower Series UPS 1000 Manuale utente

CyberPower

CyberPower BM100 Manuale utente

Best Power

Best Power 610 Manuale utente

Best Power

Best Power Unity/I UT3K Manuale utente

Mustek

Mustek PowerMust 400 Offline Manuale utente

Xantrex

Xantrex Trace 512 UR-UPS Manuale utente

Forza

Forza SL-1501UL Manuale utente

LEGRAND

LEGRAND keor 310081 Manuale utente

ABB

ABB Conceptpower DPA 500 Manuale utente